Chord SPM 6000 Mk2 Handleiding

Chord Receiver SPM 6000 Mk2

Lees hieronder de 📖 handleiding in het Nederlandse voor Chord SPM 6000 Mk2 (5 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 106 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/5
SPM 6000 MK2
POWER AMPLIFIER MANUAL
OPERATING INSTRUCTIONS
INSTALLATION
Your amplifier should be positioned to ensure a free flow of air over the rear heat sink and through the upper and
lower grilles. When driven continuously at well above average listening levels, the temperature on the heat sink may
exceed 50oC. This is not a fault, but an indication of the need for adequate ventilation.
Please ensure that the IEC mains lead is correctly terminated.
UK/EUROPE Brown = LIVE = Black USA/CANADA!
Blue = NEUTRAL = White!
Yellow/Green = EARTH = Green
THE SPM 6000 Mk 2 MUST BE EARTHED AT ALL TIMES VIA ITS OWN MAINS LEAD.
FAILURE TO DO THIS MAY BE HAZARDOUS.
CE This unit complies with EN 50081-1 & IEC 801/2
It has come to light that, in some European
countries a hum may occur if Pre and Power
Amplifiers are connected to mains wall sockets
which do not have an earth. Please ensure
that, if this is the case, the pre and power amps
are connected via a multi-way mains block
which contains an earth point at each socket
outlet. This is to ensure that the chassis
metalwork of each item is connected together
and Chord Electronics Limited firmly
recommends that an earthing method for the
building is implemented.
REAR PANEL
The rear of the SPM 6000 Mk 2 has two sets of inputs, one set of balanced XLR connections and one set of phono
RCA connectors. You will also notice by looking at the diagram below that the inputs can be connected as either
INVERTING or NON-INVERTING modes. Connecting to either the phono or the XLR on the right hand side will
give an inverted output as is normal with other Chord amplification. However if a non-inverting output is preferred
simply connect to the left hand side. As the SPM 6000 Mk 2 is of mono block construction only one of the inputs
should be used. Where a pair of units is used for stereo operation the user should take care to connect both amplifiers
in the same manner so as not to have an out of phase configuration. The input should be connected last, with the
amplifier switched off.
There are two sets of high current gold plated output terminals, the speaker may be connected to either the left
or the right set of terminals. For Bi-wiring configuration both sets of outputs can be used.
!


Product specificaties

Merk: Chord
Categorie: Receiver
Model: SPM 6000 Mk2

Heb je hulp nodig?

Als je hulp nodig hebt met Chord SPM 6000 Mk2 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Receiver Chord

Handleiding Receiver

Nieuwste handleidingen voor Receiver