Claro Whisper DC Handleiding

Claro Ventilator Whisper DC

Lees hieronder de 📖 handleiding in het Nederlandse voor Claro Whisper DC (16 pagina's) in de categorie Ventilator. Deze handleiding was nuttig voor 37 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/16
WHISPER DC
Installation Manual
VER 0.1
1
CEILING FAN INSTRUCTION BOOKLET
Thank you for purchasing your Claro Whisper DC Ceiling Fan.
Please read all instructions carefully before assembly and use.
IMPORTANT SAFEGUARDS:
Read all instructions carefully, even if you feel you are quite familiar with this type of appliance. When
using electrical appliances, in order to reduce the risk of fire, electric shock, and/or injury, these
basic safety precautions should always be followed:
1. All wiring must be done by a licenced electrician as on-site warranty may be voided if proof cannot
be provided. This ceiling fan be installed by a Qualified Electrical Contractor in accordance MUST
with the local regulations, and all local, state and national electrical codes. Any alterations or
additions to building wiring must be completed by a licensed electrical contractor, or person
authorised by legislation to work on the fixed wiring of any electrical installation.
2. The fan must be connected to a 240V AC 50Hz power supply.
3. All electrical work must only be undertaken after disconnection of the power by removing fuses or
turning off the circuit breaker, to ensure all pole isolation of the electrical supply.
4. The fan must be earthed.
5. Th e fan must be installed so that the blades are at least 2.1 metres above the floor.
6. The ceiling fan weight is max. 4.9kg. The structure that the ceiling fan is mounted to must be
capable of supporting a weight of at least 45kg. The fixing must be able to support the moving
weight of the fan and must not twist or work loose.
7. Make sure that the installation site will not allow the rotating fan blades to come into contact with
any object and that there is enough space from the blade tip to the wall or ceiling. Please note that
insufficient clearance distances might cause wobbling and the bigger this clearance is the better the
airflow from your fan will be.
8. This product can be installed in a position where it is covered or enclosed alfresco areas and there
is a minimum clearance of 1.50 m from the blade tip to all edges of the roof or positions where it
could be exposed to water, moisture or other dangerous external elements
9. DO NOT connect the fan motor to a dimmer switch. This may give an unsatisfactory performance
(motor hum) and cause damage to the motor and/or controller. Use ONLY the provided remote
control.
10. This appliance is not intended for use by young children or infirm persons without supervision.
Young children should be supervised to ensure that they play with the appliance. DO NOT
11. It is recommended that ceiling fans and gas appliances be operated in the same room at the NOT
same time.
12. The fan must be turned off and stopped completely before reversing the fan direction. This will
prevent any damage to the motor of the fan or controller.
13. Do not insert anything into the fan blades whilst they are spinning. This will damage the blades and
upset the balance of the fan causing the unit to wobble.
14. After the fan is completely installed make sure that all base and fan blade fixings are secured and
tightened to prevent any problems.
15. Because of the fan’s natural movement, some connections may loosen. Check the support
connections, brackets and blade attachments twice a year to make sure they remain secured. If any
are loose, tighten.
16. If unusual oscillating movement is observed, immediately stop using the ceiling fan and contact the
manufacturer, its service agent or suitably qualified persons.
2
17. The replacement of parts of the safety suspension system device shall be performed by the
manufacturer, its service agent or suitably qualified persons.
18. If it is necessary to replace the live or neutral brushes to ensure operation of the motor then
both brushes and the earth brush shall be replaced at the same time. The brushes shall only be
replaced by a suitably qualified person.
19. An all-pole disconnection incorporated in the fixed wiring is to be provided, such as an all-pole
switch or a supply cord fitted with a plug.
20. The remote/receiver included is intended to be used with this fan and associated light component
ONLY and is not compatible with any other lighting and/or any other electrical device. Use of it in
any way other than intended may result in damage to the fan, receiver and/or other devices and as
such, will void warranty.
21. The light source in light kit is not replaceable; when the light source reaches its end of life the
whole light kit shall be replaced by manufacture, his service agent or a qualified person.
22. The max operating temperature for the fan is 40°C. Keep the fan away from any heat sources, like
fire place, heater and stove.
23. Reasonable ‘wear and tear’ is not covered under warranty. For comprehensive warranty terms &
conditions visit clarofans.com.au
IMPORTANT NOTE:
The important safeguards and instructions given in this manual are not meant to cover all possible
conditions and situations that may occur. It must be understood that common sense, caution and care
are factors which cannot be built into any product.
CAUTION:
• DO NOT ingest battery - Chemical burn hazard
• The remote supplied with this product contains 2xAAA batteries. If the battery is swallowed, it can
cause severe internal burns in just 2 hours and can lead to death
• Keep the new and used batteries away from children. Examine devices regularly, and sure the en
battery compartment is secure
- If the battery compartment does not close securely, stop using the product and keep it away
from children
• If you think the batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention
- Call the Poisons Information Centre on or go to a hospital emergency room 13 11 26
- let the child eat or drink or induce vomiting. Dispose of used button batteries DO NOT
immediately
• The batteries supplied with this product is not to be recharged
• Different types or new and used batteries are not to be mixed
• Battery to be inserted with the correct polarity; + for positive, - for negative ‘ ’ ‘ ’
• Exhausted batteries are to be removed from the appliance and safely disposed of
• If the appliance is to be stored unused for a long period, the batteries should be removed
• Dispose of used button batteries immediately
• Flat batteries can still be dangerous. The supply terminals are not to be short-circuited

Product specificaties

Merk: Claro
Categorie: Ventilator
Model: Whisper DC

Heb je hulp nodig?

Als je hulp nodig hebt met Claro Whisper DC stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Ventilator Claro

Claro

Claro Whisper AC Handleiding

12 Juni 2023
Claro

Claro Whisper DC Handleiding

12 Juni 2023

Handleiding Ventilator

Nieuwste handleidingen voor Ventilator

Aerian

Aerian MISTY100 Handleiding

17 November 2024
Tornado

Tornado HI-FAN-24HVWM-1P Handleiding

17 November 2024
Tornado

Tornado HI-FAN-24PF-1P Handleiding

17 November 2024
Tornado

Tornado HI-FAN-24MOWF-A-1P Handleiding

17 November 2024
Tornado

Tornado HI-FAN-20HVWM-A-1P Handleiding

17 November 2024
Tornado

Tornado HI-FAN-20WMPRO-1P Handleiding

17 November 2024
Tornado

Tornado HI-FAN-24MOWF-WR-1P Handleiding

17 November 2024
Tornado

Tornado HI-FAN-30HVOF-1P Handleiding

17 November 2024
Tornado

Tornado HI-FAN-30POF-WR-1P Handleiding

17 November 2024
Tornado

Tornado HI-FAN-20POF-5BA-1P Handleiding

17 November 2024