E-flite Celectra Handleiding

E-flite Batterij-oplader Celectra

Lees hieronder de 📖 handleiding in het Nederlandse voor E-flite Celectra (6 pagina's) in de categorie Batterij-oplader. Deze handleiding was nuttig voor 57 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/6

Instruction Manual

4-Port DC Li-Po Charger EFLC1004

E-ﬂite® products are distributed exclusively by

Horizon Hobby, Inc.

4105 Fieldstone Road

Champaign, IL 61822

www.E-ﬂiteRC.com

15325 Printed 2/09

Features

• 4 independently functioning charging circuits to reliably charge your single-cell

Li-Po battery.

• Charges E-ite and ParkZone single-cell Li-Po batteries for ultra-micro yers.

• Use all 4 ports simultaneously or one at a time.

• Uses four high-capacity D-size batteries (not included) to provide many charges and

maximum portability.

• Optional AC/DC 6V power supply available (EFLC1005).

Battery Charging

LED functions under normal operation:

• Solid – Charging

• Blinking – Charging nearly complete

• Off – Fully Charged

Replace D-size batteries when:

• LED remains solid for over 60 minutes when charging (70mAh–110mAh)

Li-Po batteries

• LED remains solid after removing single-cell Li-Po batteries from individual ports.

• LED remains off after inserting discharged single-cell Li-Po batteries in

individual ports.

It is important that you only charge E-ite and ParkZone 1-Cell 3.7V Li-Po Batteries, used

in our ultra-micro yers, with the Celectra 4-Port 1-Cell 3.7V 0.3A DC Li-Po Charger

(EFLC1004). Please familiarize yourself thoroughly with the Battery Warnings and Guide-

lines section before continuing.

Please follow these steps to charge your single-cell Li-Po battery with the Celectra 4-Port

Li-Po Charger.

• Remove the cover on the bottom of the charger and install four D-size batteries,

noting proper polarity. Replace the cover after the D-size batteries are installed.

Introduction

The Celectra 4-Port DC Li-Po Charger (EFLC1004} offers E-ite® and ParkZone® single-cell

Li-Po users, for ultra-micro yers, the convenience of charging multiple or individual single-

cell Li-Po batteries simultaneously. Pilots can also charge without the need for D-size bat-

teries with the optional E-ite 6V AC/DC Power supply (EFLC1005), specically designed

for use with your 4-port charger.

Battery Warnings and Guidelines

While the Celectra 4-Port 1-Cell 3.7V 0.3A DC Li-Po Charger has been specically

designed to safely charge the E-ite and ParkZone single-cell 3.7V Lithium Polymer

Batteries such as EFLB1101S and PKZ3001, you MUST read the following safety

instructions and warnings before handling, charging or using the Li-Po battery.

Note: Lithium Polymer batteries are signicantly more volatile than the alkaline,

Ni-Cd or Ni-MH batteries used in RC applications. All instructions and warnings

must be followed exactly. Mishandling of Li-Po batteries can result in re.

By handling, charging or using the included Li-Po battery, you assume all risks associated

with lithium batteries. If you do not agree with these conditions, return your complete

Celectra 4-Port 1-Cell 3.7V 0.3A DC Li-Po Charger (EFLC1004), in unused condition to

the place of purchase immediately.

• You must charge 1-cell 3.7V Li-Po batteries in a safe area away from

ﬂammable materials.

• Never charge the battery unattended. When charging the battery you should always

remain in constant observation to monitor the charging process and react to

potential problems that may occur.

• After ight, the Li-Po batteries must be cooled to the ambient temperature

before charging.

• If at any time during the charge or discharge process the battery begins to balloon

or swell, discontinue charging or discharging immediately. Quickly and safely

disconnect the battery, then place it in a safe, open area away from ammable

materials to observe it for at least 15 minutes. Continuing to charge or discharge a

battery that has begun to balloon or swell can result in a re. A battery that has

ballooned or swollen even a small amount must be removed from service

completely.

• Slide the battery into any open slot on the charger. The end-cap of the battery has

been specically designed to allow the battery to be slid into one of the slots easily

one way (usually with the label on the battery facing outward) to prevent reverse

polarity connection. However, please be sure to check for proper alignment and

polarity before proceeding to the next step.

• Gently press the battery and its connector into one of the charge jack/connectors

located at the bottom of the slots on the charger. Again, be sure to check for and to

achieve proper polarity before making the connection. DO NOT FORCE THE BATTERY

INTO THE SLOT.

• After you make the connection successfully, the LED light on the charger port being

used will turn solid red, indicating that charging has begun.

• It will take approximately 30–40 minutes to charge a fully discharged (not

overdischarged) 70mAh–110mAh battery. As the battery nears full charge, the LED

light will begin to blink. When the battery is fully charged the LED light will blink

approximately every 20 seconds or will go out entirely.

Note: Do not leave charged Li-Po batteries connected in any of the charge ports for

long periods of time.

Using the optional 6V, 1.5-Amp AC/DC Power Supply (EFLC1005)

The Celectra 4-Port 1-Cell 3.7V 0.3A DC Li-Po Charger was designed to be compatible

with the E-ite 6V, 1.5-Amp AC/DC Power Supply.

NEVER attempt to power the charger from an AC outlet without the use of a proper AC to

DC adapter/power supply.

Note: When using the AC to DC adapter/power supply, the Celectra 4-Port Charger

is designed to bypass the D-size battery circuitry to prevent damage. It is still

highly recommended that you remove D-size batteries when connecting your

charger to a compatible AC/DC adapter/power supply. Do not insert charged

or discharged Li-Po batteries in any of the charge ports if the power supply is

connected to the 4-port charger while power supply is not connected to a power

source.

NEVER LEAVE THE ADAPTER/POWER SUPPLY OR CHARGER PLUGGED IN UNNATTENDED.

Celectra 4-Port Li-Po Charger Warning

Lithium Polymer (Li-Po) batteries are signicantly more volatile than other rechargeable

batteries used in RC applications. Failure to read and follow these instructions and safety

precautions may result in re, personal injury and damage to property.

E-ﬂite, Horizon Hobby, Inc., its retailers, and any other representatives, assume

absolutely no liability for use of this product or failure to comply with these instructions

and precautions.

If you are not prepared to accept complete liability for the purchase and/or use of this

product, you are advised to return it new and unused to the place of purchase immediately.

Never ship batteries without the expressed permission of the recipient. Batteries

carryinga charge of 25% or more cannot be shipped safely. Batteries which are damaged

cannot be shipped safely. Damage or loss due to unsafe shipping is the legal responsibility

of the person who shipped the product.

Product specificaties

Merk:	E-flite
Categorie:	Batterij-oplader
Model:	Celectra
Kleur van het product:	Zwart
Ingangsspanning:	- V
Frequentie:	- Hz
Spanning:	7.4 V
Compatibele batterij technologiën:	Lithium-Polymeer (LiPo)