EMOS M3620 Handleiding
EMOS
Multimeter
M3620
Lees hieronder de 📖 handleiding in het Nederlandse voor EMOS M3620 (38 pagina's) in de categorie Multimeter. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/38
2202017000_31-M3620_00_01 105 × 148 mm
www.emos.eu
M3620 | MD-310
GB Digital Multimeter
CZ Digitální multimetr
SK Digitálny multimeter
PL Multimetr cyfrowy
HU Digitális multiméter
SI Digitalni multimeter
RS|HR|BA|ME Digitalni multimetar
DE Digitales Multimeter
UA Цифровий мультиметр
RO Multimetru digital
LT Skaitmeninis multimetras
LV Digitālais multimetrs
EE Digitaalne multimeeter
BG Цифров мултиметър
5
Direct current (DC)
Range Resolution Accuracy
20 mA 10 µA ± (1 % + 5)
200 mA 100 µA ± (1.2 % + 5)
10 A 10 mA ± (2 % + 5)
Protection against overload:
μA and mA range: fuse 250 mA/300 V, type F, Ø 5 × 20 mm.
10 A range: fuse 10 A/300 V, type F, Ø 5 × 20 mm.
Maximum input current: "VΩmA" socket max. 200 mA; "10 A" socket max 10 A
(when measuring currents larger than 2 A; the measurement duration must be max. 10 seconds and
measurement may be repeated again only after 15 minutes)
Resistance
Range Resolution Accuracy
200 Ω 0.1 Ω ± (1.2 % + 5)
2 kΩ 1 Ω
± (1.0 % + 5)20 kΩ 10 Ω
200 kΩ 100 Ω
2 MΩ 1 kΩ ± (1.2 % + 5)
Voltage of an open circuit: 3 V
Battery Test
Range Resolution Electrical load
1.5 V 0.01 V approximately 20 mA
9 V 0.01 V approximately 5 mA
12 V 0.01 V approximately 4 mA
Continuity Test
Symbol Description Note
The built-in buzzer will ring constantly if
resistance is lower than 20 Ω.
The buzzer will be quiet if resistance is
higher than 100 Ω.
If resistance is between 20 Ω and 100 Ω;
the buzzer may or may not ring.
Voltage of an open circuit: approximately
3 V
Diode Test
Symbol Description Note
The approximate voltage of the diode
in the direction of the current ow will
appear on the screen
Voltage of an open circuit: approximately 3 V
Load current: approximately 1 mA
7
Resistance Measurement Function
Connect the plug of the black (negative) tipped measuring conductor into the "COM" socket and the
plug of the red (positive) conductor for measuring voltage into the "VΩmA" socket. Switch to the function
marked with . Choose the measuring range. It is necessary to switch to a higher range if the "OL" symbol
appears on the screen. Connect the measuring tips to the object you wish to measure (resistance). The
measured resistance value will appear on the screen. When measuring resistances higher than 1 MΩ, it is
necessary to wait a few seconds before the measured value stabilizes. If the circuit is open, the ”OL” symbol
will appear, same as when measuring range is exceeded. Before making measurements, disconnect the
power supply from the tested circuit and thoroughly discharge all its capacitors.
Diode Measurement Function
Connect the plug of the black (negative) measuring conductor into the "COM" socket and the plug of
the red (positive) measuring tip for measuring diodes into the "VΩmA" socket. Switch to the function
marked with . Connect the red measuring tip onto the diode's anode and the black measuring tip
onto the diode's cathode. Approximate voltage in the direction of the ow of current will appear on
the screen. "OL" will appear on the screen if the polarity is reversed.
Battery Test Function
Connect the plug of the black (negative) measuring conductor into the "COM" socket and the plug of the
red (positive) measuring tip for measuring diodes into the "VΩmA" socket. Switch to the function
and choose the measuring range according to the type of battery. Connect the measuring tips to the
battery in such a way that the red tip is connected to the positive pole and the black to the negative
pole of the battery. The measured value will appear on the screen.
Note: When measuring is nished, disconnect the measuring tips from the tested battery.
Emos spol s.r.o. declares that the MD-310 is in compliance with the essential requirements and other
relevant provisions of Directive. The device can be freely operated in the EU. The Declaration of Conformity
can be found at http://www.emos.eu/download.
Do not dispose with domestic waste. Use special collection points for sorted waste. Contact local
authorities for information about collection points. If the electronic devices would be disposed
on landll, dangerous substances may reach groundwater and subsequently food chain, where
it could aect human health.
CZ | Digitální multimetr
Než začnete MD-310 používat, pečlivě si přečtěte tento návod k obsluze. Jsou v něm zvýrazněny zvláště
důležité pasáže, které pojednávají o zásadách bezpečnosti práce s tímto přístrojem. Zabráníte tak mož-
nému úrazu elektrickým proudem nebo poškození přístroje. Multimetr byl navržen v souladu s normou
IEC-61010 vztahující se na elektronické měřící přístroje spadající do kategorie (CAT III 300V), úroveň zne-
čištění 2. Kategorie CAT III je určena k měření obvodů z vybavení napájeného pevnou instalací, jako relé,
zásuvky, rozvodné panely, napáječe a krátké větvící obvody a osvětlovací systémy ve velkých budovách.
Varování
Používejte multimetr MD-310 pouze tak, jak je specikováno níže. Jinak může dojít k poškození přístroje
nebo Vašeho zdraví. Dbejte následujících instrukcí:
• Dříve, než provedete měření odporu, diod nebo proudu, odpojte obvody od zdrojů energie a vybijte
vysokonapěťové kondenzátory. Pro dané měření použijte správnou volbu funkce. Před změnou
rozsahu (funkce) odpojte vodiče od měřeného obvodu.
• Než začnete multimetr používat, pozorně zkontrolujte, zda není přístroj poškozen. Pokud nalez-
nete na těle přístroje zjevné poškození, neprovádějte žádná měření! Zkontrolujte, není-li povrch
multimetru poškrábaný a nejsou-li boční spoje rozklížené.
• Zkontrolujte také izolaci na měřicích sondách. Při poškození izolace hrozí nebezpečí úrazu elektric-
kým proudem. Poškozené měřicí sondy nepoužívejte!
Product specificaties
| Merk: | EMOS |
| Categorie: | Multimeter |
| Model: | M3620 |
Heb je hulp nodig?
Als je hulp nodig hebt met EMOS M3620 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Multimeter EMOS
18 Augustus 2024
25 Juni 2023
28 Mei 2023
19 Mei 2023
13 Mei 2023
22 April 2023
18 April 2023
17 April 2023
16 April 2023
12 April 2023
Handleiding Multimeter
- Multimeter Abus
- Multimeter Aldi
- Multimeter Alecto
- Multimeter Altai
- Multimeter Amiko
- Multimeter Amprobe
- Multimeter Appa
- Multimeter Basetech
- Multimeter Beha-Amprobe
- Multimeter Benning
- Multimeter Brandson
- Multimeter Brennenstuhl
- Multimeter Bruder Mannesmann
- Multimeter Digitus
- Multimeter Elma
- Multimeter Elro
- Multimeter Extech
- Multimeter Ferm
- Multimeter Flir
- Multimeter Fluke
- Multimeter Gembird
- Multimeter Gossen Metrawatt
- Multimeter Greenlee
- Multimeter Hager
- Multimeter Hubinont
- Multimeter Ideal
- Multimeter Keithley
- Multimeter Kingcraft
- Multimeter Laserliner
- Multimeter Mastech
- Multimeter Maxwell
- Multimeter Megger
- Multimeter Metrel
- Multimeter Metrix
- Multimeter Micronta
- Multimeter Milwaukee
- Multimeter Monacor
- Multimeter Parkside
- Multimeter PCE Instruments
- Multimeter Perel
- Multimeter Plieger
- Multimeter Powerfix
- Multimeter Profile
- Multimeter Sanwa
- Multimeter Schneider
- Multimeter Silverline
- Multimeter Skandia
- Multimeter Stanley
- Multimeter TFA
- Multimeter Topcraft
- Multimeter Uni-T
- Multimeter Velleman
- Multimeter Voltcraft
- Multimeter Wiha
- Multimeter Workzone
- Multimeter Joy-it
- Multimeter Jung
- Multimeter Clas Ohlson
- Multimeter Steren
- Multimeter Klein Tools
- Multimeter Tacklife
- Multimeter Biltema
- Multimeter REV
- Multimeter Etekcity
- Multimeter Testo
- Multimeter Somogyi
- Multimeter Testboy
- Multimeter Yato
- Multimeter Wago
- Multimeter GW Instek
- Multimeter Kyoritsu
- Multimeter Owon
- Multimeter Projecta
- Multimeter Cablexpert
- Multimeter Högert
- Multimeter Multimetrix
- Multimeter Digi-tool
- Multimeter Kewtech
- Multimeter Sonel
- Multimeter Testec
- Multimeter Vimar
- Multimeter Strex
- Multimeter PeakTech
- Multimeter MBS
- Multimeter MGL Avionics
- Multimeter Rigol
- Multimeter Chauvin Arnoux
- Multimeter Aim TTi
- Multimeter CEM
- Multimeter Horex
- Multimeter Cosinus
- Multimeter Kurth Electronic
- Multimeter Weltron
- Multimeter Rohde & Schwarz
- Multimeter EEVBlog
- Multimeter Weidmüller
- Multimeter HT Instruments
- Multimeter Caltek
- Multimeter Elworks
- Multimeter Qian
- Multimeter Bearware
- Multimeter Noyafa
Nieuwste handleidingen voor Multimeter
14 November 2024
11 November 2024
22 Oktober 2024
16 Oktober 2024
16 Oktober 2024
16 Oktober 2024
16 Oktober 2024
16 Oktober 2024
30 September 2024
21 September 2024