Chord IEM58 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Chord IEM58 (4 pagina's) in de categorie Hoofdtelefoon. Deze handleiding was nuttig voor 45 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
IEM 58
In-Ear Monitoring System
Item ref: 171.900UK, 171.899UK (additional receiver)
User Manual
Version 1.0
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
171.899UK and 171.900UK User Manual
Introduction
Thank you for choosing the Chord IEM -ear monitoring system. This compact system provides 58 in
high quality wireless foldback with full freedom of movement and can also be used for wireless audio
transmission to active speakers in a PA system. Please read this manual before using this equipment
to avoid damage through incorrect operation and to get the best performance from this equipment .
Contents:
Please take care when unpacking this product. Inspect for any damage and ensure you have the
following com ponents…
• Miniature Rechargeable 5.8GHz transmitter
• Miniature Rechargeable 5.8GHz receiver
• Stereo in-ear monitoring headphones
• USB A to C charging lead
Warning
To prevent the risk of damage to the equipment, do not expose any of the components to rain or
moisture.
If liquids are spilled on any component, stop using immediately, allow unit to dry out and have
checked by qualified personnel before further use.
Avoid impact or heavy vibration to any of the components or over-stretching of the cables.
No user serviceable parts inside transmitter or receiver - refer servicing to qualified service
personnel.
Safety
• Ensure that the transmitter and ceiver are charged using a standard 5V USB charger with 1A re
minimum output.
• Avoid ingress of water or particles into the transmitter or receiver
• Do not attempt to replace the internal batteries
Placement
• Ensure good line- -sight contact between transmitter and receiver for best reception of
• Keep all components out of direct sunlight and away from heat sources.
• Do not place heavy objects on top of the receiver or transmitt er
Cleaning
• Use a soft cloth with a neutral detergent to clean the body of th transmitter and/or receiver. e
• To avoid damage, do not use solvents to clean the components
• Sterile wipes may be used on the supplied earphones be sure to avoid ingress of fluids into the –
apertures
171.899UK and 171.900UK User Manual
Transmitter d Receiver an
Setting up
Th IEM58 has been designed with simplicity in mind and requires minimum effort to set up. e
There is just an illuminated button, USB-C charging port and 3.5mm stereo jack on each unit.
It is advised to charge the transmitter and receiver fully (2 hours each) from USB before first use.
Connect a andard 5Vdc USB charger to the USB-C connector on each unit for recharging. st
The push button wi light solid green when charging ( or blue/green if the unit is switched on) ll …
Th green light will go out when charging is complete. e
Connect a stereo line level signal to the transmitter via the 3.5mm stereo jack on top.
This can be the headphones output, aux out or monitor out from a mixing console.
Note: i may be necessary to use leads or adaptors that convert the mixer output connections to t a
3.5mm stereo plug for the ansmitter. tr
Connect the supplie -ear headphones (or other 32 type) to the 3.5mm jack the receiver. d in Ωon
This tput could also be used as a line in t for an active speaker or mixing console if required. ou pu
Th transmitter and receiver may already be paired with each other when bought as a set. e
Additional receivers (171.899UK) may be bought for multi-listen applications. er
The pairing procedure between transmitter and receiver is mentioned further below.
Th push button on each unit should be pressed and hel for 3 seconds, which will cause the push e d
button to flash blue. When both transmitter and receiver are flashing blue, they will connect if they
are already paired and the push buttons will change from flashing to solid blue.
When this happens, the transmitter will sending audio wirelessly to the receiver. be
Pres ng the button on the transmitter or receiver for 5 seconds will cause the push button to flash si
blue and green at the same time. This is now in pairing mode and removes any evious pairing pr
setting. When a transmitter and receiver are flashing blue and green together, they will pair
automatically, and the LED will change to continuous blue when paired and connected.


Product specificaties

Merk: Chord
Categorie: Hoofdtelefoon
Model: IEM58

Heb je hulp nodig?

Als je hulp nodig hebt met Chord IEM58 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Hoofdtelefoon Chord

Handleiding Hoofdtelefoon

Nieuwste handleidingen voor Hoofdtelefoon