Dension Gateway 500S Handleiding

Dension Autoradio Gateway 500S

Lees hieronder de 📖 handleiding in het Nederlandse voor Dension Gateway 500S (4 pagina's) in de categorie Autoradio. Deze handleiding was nuttig voor 45 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

INSTALL GUIDE

ice4Link Gateway 500 MOST

State of the art car integration

for media players, USB and

Bluetooth devices

GW5-9210-8

Set the DIP switches to the following

position and install the Gateway

500 as illustrated below:

Car side

CDC

1a.

Remove the blue locking clip from the

middle of the bre optic housing.

Strain the hook carefully with a

sharp tool, while pulling out the

optical bre from the housing.

1b.

1c.

Installation Type 1:

Vehicles supporting multiple CD changers

and equipped with a CD changer

• Audi A4/S4/RS4/A5/A6/S6/RS6/A8/Q7

with MMI-2 High (colour)

These vehicles allow selection of Gateway audio sources

and the original CD changer through the existing car audio

controls.

Introduction

Gateway 500 emulates a CD changer and uses CD changer controls to access

oboard audio sources including iPod, USB devices and Dension Gateway

accessories. If your car is not already equipped with a CD changer, it may be

necessary to have the car programmed by your dealer in order to use the

GW500 with it.

Programming the car for GW500

Audi

No programming required

BMW non iDrive-4

If original CD changer tted and MP3 capability is available: no programming

is required.

If original CD changer tted and no MP3 capability is available:

a) Retrot “KMP3” option with service computer

b) Used in non text capable BMW mode

If original CD changer not tted or E60 M-ASK used: install GW500 and retrot

“IPOD” option with service computer

BMW with iDrive-4

If original CD changer tted: no programming is required

If original CD changer not tted: install an original BMW CD changer and

retrot “CD Changer” temporarily option with service computer

Mercedes

Generally no programming is required but in some cases (e.g. no device was

connected onto the optical ring) it is needed to enable a CD changer with the

service computer.

Porsche

Generally it is needed to enable a CD changer with the service computer but

in rare cases the PCM accept the GW500 without this enabling process.

Saab 9-3

It is needed to enable a CD changer with the service computer using an

original CD changer.

Installation Type 2a:

Vehicles with an existing CD changer

These vehicles allow selection of Gateway audio sources and

the original CD changer by switching the mode between CD

Changer and Gateway mode.

Audi (MMI-2 Basic Monochrome)

Saab 9-3 (Rear CDC)

Porsche (CDR 23/24 and PCM I/II/2.1)

for longer CDC and car side cable use

FOA1PO1

Mercedes (NTG1-, NTG2- Audio 20/50 and

Comand)

CDR PCM

Text capable BMW E87, E90, E91, E92, E93,

E60/61, E63/E64, E65/E66 (03/2005-), E70

and Mini (non iDrive-4)

Non text capable BMW E65/E66 (-03/2005)

(non iDrive-4)

Package Content & Electrical Installation

DIP switch

Car side

CDC side

Power

harness

Power harness:

-red wire

(+12V non switched)

-black (GND)

Car side CDC side

BMW E90, E91, E92, E93 with iDrive-4

You must set the mode selector switch

to service mode (bypass, CD Changer)

position otherwise the service

computer may detect an unknown

device in the bre optic system which

can lead to errors reported.

Service/CDC

mode

When servicing your vehicle

Text Conguration

Saab & Mercedes vehicles require

nal conguration of the Gateway as

not all of the radios in these vehicles

support text display. After Gateway

500 has been installed, toggle the

mode selector switch six times (three

times on/o) and a conguration

menu will appear on the radio

display. Select the conguration

mode according to your head unit

listed in the conguration table. To

conrm the selection press and hold

; to discard the selection press

and hold

Track # Cong Mercedes

Command

Saab

Text

# 1 NO TEXT D D

# 2 Timeout - -

# 3 Text - -

# 4 +Cache - -

# 5 +Paging R R

# 6 +Select - R

For detailed information visit:

http://support.dension.com

D: Default, R: Recommended

Car side

Installation Type 3a:

Vehicles with no existing CD changer

Set the DIP switches as shown below.

Text capable BMW E87, E90, E91, E92, E93, E60/61,

E63/E64, E65/E66 (03/2005-), E70

and Mini (non iDrive-4)

Audi (MMI-2 Basic Monochrome)

Saab 9-3 (Rear CDC)

Porsche (CDR 23/24 and PCM I/II/2.1)

Mercedes (NTG1-, NTG2- Audio 20/50 and

Comand)

If you are connecting Gateway 500 to the back

of the head unit, use this diagram:

CDR PCM

Non text capable BMW E65/E66 (-03/2005)

(non iDrive-4)

Car side

Installation Type 3b:

If you are installing to a free bre optic connector in the car

(CDC preparation) use this method:

654

Volvo S40/V50 - MY 2004-2007 with Basic and

High Performance sound system, without AUX in-

put, with CDC

Installation Type 2b:

ICM

(Display)

Car side

LED

Volvo XC90 - MY 2002-2006, with High Perfor-

mance and Premium sound system,

without AUX input, with CDC

Saab 9-3 (Front CDC)

BMW E90, E91, E92, E93 with iDrive-4

Use a CDC for enabling

Saab 9-3 (Front CDC)

The LED (arrowed) indicates

the current operating mode

ò= GW5 (Blue LED Solid)

ö = Service/CDC

(Blue LED Flashing)

LED

Product specificaties

Merk:	Dension
Categorie:	Autoradio
Model:	Gateway 500S
Kleur van het product:	Zwart
Ingebouwd display:	Nee
Bluetooth:	Nee
MP3 afspelen:	Ja
AUX ingang:	Ja
Optische drive type:	Nee
USB direct afspelen:	Ja
CD-R afspelen:	Nee
CD-RW afspelen:	Nee
Te gebruiken met een iPod:	Ja