Caliber RCD110 Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor Caliber RCD110 (17 pagina's) in de categorie Autoradio. Deze handleiding was nuttig voor 27 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/17
CAR CD/MP3 PLAYER / RDS RECEIVER
WITH
USB INTERFACE, SD INTERFACE
AUX USB
IN T
2 65
RD M
4
RP T
3
OP EN
M EN U
MO D E
ID3
DI S P
1
BA N D
PS
PT Y
AS
M UT E
1. PANEL RELEASE BUTTON
2. ENCODER VOLUME KNOB
3. SYSTEM MENU BUTTON
4. PRESET MEMORY BUTTONS
5. ENCODER TUNING UP/ DOWN & TRACK UP / DOWN BUTTON
6. POWER / MUTE BUTTON
7. MODE BUTTON
8. BAND/ BUTTON / PTY BUTTON
9. AUTOMATICALLY STORE / PRESET SCAN (AS/PS) BUTTON
10. DISPLAY BUTTON / MP3/ID3 INFORMATION BUTTON
11. RADIO SIGNAL STREGTH METER
12. EJECT BUTTON
13.CD SLOT
14. USB COVER / FLIP OPEN TO ACCESS TO USB SOCKET
15. AUX-IN JACK ON FRONT PANEL
2
13 56
715
10 9
814
11
4
13 12
E - 1
1. HANDLING COMPACT DISCS
MOISTURE CONDENSATION
NOTES ON CDs
P. 2
P. 3
P. 4
P. 1
P. 5
P. 6
P. 7
1.
2.
3.
4.
5.
NOTES ON DISCS
There are paste residue.
Ink is sticky (P.5).
Stickers that are beginning
to peel away, leaving a
sticky residue (P.6).
Labels are attached (P.7).
On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should
this occur, the unit will not operate properly. In such a case, remove the disc and wait for about an
hour until the moisture has evaporated.
A dirty or defective disc may cause sound
dropouts while playing. To enjoy optimum
sound, handle the disc as follows.
Handle the disc by its edge. To keep the
disc clean, do not touch the surface (P.1).
If you use the discs explained below, the
sticky residue can cause the CD to stop
spinning and may cause malfunction or
ruin your discs.
Do not use second-hand or rental CDs
that have a sticky residue on the surface
(for example, from peeled-off stickers or
from ink, or glue leaking from under the
stickers).
Do not stick paper or tape on the disc (P.2).
Before playing, clean the discs with an
optional cleaning cloth. Wipe each disc from
the centre out (P.4).
Do not use solvents such as benzine,
thinner,commercially available cleaners, or
antistatic spray intended for analog discs.
Do not expose the discs to direct sunlight or
heat sources such as hot air-ducts, or leave
them in a car parked in direct sunlight where
there can be a considerable rise in
temperature inside the car (P.3).
Do not use rental CDs with old labels that
are beginning to peel off.
Do not use your CDs with labels or
stickers attached.
**************
*******
*******
*******
*******
*******
*******
*******
*******
****
*******
*******
*******
*******
Do Not Use Special Shape CDs
Be sure to use round shape CDs only for
this unit and do not use any special shape
CDs. Use of special shape CDs may
cause the unit to malfunction.(P.8).
Be sure to use CDs with disc mark
Only for this unit.
RECORDABLE REWRITABLE
P. 8
CD-Rs and CD-RWs which have not
undergone finalization processing cannot
be played. (For more information on
finalization processing, refer to the manual
for your CD-R/CD-RW writing software or
CD-R/CD-RW recorder.) Additionally,
depending on the recording status, it may
prove impossible to play certain CDs
record on CD-R or CD-RW.
2. INSTALLATION
30°
DIN FRONT/REAR-MOUNT
- DIN FRONT-MOUNT (Method A)
Installation the unit
1. Dashboard
2. Half Sleeve
3. Screw
1
7
4
23
5
61. Dashboard
2. Nut (5mm)
3. Spring washer
4. Screw (5x12+5x4mm)
5. Screw
6. Support Strap
7. Plain washer
182
53
12
E - 2
Before finally installing the unit, connect the wiring temporarily and make sure it is all
connected up properly and the unit and system work properly.
Use only the parts included with the unit to ensure proper installation. The use of
unauthorized parts can cause malfunctions.
Consult with your nearest dealer if installation requires the drilling of holes or other
modifications of the vehicle.
Install the unit where it does not get in the driver's way and cannot injure the passenger if
there is a sudden stop, like an emergency stop.
If installation angle exceeds 30° from horizontal, the unit might not give its optimum
performance.
Avoid installing the unit where it would be subject to high temperature, such as from direct
sunlight, or from hot air, from heater, or where it would be subject to dust dirt or excessive
vibration.
Be sure to remove the front panel before installing the unit.
This unit can be property installed either from “Front” (conventional DIN Front-mount) or
“Rear”(DIN Rear-mount installation, utilizing threaded screw holes at the sides of the unit
chassis). For details, refer to the following illustrated installation methods A and B.
34
4. Remove the two screws that fix the CD
deck mechanism player before
mounting the unit.
After inserting the half sleeve into the
dashboard, select the appropriate tab
according to the thickness of the
dashboard material and bend them
inwards to secure the holder in place.
Be sure to use the support strap to
secure the back of the unit in place. The
strap can be bent by hand to the desired
angle.


Product specificaties

Merk: Caliber
Categorie: Autoradio
Model: RCD110
Kleur van het product: Grijs
Ingebouwd display: Ja
Bluetooth: Ja
GeĂŻntegreerde geheugenkaartlezer: Ja
Compatibele geheugenkaarten: SD
Audio-uitgangskanalen: 4.0 kanalen
MP3 afspelen: Ja
ID3 Tag weergave: Ja
AUX ingang: Ja
Ondersteunde frequentiebanden: AM, FM
Inclusief RDS tuner: Ja
USB direct afspelen: Ja
CD-R afspelen: Ja
CD-RW afspelen: Ja
Type beeldscherm: LED
Maximaal vermogen per kanaal: 75 W
Line outputs (RCA): 1

Heb je hulp nodig?

Als je hulp nodig hebt met Caliber RCD110 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Autoradio Caliber

Handleiding Autoradio

Nieuwste handleidingen voor Autoradio