Electrolux E2YH01 Handleiding

Electrolux Strijkijzer E2YH01

Lees hieronder de 📖 handleiding in het Nederlandse voor Electrolux E2YH01 (20 pagina's) in de categorie Strijkijzer. Deze handleiding was nuttig voor 146 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/20

MOUNTING INSTRUCTIONS

INSTRUCTIONS DE MONTAGE

MONTAGEANLEITUNG

INSTRUCTIES VOOR MONTAGE

INSTRUZIONI PER IL MONTAGGIO

INSTRUCCIONES DE INSTALACIÓN

INSTRUÇÕES DE MONTAGEM

MONTERINGSANVISNINGER

MONTERINGSINSTRUKSJONER

MONTERINGSANVISNING

ASENNUSOHJEET

Инструкция по монтажу

MONTAJ BILGILERI

3. 4.

5. 6.**

112233

445566

66**77

8899

Dear customer,

this discharging kit will allow your tumble dryer to discharge the condensation water produced

during each drying cycle directly into the nearest drain, without your having to empty out the

tank at the end of the cycle.

Open the door of your tumble dryer, and extract from the drum the bag that contains the

following items of the discharging kit:

●a nylon band;(5)

●a 90° fitting for connecting the draining hose;(3)

●a plastic curved part to be used for discharging into a sink;(2)

●a plastic anchoring support for fastening the draining hose to the back of the

machine;(4)

●2,5 metres of semi-transparent hose;(1)

●a gasket.(6**)

Position the tumble dryer so its back is towards you.

At the top right you can see a red hose which comes out of the back and is fastened to

a plastic fitting.

Using a pair of pliers, loosen the metal band and push it down, in order to be able to

extract the red hose from the plastic fitting.

Take the 90° fitting that has been supplied and insert it into the red hose.

Insert the plastic anchoring support that fastens the draining hose to the back, then

connect the other end of the draining hose to the 90° fitting.

Using the nylon band, fasten the red hose to the fixed fitting on the back.

By means of a 7-mm socket spanner, unscrew the screw shown in the figure from the

back. Insert the screw you have removed into the relevant seat on the plastic anchoring

support, and tighten the screw, positioning the draining hose as shown in the figure.

If necessary, shorten the draining hose. If you wish to discharge the condensation water

into a sink, you will have to apply the plastic curved part to the draining hose, in order

to be able to hang it on the edge of the sink.

Important!

Do not hang the curved part at a height exceeding 1 metre, and suitably shorten the

draining hose so as not to create a bend higher than 0.5 metres, as shown in the figure.

* Dryers with Steam Technology

Important!

The operation described below must be carried out before completing the stages of the entire

installation of the tumble dryer.

66**

** only with kit 12512251/

Product specificaties

Merk:	Electrolux
Categorie:	Strijkijzer
Model:	E2YH01
Kleur:	n.v.t.
Model:	E2YH01
Merk:	Electrolux
EAN-code:	7321422820001
Productnummer:	902 979 338
Productnummer (PNC):	902 979 338