Celestron NexImage 5 Handleiding

Celestron Fotocamera NexImage 5

Lees hieronder de 📖 handleiding in het Nederlandse voor Celestron NexImage 5 (12 pagina's) in de categorie Fotocamera. Deze handleiding was nuttig voor 59 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/12

USERS MANUAL

Model #93711

English

Congratulations on your purchase of the Celestron NexImage 5 Solar System imaging camera.

Your NexImage camera comes with the following:

+ NexImage 5 Camera

+ 1.25” nose piece

+ CD including NexImage iCap and RegiStax processing software

+ USB Cable

Recommended Minimum System requirements:

+ Pentium IV, 2.0 GHz, 1GB RAM

+ Graphics card with 24 or 32 bit

+ Windows XP, Windows Vista, Windows 7 (32 & 64 bit)

+ DirectX 9.0c or higher

1.25”

Nose Piece USB CableNexImage 5 Camera

NexImage iCap and

Registax processing

software

Fig 1

Quick start

1. Place the CD into your computer’s CD rom drive.

2. Install both the NexImage iCap and RegiStax software

onto your computer.

3. Thread the 1.25” nose piece into the body of the

NexImage camera. see Fig 2.

4. Slide the 1.25” nose piece of the camera into the eyepiece barrel of your telescope. .see Fig 3

5. Plug the small end of the USB cable into the port on the back of the camera.

6. Plug camera into the USB port of your computer. Once connected, the Found New Hardware

message will appear. Follow the Installation Wizard until the device has been successfully installed.

Fig 2

Fig 3

Product specificaties

Merk:	Celestron
Categorie:	Fotocamera
Model:	NexImage 5
Gebruikershandleiding:	Ja
Type verpakking:	Doos
Meegeleverde kabels:	USB
Type camerasluiter:	Elektronisch
Cameraresolutie:	2592 x 1944 Pixels
Grootte van de beeldsensor ( B x H ):	5.7 x 4.28 mm