Cardinal Detecto MCS-20P Handleiding

Cardinal Detecto Keukenweegschaal MCS-20P

Lees hieronder de 📖 handleiding in het Nederlandse voor Cardinal Detecto MCS-20P (4 pagina's) in de categorie Keukenweegschaal. Deze handleiding was nuttig voor 53 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

SCS30

Solar Powered

Hanging Scale

Operation Manual

CARDINAL SCALE MFG. CO.

8551-0967-0M Rev A PO BOX 151



WEBB CITY, MO 64870

12/14 PH

(

417

)

673-4631



FAX

(

417

)

673-5001

www.detectoscale.com

Technical Support: Ph: 866-254-8261 techsupport@cardet.com 

8551-0967-0M Rev A  SCS30 Operation

SPECIFICATIONS

Power: Solar Cell (min. 400 LUX)

Operating Temperature: 32 to 104º F (0 to 40 º C)

Display: Five digit, seven segment, 1.0 inch (25 mm) high LCD

Annunciators: lb, kg, 



 



 (Zero), (Solar Charge Status)

Capacity: 30lb x 0.02 lb (15kg x 0.01kg)

UNPACKING

Before beginning installation of your scale, make certain it has been received in good

condition. When removing the scale from its packing, inspect it for signs of damage, such as

exterior dents and scratches. Keep the carton and packing material for return shipment if it

should become necessary. It is the responsibility of the purchaser to file all claims for any

damages or loss incurred during transit. You should have the following items:

(1) SCS30 Scale

(2) S-Hooks

(1) Bow Assembly

(1) Ring Assembly

(2) Pan Bow Nuts

(2) Wing Nut 5/16-18

(1) Pan

SETUP

1. Insure that the light available is adequate to power

the scale (typically an average lighted room is 400

LUX. This is adequate to power the scale.

NOTE: Make sure nothing is shading the solar cell

from the available light. Low lighting will result in the

scale display showing Lo

LoLo.

2. Referring to Figure No. 1, install S-Hook on top loop

of scale.

3. Hang scale from a support that is strong enough to

support the scale PLUS the weight of the item to be

weighed.

4. Follow the Hanging Assembly instructions to

compete the required assembly.

5. The scale has been calibrated with the enclosed

hanging assembly. In order to display zero, the

hanging assembly must be attached.

6. Scale is now ready to use.

WARNING! Failure to attach the scale to a support of sufficient strength

using a connector to hold the scale PLUS the weight of the item to be

weighed can result in the scale coming loose and damaging the scale

and/or injuring the operator and persons nearby.

Figure No. 1

8551-0967-0M Rev A  SCS30 Operation

HANGING ASSEMBLY

The SCS30 is shipped with a bow and pan

hanging assembly. The hanging assembly is

made up of four (4) main components.

S-Hook

Bow

Ring and bow attachment hardware (Pan Bow

Nuts and 5/16-18 Wing Nuts)

Pan

Assemble the hanging assembly as illustrated in

Figure No. 2. The hanging assembly is then

attached to the lower loop on the scale. Place

pan in Ring.

OPERATION

1. Hang scale from a secure position with

minimum 400 LUX lighting level. Make sure

nothing is shading the solar cell from the

available light.

2. Referring to Figure No. 3, press Zero Button

to zero scale.

3. To change between units (lb to kg or kg to lb),

press and hold Zero Button for approximately

5 seconds.

4. Place item to be weighed in pan.

5. Display will show weight of item.

6. Remove product and press Zero Button if

required before weighing next item.

DO’S AND DON’TS

 DO hang scale from a support that is strong enough to support the weight of the scale

PLUS the weight of the material to be weighed. The more rigid the support the better.

 DO ensure that the scale is not shaded from the available light.

 DO avoid shock loading the scale, i.e. do not drop heavy loads in the pan.

 DO check the hanging assembly wing nuts on a regular basis to ensure they are tight.

 DO check on a regular basis the scale’s supporting hardware to ensure that it continues

to provide the strength necessary to support the weight of the scale PLUS the item to be

weighed.

 DO NOT spray; water directly on the scale.

 DO clean scale using a damp, soft cloth and mild detergent.

 DO NOT use acetone, alcohol, or other volatile solvents for cleaning.

Zero

Button

Figure No. 2

S-Hook

Bow

Rin

Pan

Figure No. 3

Pan Bow Nut

5/16-18 Win

Nut

Product specificaties

Merk:	Cardinal Detecto
Categorie:	Keukenweegschaal
Model:	MCS-20P

Heb je hulp nodig?

Als je hulp nodig hebt met Cardinal Detecto MCS-20P stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Keukenweegschaal Cardinal Detecto

Cardinal Detecto AP-6 Handleiding

17 November 2024

Cardinal Detecto PZ60W Handleiding

26 Augustus 2023

Cardinal Detecto PZ30W Handleiding

26 Augustus 2023

Cardinal Detecto HSDC-20 Handleiding

9 Augustus 2023

Cardinal Detecto HSDC-500 Handleiding

9 Augustus 2023

Cardinal Detecto HSDC-100 Handleiding

9 Augustus 2023

Cardinal Detecto HSDC-40KG Handleiding

9 Augustus 2023

Cardinal Detecto MCS-20P Handleiding

8 Augustus 2023

Cardinal Detecto HSDC-40 Handleiding

8 Augustus 2023

Cardinal Detecto HSDC-100KG Handleiding

8 Augustus 2023

Handleiding Keukenweegschaal

Nieuwste handleidingen voor Keukenweegschaal

Catler KS 4020 Handleiding

15 December 2024

Vivax KS-505P Handleiding

14 December 2024

Create Balance Food Eco Handleiding

11 December 2024

Girmi PS05 Handleiding

10 December 2024

Girmi PS04 Handleiding

10 December 2024

Ardes AR1PA4WW Handleiding

10 December 2024

Pyrex SB-720 Handleiding

9 December 2024

Rosti Mensura Handleiding

5 December 2024

Smeg KSF01 Handleiding

5 December 2024

Blaupunkt FKS701 Handleiding

4 December 2024