Crestron HD-RX3-C-B Handleiding

Crestron AV extender HD-RX3-C-B

Lees hieronder de 📖 handleiding in het Nederlandse voor Crestron HD-RX3-C-B (1 pagina's) in de categorie AV extender. Deze handleiding was nuttig voor 97 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/1

quickstart guide

HD-RX3-C

www.crestron.com

Specifications subject to

change without notice.

QUICKSTART DOC. 7484B (2035791) 05.14

4K HDMI® over HDBaseT® Receiver

For regulatory compliance information, refer to Doc. 7485.

HD-RX3-C

2 Mounting

Mount the HD-RX3-C on a flat surface or on a rack rail as

appropriate for the installation.

Introduction

The Crestron® HD-RX3-C connects directly to an HDBaseT®

compliant source, enabling the transmission of high-definition

digital video and audio signals up to 330 feet (100 meters)

over a single CAT5e cable. When used with the HD-TX3-C

transmitter, the HD-RX3-C transmits HDMI® signals as well

as RS-232 and IR control signals. 4K video is supported up

to 230 feet (70 meters).

Mounting the HD-RX3-C on a Flat Surface

Using four mounting screws

(not supplied), attach the

HD-RX3-C to a flat surface.

Mounting of the HD-RX3-C

on a wall is shown below.

Mounting Screws (4)

(Not Supplied)

Mounting the HD-RX3-C on a Rack Rail

Mount the HD-RX3-C on the front or rear rail of a rack

as follows:

1. Position either the left or right mounting flanges of the

device so that the holes align with the holes in the rack

(mounting of right mounting flanges is shown below).

2. Secure the device to the rack using two rack mounting

screws (not supplied).

Connections

Connecting to Ground

Connect the chassis ground lug on the HD-RX3-C to

earth ground (building steel). Ground

Lug

Connecting the 24 Vdc Power Connector

Connect the 24 Vdc power connector as follows:

●

If the HD-RX3-C connects to an HD-TX3-C, connect only one 24 Vdc power pack

(supplied) to either the HD-RX3-C or HD-TX3-C. Only one power pack is

required to power both the HD-RX3-C and HD-TX3-C. Power is transmitted over

the cable that connects the HDBaseT ports of the HD-RX3-C and HD-TX3-C.

● If the HD-RX3-C connects to a DM 8G+ output or to a third-party HDBaseT

compliant source, connect the supplied power pack to the HD-RX3-C.

To HD-RX3-C

HD-TX3-C

HDBaseT IN PWR

24 V

0.75A

24V

0.75A

OUT

Connecting the HDMI OUT Port

Using an HDMI cable (not supplied), connect the HDMI

OUT port to the HDMI input port of the receiving device.

Connecting the Control Ports

Connect the or control port or both as IR OUT COM

follows:

● IR OUT: Using the Crestron IRP2 emitter (sold

separately), connect the 2-pin terminal block of the

IR OUT port to the IR sensor window of the device to

be controlled.

● COM (RS-232): Using a data communications cable

(not supplied), connect the 3-pin terminal block of

the COM port to the COM port of the device to

be controlled.

Connecting the HDBaseT IN Port

Connect the port to any of the following:HDBaseT IN

● HDBaseT port on the HD-TX3-COUT

● DM 8G+™ output of a DM

® switcher or DM 8G+

transmitter

● Third-party HDBaseT compliant source

For resolutions up to 1600 x 1200 and 1920 x 1200

(including 1080p60 and 2K), maximum wire length is

330 feet (100 meters) using Crestron DM-CBL-8G,

DM-CBL, DM-CBL-D, or third-party CAT5e (or better)

UTP or STP cable. For higher resolutions (including 4K),

maximum wire length is 230 feet (70 meters) using

DM-CBL-8G or 165 feet (50 meters) using DM-CBL,

DM-CBL-D, or third-party CAT5e cable. (All wire and

cables are sold separately.)

COM HDMI OUT IR OUT

G S

NOTE: Shielded cable and connectors are

recommended to safeguard against unpredictable

environmental electrical noise which may impact

performance at resolutions above 1080p.

DM-CBL-8G cable is recommended for optimum

performance and ESD (electrostatic discharge)

protection.

HDBaseT IN PWR

24 V

0.75A

HDBaseT IN PWR

24 V

0.75A

LED Indicators

LED indicators are provided on the

HD-RX3-C.

PWR

LED

Green

LED

Amber

LED

INDICATOR

COLOR DESCRIPTION

HDBaseT IN A link is established

with the HD-TX3-C,

DM 8G+, or

third-party HDBaseT

compliant device.

Non-HDCP video is

detected.

HDCP video is

detected.

HDMI video is not

detected.

PWR The HD-RX3-C is

powered on.

The HD-RX3-C is

not powered on.

Green

Blinking

amber

Solid

amber

Amber

off

Green

Off

HDBaseT IN PWR

24 V

0.75A

The specific patents that cover Crestron products are listed at patents.crestron.com.

Crestron, the Crestron logo, DM, and DM 8G+ are either trademarks or registered trademarks of Crestron Electronics, Inc. in the

United States and/or other countries. HDBaseT and the HDBaseT Alliance logo are either trademarks or registered trademarks of

the HDBaseT Alliance in the United States and/or other countries. HDMI and the HDMI logo are either trademarks or registered

trademarks of HDMI Licensing LLC in the United States and/or other countries. Other trademarks, registered trademarks, and trade

names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron

disclaims any proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or

photography.

Rack Mounting Screws

(Not Supplied)

COM HDMI OUTIR OUT

G S

Product specificaties

Merk:	Crestron
Categorie:	AV extender
Model:	HD-RX3-C-B
Kleur van het product:	Zwart, zilver
Gewicht:	330 g
Breedte:	100 mm
Diepte:	120 mm
Hoogte:	37 mm
Soort:	AV-receiver
LED-indicatoren:	Ja
Stroom:	0.75 A
Connectiviteitstechnologie:	Bedraad
Maximum resolutie:	4096 x 2160 Pixels
Inclusief AC-adapter:	Ja
HDCP:	Ja
Aansluiting voor netstroomadapter:	Ja
3D:	Ja
Materiaal:	Aluminium, Polycarbonate
Ondersteunde grafische resoluties:	1600 x 1200 (UXGA),1920 x 1080 (HD 1080),2048 x 1080,2560 x 1440,2560 x 1600 (WQXGA),3840 x 2160,4096 x 2160
Aantal HDMI-uitgangen:	1
Operating voltage:	24 V
HDBaseT-poort:	Ja
Maximaal bereik:	100 m
AC-ingangsspanning:	100-240 V
AC-ingangsfrequentie:	50 - 60 Hz
Bedrijfstemperatuur (T-T):	0 - 40 °C
Relatieve vochtigheid in bedrijf (V-V):	10 - 90 procent
HDCP- & EDID-omzeiling:	Ja