CaterCool 682004 Handleiding


Lees hieronder de πŸ“– handleiding in het Nederlandse voor CaterCool 682004 (7 pagina's) in de categorie Koelkast. Deze handleiding was nuttig voor 51 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/7
682001-02-03-04-10 en ma 2012 1
USER’S MANUAL
Attention: before removing the packaging of your refrigerator carefully read the operation
instructions in this user’s guide (possible damages due to a failure in following these
instructions are not considered in the warranty).
Profession al uppl iesS
COUNTER TOP REFRIGERATORS
Modelnr.: *682.001 - *682.002 - *682.003
*682.004 - *682.010
682001-02-03-04-10 en ma 2012 2
PACKAGING.
Despite the care the manufacturer always puts when packing their refrigerators to ensure that no damage
occurs during the transport, it may happen that the carrier delivers a parcel visibly damaged. In this case
the customer is required to notify details of any damage on the transportation document of the carrier in
order to put in a complaint if the merchandise is damaged. In case of doubt do not use the refrigerator and
refer to qualifi ed personnel for any tests.
Once pulled out the refrigerator please keep the packaging in a dry place in order to reuse it in case
the machine must be returned to the manufacturer for any eventually. We will not respond to damages of
refrigerators returned into packaging different from the original one.
INSTALLATION.
– After removing the refrigerator from its packaging, leave it in a horizontal position for at least
30 minutes.
– The refrigerator must be installed on a fl at surface but can be raised of about 5 cm in its back side to
allow a better access to the basins.
– In the meantime check the basins correspond to those chosen ordered with the refrigerator.
– Check the switch is on the OFF position (0) and the electrical data indicated on the plate are compatible
with the electric power source.
– Make sure the installation area on which the refrigerator will be placed is protected and quite far from
the heating rays originating from ovens.
– Make sure the inlet - outlet air grills are not obstructed in order to allow a correct and natural air
recycling: We advise to leave a space of 10 cm at least.
– An anomalous installation not in accordance to the above-mentioned instructions affects both the correct
operation of the refrigerator and its life-time and annul your warranty.
– Connect the plug to the electrical system ensuring that the latter is in compliance with the Laws in force
(differential circuit-breaker, earthing connection, etc.). Please remember that a faulty power source could
irreparably damage some components of your refrigerator and as well as invalidating the warranty.
– Generally we advise against the utilization of adapters, multiple plates and/or extensions. Otherwise use
only fi ttings in conformity with the safety rules in force. Do not modify the power cord supplied.
– Do not connect the refrigerator to the electrical system with wet hands and/or bare feet.
– Do not unplug by pulling on the cord.
– Do not allow children and / or unable to use the refrigerator without supervision
– However avoid your refrigerator suffers strokes or sudden movements that could compromise its life-time
and its operation. NOTE: A properly cleaning of the basins is strictly necessary before putting food into
them.
START UP.
– To start-up your refrigerator press the GREEN BUTTON by putting it on β€œON” (1) and control the
compressor starts up within 60 seconds.
– If you haven’t already inserted the basins into the refrigerator please cover the basins holder with a
cardboard to prevent cold air dispersion.
– After a time variable among 90 and 120 minutes the refrigerator reaches the factory pre-set
temperature of 4Β°C.
– To modify this temperature read the instructions of the control unit (paragraph SET POINT SETTINGS):
normally you have to press the SET button, by means of the UP and DOWN buttons temperature will
change and pressing SET again new data will saved.
– Food must be place into basins only when the machine reaches the proper temperature because this
type of refrigerator maintains the temperature because it is not a blast chiller.
– We advise the basins never be fi lled more than 80% of their capacity and keep them closed with their
lid as much as possible. Thus the food will be better preserved.
682001-02-03-04-10 en ma 2012 3
USE AND MAITENANCE.
It is very important to dedicate a short time for the maintenance of your refrigerator in order to maintain it
in perfect effi ciency and for a long life-time,
– Every week clean the air fi lter placed inlet the fan of the refrigerator to avoid the infi ltration of
fl our, dust, grease, oil, etc.
– The air fi lter removal is easy and does not need particular tools: just a little pressure on the two sides of
the safety grid occurs to lift it, then remove the fi lter
– For a proper cleaning it is necessary to immerse the fi lter in warm water added with detergent,
rinse it and wipe with a cloth, If the fi lter is only covered with dust an air blow is suffi cient to clean it.
– Before replace it in its site control it is not damage or unusable: in this case you have to replace it with
a new one of the same type and thickness (the manufacturer always provides some spare parts).
– Regularly clean the refrigerator (once a week at least) using a sponge and warm water: it is strictly
forbidden to use pointed or cutting metal objects, solvents or aggressive chemicals.
– Sure before cleaning your refrigerator disconnect the plug from the wiring and wait a few minutes in
order to permit the melting of the frost on the inner walls.
IT IS STRICTLY FORNIDDEN AND EXTREMELY DANGEROUS
to throw water or sprinklings on the electrical circuits (fan, suction grids, switch, thermostat, etc.)
OPERATION PROBLEMS AND SOLUTIONS.
(1) THE REFRIGERATOR DOES NOT TURN ON
SOLUTIONS:
– First check the socket is connected and the plug supplies current regularly
– If the refrigerator does not turn on again, (green light off) check the power cable is not damage and if
so, only a technician can replace it.
(2) THE REFRIGERATOR DOES NOT COOL OR IT DOES NOT REACH THE PRE-SET TEMPERATURE
SOLUTIONS:
– Check the thermostat is on and set on the right temperature so that lower than that of the environment,
on the display of the control unit check the operating LED is on and the compressor is on work
(you should hear the noise of the motor)
After fi ve working minutes control the condenser (aluminium exchanger placed laterally behind
the perforated grid) exhales an hot airfl ow from its upper side. If not, it could be a problem on the
compressor or a lack of gas from the refrigerant circuit or the fan is blocked so you have to
contact a technician.
– Control the condenser is dirty or obstructed: in that case clean it using a jet of compressed air.
– Control that the room temperature is not over 40Β°C.
(3) THE CONTROL UNIT GOES INTO ALARM
– If the control unit beeps it means the maximum required time to allow the refrigerator reaches the set
temperature is over.
SOLUTIONS:
– Carry out the same controls mentioned in point (2).
– If the display shows blink characters please contact the after-sale service.
(4) THE CONTROL UNIT SHOWS A FAILURE (ERR)
SOLUTIONS:
– It means the probe of the thermostat doesn’t work properly and you must replaced it.
Contact the after-sale service.


Product specificaties

Merk: CaterCool
Categorie: Koelkast
Model: 682004

Heb je hulp nodig?

Als je hulp nodig hebt met CaterCool 682004 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Koelkast CaterCool

Handleiding Koelkast

Nieuwste handleidingen voor Koelkast