Chief SSB007 Handleiding

Chief Projector accessoire SSB007

Lees hieronder de 📖 handleiding in het Nederlandse voor Chief SSB007 (1 pagina's) in de categorie Projector accessoire. Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/1

I N S T A L L A T I O N I N S T R U C T I O N S

Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes

no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use

of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or

implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.

Chief Manufacturing, a products division of Milestone AV Technologies

8401 Eagle Creek Parkway, Savage, MN 55378

• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918

8802-000074 Rev01

a Duchossois Group Company

05/09

SSB-007, SSM-007, SLB-007 and SLM-007 Interface Brackets

SSB-007, SSM-007, SLB-007 and SLM-007 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific

installation instructions provided with the mount for additional installation information.

Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.

WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE

TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!

**Only used when installing SLB/SSB interface bracket.

NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the encircled

locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style interface bracket

installation.

Installation Instructions

WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE

TO EQUIPMENT! DO NOT over tighten screws when installing Interface bracket.

NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.

1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.

2. Turn projector upside down.

3. Remove the rear black hard plastic foot from the projector using a small flat screw driver and pry it up from the projector housing. This foot is held

on by two-face tape.

4. Remove the screw under the black plastic foot.

5. Remove the rear adjustable foot from the projector.

6. Remove the two small screws in the front of the bottom of the projector housing.

7. Place the four 3/8” nylon spacers over the four threaded inserts in the bottom of the projector over each screw hole previously removed.

8. Place the interface bracket onto the four ½” nylon spacers on the bottom of the projector and align the four mounting holes in the bracket with the

four nylon spacers.