Elkay LKMY1042CR Handleiding

Elkay Niet gecategoriseerd LKMY1042CR

Lees hieronder de 📖 handleiding in het Nederlandse voor Elkay LKMY1042CR (7 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 151 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/7

SAVE FOR CONSUMER

INSTALLATION / OWNER’S MANUAL

Mystic - Pull-Out Bar Faucet

LKMY1042CR

LKMY1042NK

LKLFMY1042CR

LKLFMY1042NK

Includes:

Tools:

1/2”

[13 mm]

13/16”

[20 mm]

5/8”

[16 mm]

13/16”

[21 mm]

NOTE: these washers are not

used on this faucet model

321

Before inserting the single lever group in the hole of

the sink, make sure that the base gasket is properly

positioned in its seat and that the exible hoses are

well tightened to the body of the tap.

Place the single lever group in the hole of the sink,

orienting the spout toward the sink tank.

For countertop thicknesses less than 1/16” thick

use the ange (B1), for all other installations use

the metal washer (B2).

Secure mounting hardware in place by tightening

mounting nut (B3).

Install the check valve (C1) to the outlet hose with a

rubber washer (C2).

Secure with wrench.

Attach the pull-down hose to the bottom of the

check valve with a rubber washer (D1).

Secure with wrench.

13/16”

[20 mm]

WARNING: please carefully read and properly follow the instructions for installation found in this manual.

STEPS:

1/2”

[13 mm]

Attach the counterweight (D2) to the exible hose

approximately 15-3/4” [400mm] from the connection

to the outlet pipe.

Tighten the shower (E) to the hose interposing

the gasket (D3) and conrm the hose can slide

smoothly through the passage hole.

321

Before dissassembling the faucet be sure that the water supply is turned off.

Remove the nish cap (A), paying attention not to damage it. Remove the setscrew (B) with a 1/8” [2,5mm] hex wrench. Remove the handle (C). Lift the nishing ring nut

(D) using the reference notch. Remove the indicator ring (E). Unscrew the cartridge nut (F) then pull out the cartridge (G). Put the new cartridge into the body of the faucet,