Da-Lite Scenic Roller 40317 Handleiding

Da-Lite Niet gecategoriseerd Scenic Roller 40317

Lees hieronder de ๐Ÿ“– handleiding in het Nederlandse voor Da-Lite Scenic Roller 40317 (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
INSTRUCTION BOOK FOR
Scenic Roller
2
Pre-Installation Installation
Having decided on hooks, chains, cables or other mounting
method, have mounting prepared before opening box.
Do not mount screen against walls that might rub fabric.
1. Remove screen from box by lifting roller at the ends. Be
careful not to permit lid or any tools to fall on screen. During
installation handle unit only by ends of roller and top header.
Do not grasp around fabric โ€“do not rest unit on fabric.
2. Remove wrapping paper and unwind ropes.
3. With the screen lying on the ๎˜Ÿloor, install the clamps on the
reinforcement tape on the header as shown in Figure 2.
Clamp assembly is shown in Figure 1. Drop the closed loop of
the turnbuckle in the slot of the clamp before inserting bolt.
Each clamp uses three bolts and nuts. Do not tighten nuts
any more than ๎˜Ÿinger tight. Make sure the ends of clamps do
not push into the fabric. Pulleys at each end of header must
be in the vertical position, when hung for proper operation.
4. Adjust top header in fabric pocket to the 2๎˜ž1/4" and 3๎˜ž3/4"
position shown on the drawing.
5. Hang the screen in place at three, ๎˜Ÿive, or seven points.
CAUTION! When this screen is shipped from the factory,
there are 2-1/2 turns of rope around each end of the roller.
Make certain that this is left unchanged to insure good
operation.
CAUTION! Before dropping fabric make certain ropes
at end of bottom roller do not overlap. Overlapping of
ropes will cause rope to work inward and thus damage
the fabric.
Figure 1 โ€“ Clamp Assembly
3
1. Lower screen slowly by gradually releasing ropes.
2. With screen in the โ€œDownโ€ position, turn the header in the
fabric pocket carefully to adjust the pulleys to a vertical end
position. Check the 2๎˜ž1/4" and 3๎˜ž3/4" end tube dimensions.
Adjust the clamps on the reinforcement tape. Clamps are not
to push into fabric pocket. Tighten nuts on all bolts.
3. Total screen drop may be controlled by adjusting rope clamp.
Do not adjust for more drop.
4. With unit in completely unrolled position, examine the screen
carefully. If slight sag appears in center of fabric, adjust
turnbuckles at the eye bolts until fabric hangs ๎˜Ÿlat.
5. Screen may be raised by pulling on ropes. Tie o๎˜Ÿf ropes to
keep screen in raised position.
6. Protect your screen against damage and it will give many
years of enjoyment.
a. When lowering screen, do so gently. Never allow it to
drop uncontrolled.
b. Before raising screen, be sure both front and back sides
are free from insects or any foreign matter.
c. Form the habit of looking in space between fabric and
roller for foreign matter before raising screen.
d. Caution stage hands and others to avoid bumping
screen with ladders, scenery, etc.
Screen Adjustment
Don't Adjust
Rope Clamp
Already Set
for Proper
Full Screen
Opening
Mount Header
Tube Level
Locate Clamps on
Reinforcement Tape
Mount at These Points Only
Turnbuckle โ€“ Adjust
for Flat Fabric Hang
Do Not Handle Unit by
Fabric Area
Pulley Must be Installed
in The Vertical Position
Check Here for Foreign
Matter Before Raising
Screen
Center Line of Screen
Handle Unit Only
by Top Header and
Roller Ends During
Installation
Figure 2
2 ยผ" 3 ยพ"
6" 6"


Product specificaties

Merk: Da-Lite
Categorie: Niet gecategoriseerd
Model: Scenic Roller 40317

Heb je hulp nodig?

Als je hulp nodig hebt met Da-Lite Scenic Roller 40317 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Da-Lite

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd