Drawmer DS201 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Drawmer DS201 (14 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 175 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/14
DRAWMER
DS201
DUAL NOISE GATE
OPERATOR’S MANUAL
CONTENTS
SAFETY CONSIDERATION page 3
INSTALLATION page 3
INTRODUCTION page 4
CONTROL DESCRIPTIONS page 6
OPERATION page 8
IF A FAULT DEVELOPS page 12
CONTACTING DRAWMER page 12
TECHNICAL SPECIFICATION page 13
BLOCK DIAGRAM page 14
COPYRIGHT
This manual is copyrighted © 2008 by Drawmer Electronics, Ltd. With all rights reserved.
Under copyright laws, this manual may not be duplicated in whole or in part without the
written consent of Drawmer.
ONE YEAR LIMITED WARRANTY
Drawmer Electronics Ltd., warrants this product to conform substantially to the
specifications of this manual for a period of one year from the original date of purchase
when used in accordance with the specifications detailed in this manual. In the case of a
valid warranty claim, your sole and exclusive remedy and Drawmer’s entire liability under
any theory of liability will be to, at Drawmer’s discretion, repair or replace the product without
charge, or, if not possible, to refund the purchase price to you. This warranty is not
transferable. It applies only to the original purchaser of the product.
For warranty service please call your local Drawmer dealer. Alternatively call Drawmer
Electronics Ltd. at +44 (0)1709 527574. Then ship the defective product, with transportation
and insurance charges pre-paid, to Drawmer Electronics Ltd., Coleman Street, Parkgate,
Rotherham, S62 6EL UK. Write the RA number in large letters in a prominent position on
the shipping box. Enclose your name, address, telephone number, copy of the original sales
invoice and a detailed description of the problem. Drawmer will not accept responsibility for
loss or damage during transit.
This warranty is void if the product has been damaged by misuse, modification or
unauthorised repair.
THIS WARRANTY IS IN LIEU OF ALL WARRANTIES, WHETHER ORAL OR WRITTEN,
EXPRESSED, IMPLIED OR STATUTORY. DRAWMER MAKES NO OTHER WARRANTY
EITHER EXPRESS OR IMPLIED, INCLUDING, WITHOUT LIMITATION, ANY IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR
NON-INFRINGEMENT. PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS
WARRANTY SHALL BE REPAIR OR REPLACEMENT AS SPECIFIED HEREIN.
IN NO EVENT WILL DRAWMER ELECTRONICS LTD. BE LIABLE FOR ANY DIRECT,
INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING
FROM ANY DEFECT IN THE PRODUCT, INCLUDING LOST PROFITS, DAMAGE TO
PROPERTY, AND, TO THE EXTENT PERMITTED BY LAW, DAMAGE FOR PERSONAL
INJURY, EVEN IF DRAWMER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES.
Some states and specific countries do not allow the exclusion of implied warranties or
limitations on how long an implied warranty may last, so the above limitations may not apply
to you. This warranty gives you specific legal rights. You may have additional rights that vary
from state to state, and country to country.
In the interests of product development, Drawmer reserve the right to modify or improve
specifications of this product at any time, without prior notice.
-2-
SAFETY CONSIDERATIONS
CAUTION - MAINS FUSE
TO REDUCE THE RISK OF FIRE REPLACE THE MAINS FUSE ONLY WITH THE
SAME TYPE, WHICH MUST BE A CLASS 3, 230 VOLT, TIME DELAY TYPE,
RATED AT 32mA WHERE THE MAINS INPUT VOLTAGE SWITCH IS SET TO 230
VOLTS AC. AND 63mA WHERE THE MAINS INPUT VOLTAGE IS 115 VOLTS AC.
ALL FUSES MUST COMPLY WITH IEC 127-2.
THE FUSE BODY SIZE IS 20mm x 5mm.
CAUTION - MAINS CABLE
DO NOT ATTEMPT TO CHANGE OR TAMPER WITH THE SUPPLIED MAINS
CABLE.
CAUTION - SERVICING
DO NOT PERFORM ANY SERVICING. REFER ALL SERVICING TO
QUALIFIED SERVICE PERSONNEL.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS
EQUIPMENT TO RAIN OR MOISTURE.
INSTALLATION
This product is designed for standard 19" rack mounting and occupies 1U of rack space.
Use four M6 pan head screws to secure the unit into the rack. Fibre or plastic washers may
be used to prevent the front panel becoming marked by the mounting bolts.
!Care should be taken in the choice of positioning. The unit should not be mounted
where other equipment obstructs the normal air flow. The unit should not be situated
near any heat source, such as a radiator, stove or a high power amplifier that would
generate heat.
!The DS201 should not be operated near any water or in a location where moisture
might be present.
-3-


Product specificaties

Merk: Drawmer
Categorie: Niet gecategoriseerd
Model: DS201

Heb je hulp nodig?

Als je hulp nodig hebt met Drawmer DS201 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Drawmer

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd