Denon AVR-1706 Handleiding

Denon Receiver AVR-1706

Lees hieronder de 📖 handleiding in het Nederlandse voor Denon AVR-1706 (61 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 130 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/61

AV SURROUND RECEIVER

AVR-1706

OPERATING INSTRUCTIONS

MODE D’EMPLOI

FCC INFORMATION (For US customers)

ENGLISHFRANCAIS

2 SAFETY PRECAUTIONS

1. PRODUCT

This product complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) this product may not cause

harmful interference, and (2) this product must accept any interference

received, including interference that may cause undesired operation.

2. IMPORTANT NOTICE: DO NOT MODIFY THIS PRODUCT

This product, when installed as indicated in the instructions contained

in this manual, meets FCC requirements. Modification not expressly

approved by DENON may void your authority, granted by the FCC, to

use the product.

3. NOTE

This product has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation.

This product generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular

installation. If this product does cause harmful interference to radio or

television reception, which can be determined by turning the product

OFF and ON, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the product into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the local retailer authorized to distribute this type of

product or an experienced radio/TV technician for help.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT

REMOVE COVER (OR BACK). NO USER-SERVICEABLE

PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE

PERSONNEL.

The lightning flash with arrowhead symbol, within an

equilateral triangle, is intended to alert the user to the

presence of uninsulated “dangerous voltage” within the

product’s enclosure that may be of sufficient magnitude

to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is

intended to alert the user to the presence of important

operating and maintenance (servicing) instructions in the

literature accompanying the appliance.

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO

NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

1. Read Instructions – All the safety and operating instructions should be

read before the product is operated.

2. Retain Instructions – The safety and operating instructions should be

retained for future reference.

3. Heed Warnings – All warnings on the product and in the operating

instructions should be adhered to.

4. Follow Instructions – All operating and use instructions should be

followed.

5. Cleaning – Unplug this product from the wall outlet before cleaning.

Do not use liquid cleaners or aerosol cleaners.

6. Attachments – Do not use attachments not recommended by the

product manufacturer as they may cause hazards.

7. Water and Moisture – Do not use this product near water – for

example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in

a wet basement; or near a swimming pool; and the like.

8. Accessories – Do not place this product on an unstable cart, stand,

tripod, bracket, or table. The product may fall, causing serious injury

to a child or adult, and serious damage to the product. Use only with

a cart, stand, tripod, bracket, or table recommended by the

manufacturer, or sold with the product. Any

mounting of the product should follow the

manufacturer’s instructions, and should use a

mounting accessory recommended by the

manufacturer.

9. A product and cart combination should be moved

with care. Quick stops, excessive force, and

uneven surfaces may cause the product and cart

combination to overturn.

10. Ventilation – Slots and openings in the cabinet are provided for

ventilation and to ensure reliable operation of the product and to

protect it from overheating, and these openings must not be blocked

or covered. The openings should never be blocked by placing the

product on a bed, sofa, rug, or other similar surface. This product

should not be placed in a built-in installation such as a bookcase or

rack unless proper ventilation is provided or the manufacturer’s

instructions have been adhered to.

11. Power Sources – This product should be operated only from the type

of power source indicated on the marking label. If you are not sure of

the type of power supply to your home, consult your product dealer

or local power company. For products intended to operate from

battery power, or other sources, refer to the operating instructions.

12. Grounding or Polarization – This product may be equipped with a

polarized alternating-current line plug (a plug having one blade wider

than the other). This plug will fit into the power outlet only one way.

This is a safety feature. If you are unable to insert the plug fully into

the outlet, try reversing the plug. If the plug should still fail to fit,

contact your electrician to replace your obsolete outlet. Do not defeat

the safety purpose of the polarized plug.

13. Power-Cord Protection – Power-supply cords should be routed so that

they are not likely to be walked on or pinched by items placed upon

or against them, paying particular attention to cords at plugs,

convenience receptacles, and the point where they exit from the

product.

15. Outdoor Antenna Grounding – If an outside antenna or cable system

is connected to the product, be sure the antenna or cable system is

grounded so as to provide some protection against voltage surges

and built-up static charges. Article 810 of the National Electrical Code,

ANSI/NFPA 70, provides information with regard to proper grounding

of the mast and supporting structure, grounding of the lead-in wire to

an antenna discharge unit, size of grounding conductors, location of

antenna-discharge unit, connection to grounding electrodes, and

requirements for the grounding electrode. See Figure A.

16. Lightning – For added protection for this product during a lightning

storm, or when it is left unattended and unused for long periods of

time, unplug it from the wall outlet and disconnect the antenna or

cable system. This will prevent damage to the product due to

lightning and power-line surges.

17. Power Lines – An outside antenna system should not be located in

the vicinity of overhead power lines or other electric light or power

circuits, or where it can fall into such power lines or circuits. When

installing an outside antenna system, extreme care should be taken to

keep from touching such power lines or circuits as contact with them

might be fatal.

18. Overloading – Do not overload wall outlets, extension cords, or

integral convenience receptacles as this can result in a risk of fire or

electric shock.

19. Object and Liquid Entry – Never push objects of any kind into this

product through openings as they may touch dangerous voltage

points or short-out parts that could result in a fire or electric shock.

Never spill liquid of any kind on the product.

20. Servicing – Do not attempt to service this product yourself as opening

or removing covers may expose you to dangerous voltage or other

hazards. Refer all servicing to qualified service personnel.

21. Damage Requiring Service – Unplug this product from the wall outlet

and refer servicing to qualified service personnel under the following

conditions:

a) When the power-supply cord or plug is damaged,

b) If liquid has been spilled, or objects have fallen into the product,

c) If the product has been exposed to rain or water,

d) If the product does not operate normally by following the operating

instructions. Adjust only those controls that are covered by the

operating instructions as an improper adjustment of other controls

may result in damage and will often require extensive work by a

qualified technician to restore the product to its normal operation,

e) If the product has been dropped or damaged in any way, and

f) When the product exhibits a distinct change in performance – this

indicates a need for service.

22. Replacement Parts – When replacement parts are required, be sure

the service technician has used replacement parts specified by the

manufacturer or have the same characteristics as the original part.

Unauthorized substitutions may result in fire, electric shock, or other

hazards.

23. Safety Check – Upon completion of any service or repairs to this

product, ask the service technician to perform safety checks to

determine that the product is in proper operating condition.

24. Wall or Ceiling Mounting – The product should be mounted to a wall

or ceiling only as recommended by the manufacturer.

25. Heat – The product should be situated away from heat sources such

as radiators, heat registers, stoves, or other products (including

amplifiers) that produce heat.

SAFETY INSTRUCTIONS

FIGURE A

EXAMPLE OF ANTENNA GROUNDING

AS PER NATIONAL

ELECTRICAL CODE ANTENNA

LEAD IN

WIRE

GROUND

CLAMP

ELECTRIC

SERVICE

EQUIPMENT

ANTENNA

DISCHARGE UNIT

(NEC SECTION 810-20)

GROUNDING CONDUCTORS

(NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING

ELECTRODE SYSTEM

(NEC ART 250, PART H)

NEC – NATIONAL ELECTRICAL CODE

ENGLISH FRANCAIS

2 System setup / Configuration système

* F r o n t L a r g e

* C e n t e r S m a l l

* S u r r . S m a l l

* S . B a c k S m a l l

* S . B a c k 2 s p >

* S u b w o o f e r Y e s

Speaker Configuration Subwoofer Mode

Crossover Frequency

* S u b w o o f e r Y e s

Delay Time

* F r o n t L 1 2 f t

* F r o n t R 1 2 f t

* C e n t e r 1 2 f t

* S u r r . L 1 0 f t

* S u r r . R 1 0 f t

* S . B a c k L 1 0 f t

* S . B a c k R 1 0 f t

* S W 1 2 f t

Digital In Assignment

* S W M o d e N o r m

* C r . O v e r 8 0 H z

Test Tone

* T E S T T O N E Y e s <

Audio Delay

*COAX1 CD

*COAX2 AUX

*OPT1 DVD

*OPT2 TV

Video Input Mode

*DVD Auto

*TV Auto

*VCR Auto

* A . D e l a y 0 m s

Auto Surround Mode

* A u t o S u r r . O N

Ext. In Subwoofer Level

Power Amp Assignment

* E x t . I n S W + 1 5 d B

* P . A m p S . B a c k

page 38, 39

page 39, 40

page 40

page 41

page 42

page 43

Product specificaties

Merk:	Denon
Categorie:	Receiver
Model:	AVR-1706
Kleur van het product:	Zwart
Gewicht:	11.3 g
Breedte:	434 mm
Diepte:	417 mm
Hoogte:	147 mm
Ethernet LAN:	Nee
Composiet video-ingang:	4
Componentingang video (YPbPr/YCbCr):	3
S-Video ingang:	3
Ingang stroom:	Ja
3D:	Nee
Digitale audio, optische uitgang:	2
Ingebouwde audio decoders:	DTS 96/24,DTS-ES (Discrete 6.1),DTS-ES (Matrix 6.1),Dolby Digital EX,Dolby Pro Logic IIx
Audio-uitgangskanalen:	7.1 kanalen
Frequentiebereik:	10 - 100000 Hz
Composiet video-uitgang:	2
Audio A/D-converter (ADC):	24-bit/96kHz
D/A-converter:	24-bit/192kHz
S-Video uitgang:	2
Digitale audio, coaxuitgang:	2
Componentuitgang video (YPbPr/YCbCr):	1
AUX ingang:	Ja
Ondersteunde frequentiebanden:	AM,FM
Totale harmonische vervorming (THD):	0.08 procent
Apple docking-compatibiliteit:	Niet ondersteund
FM-band:	87.5 - 107.9 MHz
Ontvanger type:	Surround
Afstandsbediening inbegrepen:	Ja
Wifi:	Nee
AC-ingangsspanning:	120 V
AC-ingangsfrequentie:	60 Hz
AM band bereik:	520 - 1710 kHz
Digital Signal Processing (DSP):	Ja
Vermogen uitvoer per kanaal (20-20KHz@8 Ohm):	75 W
Inclusief optische drive:	Nee
Vermogen uitvoer per kanaal (1KHz@6 Ohm):	110 W