Chief SLM275 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Chief SLM275 (1 pagina's) in de categorie Projector accessoire. Deze handleiding was nuttig voor 23 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-002072 Rev00
©2010 Milestone AV Technologies,
a Duchossois Group Company
11/10
SSB-275, SSM-275, SLB-275 and SLM-275 Interface Brackets
SSB-275, SSM-275, SLB-275 and SLM-275 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the interface bracket onto the bottom of the projector, aligning the mounting holes in the bracket with the threaded inserts in the
bottom of the projector and ensuring that triangle in bracket points towards front of projector.
4. Position M6 x 10mm mounting screws with M6 flat washers into the threaded inserts and three bracket side tabs. Position 1/2" tall spacer
underneath threaded insert and mounting hole at front of interface bracket. Place the M6 x 20mm screw into the threaded insert and
mounting hole at front of interface bracket and through 1/2" spacer. Tighten all fasteners at this time, securing the bracket to the projector.
NOTE: Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation
instructions in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (3) Screw, Phillips Pan Head, Machine, M6 x 10mm
(4) 10-24 Thumb Nuts ** (1) Screw, Phillips Flat Head, Machine, M6 x 20mm
(3) Washer, M6
(1) All-Points Security Kit (1) 5/32" Hex Key
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation: All appropriate screws come pre-installed in the circled locations above.
DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style interface bracket installation.
Note: SSB-style interface bracket connections are circled. Note: SSM-style interface bracket connections are circled.
SLB-275 SLM-275
Towards front
of projector
Towards front
of projector
(1) Nylon Spacer, 1/2" x .316" x 1/2"


Product specificaties

Merk: Chief
Categorie: Projector accessoire
Model: SLM275
Kleur van het product: Zwart
Gewicht verpakking: 2000 g
Aantal per verpakking: 1 stuk(s)

Heb je hulp nodig?

Als je hulp nodig hebt met Chief SLM275 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Projector accessoire Chief

Chief

Chief SLM248 Handleiding

18 November 2024
Chief

Chief SLM251 Handleiding

17 November 2024
Chief

Chief SLM255 Handleiding

17 November 2024
Chief

Chief SLM293 Handleiding

17 November 2024
Chief

Chief SLM3000 Handleiding

17 November 2024
Chief

Chief RPMAU Handleiding

17 November 2024
Chief

Chief SLM230 Handleiding

17 November 2024
Chief

Chief WM2I Handleiding

17 November 2024
Chief

Chief RSMD311 Handleiding

17 November 2024
Chief

Chief RPMA368 Handleiding

14 November 2024

Handleiding Projector accessoire

Nieuwste handleidingen voor Projector accessoire