Chief SSB860 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Chief SSB860 (1 pagina's) in de categorie Projector accessoire. Deze handleiding was nuttig voor 38 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-000007 Rev01
©2009 Milestone AV Technologies,
a Duchossois Group Company
05/09
SSB-860, SSM-860, SLB-860 and SLM-860 Interface Brackets
SSB-860, SSM-860, SLB-860 and SLM-860 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface bracket.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Raise the front adjustable feet and place interface bracket on the projector. Ensure the front slots in the bracket are around the adjustable
feet and the two front mounting holes in the bracket align with the two mounting inserts in the bottom front of the projector.
4. Attach the interface bracket using the three 4 x 10mm mounting screws and # 4 washers. Tighten the two front adjustable feet against the
projector.
5. Attach the U-Form bracket around the projector and through the holes in the interface bracket using the two #10 flat washers and 10 x 24
Nylock nuts.
6. Tighten all fasteners at this time securing interface bracket to projector.
NOTE: Felt squares are provided to protect projector shell, if desired. They can be attached to the projector or wrapped around the
U-Form rod. Security screws can be substituted when mounting interface bracket to projector by using the parts and
installation instructions in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (4) Felt Squares
(4) 10 - 24 Thumb Nuts** (2) #10 Flat Washers
(1) All-Points Security Kit (2) 10 x 24 Nylock Nuts
(1) U-Form Bracket (3) #4 Flat Washers
(3) M4 x 10mm Screws
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
interface bracket installation.
Towards front of
projector Towards front of
projector
SLB-860
SLM-860
(Note: SSM-style interface bracket connections
a
r
e
e
n
c
i
r
c
l
e
d
)
(Note: SSB-style interface bracket connections
a
r
e
e
r
c
l
d
)


Product specificaties

Merk: Chief
Categorie: Projector accessoire
Model: SSB860

Heb je hulp nodig?

Als je hulp nodig hebt met Chief SSB860 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Projector accessoire Chief

Chief

Chief SLM248 Handleiding

18 November 2024
Chief

Chief SLM251 Handleiding

17 November 2024
Chief

Chief SLM255 Handleiding

17 November 2024
Chief

Chief SLM293 Handleiding

17 November 2024
Chief

Chief SLM3000 Handleiding

17 November 2024
Chief

Chief RPMAU Handleiding

17 November 2024
Chief

Chief SLM230 Handleiding

17 November 2024
Chief

Chief WM2I Handleiding

17 November 2024
Chief

Chief RSMD311 Handleiding

17 November 2024
Chief

Chief RPMA368 Handleiding

14 November 2024

Handleiding Projector accessoire

Nieuwste handleidingen voor Projector accessoire