Danby DPSL120B1W Handleiding

Danby Airco DPSL120B1W

Lees hieronder de 📖 handleiding in het Nederlandse voor Danby DPSL120B1W (12 pagina's) in de categorie Airco. Deze handleiding was nuttig voor 72 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
DANBY PRODUCTS LIMITED, ONTARIO, CANADA N1H 6Z9
DANBY PRODUCTS INC., FINDLAY, OHIO, USA 45840
OWNER’S MANUAL
MANUEL DU PROPRIÉTAIRE
MANUAL DEL PROPIETARIO
www.Danby.com
THROUGH-THE-WALL AIR CONDITIONER SLEEVE
Owners Manual.........................................1 - 3
MANCHON DU CLIMATISEUR AU MUR
Manual du propriétaire...............................4 - 6
MANGA DEL ACONDICIONADOR DE AIRE
Manual del propietario...............................7 - 9
2020.04.10
MODEL MODÈLE MODELO• •
DPSL120B1W
INSTALLATION INSTRUCTIONS
INCLUDED PARTS - SLEEVE
A. Bottom panel
B. Top panel
C. Left panel
D. Right panel
E. Seal A (26.4” long)
F. Seal B (1.6” long) x2
G. Long screws x4
H. Short screws x14
1
6
9.3
A
BB
1
2
3
4
Open the left and right panels
Secure with 6 short screws
Use 8 short screws to secure
the bottom panel
Attach foam seal A and B
INCLUDED PARTS - DRAIN KIT
1. Cover plate with drain outlet
2. Foam gasket with drain outlet x2/x6
3. Cover plate (optional) x1/x2
4. Bent tube (optional)
5. Straight tube (optional) x0/x1
6. Screws ST3.9*14 (optional) x4/x6
Note: There are differences between the inside and
outside drainage kit parts, please refer to the actual
product.
ASSEMBLY - SLEEVE
Note: The drain kit is optional. If you plan to use the
drain kit, make sure to assemble and install it before
installing the air conditioner in the sleeve.
12
7
56
3 4
123
6
45
INSTALLATION INSTRUCTIONS
If using the drain on the back of the sleeve,
attach the foam gaskets to the cover plates
and insert the bent hose
Install the cover plate with the tube on the
outlet at the back of the sleeve. Install the
cover plate without the tube on the outlet at
the front of the sleeve. The cover plate with
the tube can be placed on either side of the
sleeve. Make sure the tube’s position will
allow the sleeve to fit in the wall.
Install the final cover plate on the drain
outlet on the bottom of the sleeve.
ASSEMBLY - DRAIN KIT - OUTSIDE DRAIN ASSEMBLY - DRAIN KIT - INSIDE DRAIN
1/ 8 0.4 ~ 0.5
Drill two 1/8” holes in the bottom of the sleeve for the screws.
Drill one 0.4” ~ 0.5” hole for the drain tube.
Install the cover plate with the tube on the bottom of the sleeve.
Install the other two cover plates on the drain outlets on the front
and back of the sleeve.
If using the drain on the bottom of the sleeve, attach the foam
gaskets to the cover plates and insert the straight hose
2


Product specificaties

Merk: Danby
Categorie: Airco
Model: DPSL120B1W

Heb je hulp nodig?

Als je hulp nodig hebt met Danby DPSL120B1W stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Airco Danby

Handleiding Airco

Nieuwste handleidingen voor Airco