Byron SX-60I Handleiding
Lees hieronder de š handleiding in het Nederlandse voor Byron SX-60I (1 pagina's) in de categorie Deurbel. Deze handleiding was nuttig voor 29 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/1
CR2032 3V
Lithium Battery
Remove
Isolation
Strip
Push Button
ā¢ Open up the push button by pushing in the tab on the
bottom of the push with a small flat screwdriver.
ā¢ Remove the isolation strip from the battery
compartment then it is ready to use.
ā¢ When replacing the battery, ensure the battery polarity
matches the internal markings (ā+ā facing upwards),
then press the battery down so that it is sitting firmly in
its compartment.
Victorian Bell
Insert 4 x 1.5volt alkaline batteries (āCā, UM2 & LR14
- not included) into the battery compartment at the back
of the Bell unit, ensuring the battery polarity matches the
internal markings.
IMPORTANT: NOT TO BE USED WITH A TRANSFORMER
Push Button Installation
ā¢ Using the holes on the back of push button as a
template, mark the fixing position for the unit.
ā¢ Drill holes and fit wall plugs and secure the push button
unit to the wall with screws.
ā¢ Do not mount it on any metal surface or UPVC door
frame.
Door Chime Installation
ā¢ Drill two holes, fit a wall plugs and screws.
ā¢ Leave a gap of 3mm between the screw head and wall.
ā¢ Locate the keyhole slots on the back of the chime unit
over the screws.
Operation
ā¢ Press the button on the Push Button unit once, it sends
a wireless signal to the Bell unit, the Bell unit will sound.
ā¢ Operate the Bell unit within the operation range, test it
before final installation.
Digital Code Set Up
ā¢ Press the Push Button once, a new operation code is
generated randomly and sent to the Chime unit.
ā¢ The Bell unit will sound to indicate that a new operation
code is registered and memorised.
Wire Free Victorian Bell Kit SX-60i
Wire Free Victorian Bell Kit SX-60i
100m
1 2 3 4
5 6
Push Button unit
Power: 1 x 3volt Lithium battery (CR2032 - included)
Door Chime unit
Power: 4 x 1.5volt alkaline batteries (āCā, UM2 & R14 - not included)
Door Chime Operation
Press the button on the Push Button once, it sends a wireless signal to the Victorian Bell unit and it
will sound. For repeat sound, press the button again. Hold the button in will repeat the sound.NOT
Digital Code Set Up
The Victorian Bell kit is equipped with an advanced random and self-learning operation coding
ability therefore no setting is needed. Read the following instructions before use.
1. First time operation:
After battery installation on the Push Button and Victorian Bell units, press the Push Button once
and it will generate a new operation code randomly and send a wireless signal to the Victorian
Bell unit. The Bell unit will sound to indicate that a new operation code is registered and
memorised.
2. Interference from a similar unit operating nearby:
a) Simply remove the batteries from the Push Button and Victorian Bell units and rest for 10
seconds, this will erase the memory.
b) Insert the batteries into the Push Button and Victorian Bell units. Press the Push Button once,
it will generate a new operation code randomly and send a wireless signal to the Victorian Bell
and it will sound to indicate that a new operation code is registered and memorised.
3. Front and back door Push Button operation:
a) Remove the batteries from the Push Buttons (Front & Back Door) and Victorian Bell units and
rest for 10 seconds, this will erase the memory.
b) Insert the batteries into the Push Buttons and Victorian Bell units. Press the front door Push
Button once, it will generate a new operation code randomly and send a wireless signal to the
Victorian Bell unit and it will sound to indicate that a new operation code is registered and
memorised.
c) After, (within 2 minutes) press the back door Push Button once, it will generate a new
operation code randomly and send a wireless signal to the Victorian Bell unit and it will sound
to indicate that a new operation code is registered and memorised. The Victorian Bell unit has
the ability to memorise both operation codes.
d) Test to ensure correct operation before final installation.
Important
1. Do not mount either unit close to fireplace or expose to high temperatures.
2. Do not expose the Victorian Bell unit to direct sunlight or moisture
3. Always use alkaline battery. Please dispose of old, defective batteries in an environmentally
friendly manner in accordance with the relevant legislation.
4. Make sure that no naked flame sources, such as lighted candles, should be placed on the unit.
5. The unit should not be exposed to dripping or splashing and no objects filled with liquids, such
as vases, should be placed on the unit.
Byron No.SX60i Size: A4 Date: 15 Oct 2007
6. Replace only with the same or equivalent type of battery that is recommended by the CAUTION:
manufacturer.
7. Make sure batteries are installed correctly as per the internal markings.CAUTION:
8. Danger of explosion if battery is incorrectly installed or replaced.CAUTION:
9. IMPORTANT: There are no serviceable parts in the units, do not attempt to repair it.
User Hints
If the Bell unit does not sound, please check the following:
a) Flat batteries in either Push Button or Victorian Bell units - change the batteries.
b) Wrong battery polarity in either Push Button or Victorian Bell units - re-insert the batteries.
c) Push Button and Victorian Bell units are not on the same operation codes - re-set the code (see
digital code set up).
d) Units are out of range - Operate the Victorian Bell unit within the operation range.
Specification
Operating Temperature: -10C - +40C
Operating Distance: 100metre (330ft approx. - in open field & at suitable condition)
Selectable Digital Code: Total two hundred fifty six (256) possible digital codes
āType R2 Device - device where the sound output is created by the initial operation of the control
and where the period of sound output continues for the designed duration irrespective of condition
of the control.ā
Important:
ā¢ Make sure new set of alkaline battery is used in first
time operation.
ā¢ Make sure the batteries are installed properly and
the battery polarities match the internal markings.
ā¢ Change the frequency digital codes if door chime
activate intermittently for no reason at all (see
digital set up).
ā¢ Do not use the Chime unit with transformer
433MHz
R&TTE
APPROVED
CH Byron Electrical United Kingdom. www.chbyron.com
CH Byron Electrical Ltd
Byron House
34 Sherwood Rd, Astonfield
Bromsgrove, B60 3DR
UK
Tel: 0845 2301231
e: support@chbyron.com
w: www.chbyron.com
āCā / LR14ā āCā / LR14ā
āCā / LR14ā
āCā / LR14ā
3mm
Product specificaties
| Merk: | Byron |
| Categorie: | Deurbel |
| Model: | SX-60I |
Heb je hulp nodig?
Als je hulp nodig hebt met Byron SX-60I stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Deurbel Byron
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
Handleiding Deurbel
- Deurbel Philips
- Deurbel Panasonic
- Deurbel Fysic
- Deurbel Grundig
- Deurbel Honeywell
- Deurbel Inventum
- Deurbel Quigg
- Deurbel Acti
- Deurbel Alecto
- Deurbel Arendo
- Deurbel Axis
- Deurbel Balay
- Deurbel Baseline
- Deurbel Beafon
- Deurbel Belkin
- Deurbel Bellman
- Deurbel Bitron Video
- Deurbel Delta
- Deurbel Denver
- Deurbel Desa
- Deurbel DIO
- Deurbel Doorsafe
- Deurbel Doro
- Deurbel Ebench
- Deurbel Eken
- Deurbel Elektrobock
- Deurbel Elro
- Deurbel Envivo
- Deurbel Eufy
- Deurbel Ezviz
- Deurbel Fagor
- Deurbel Foscam
- Deurbel Friedland
- Deurbel Geemarc
- Deurbel GeoVision
- Deurbel Gira
- Deurbel GlobalTronics
- Deurbel Grothe
- Deurbel Hama
- Deurbel Hauck
- Deurbel Heidemann
- Deurbel Hikvision
- Deurbel HQ
- Deurbel Intersteel
- Deurbel KlikaanKlikuit
- Deurbel Kogan
- Deurbel Konig
- Deurbel Kruidvat
- Deurbel Lifetec
- Deurbel Lorex
- Deurbel LSC SmartConnect (Action)
- Deurbel Marquant
- Deurbel ME
- Deurbel Melinera
- Deurbel Mercury
- Deurbel Merlin
- Deurbel Mr Safe
- Deurbel Nedis
- Deurbel Nest
- Deurbel Netatmo
- Deurbel Perel
- Deurbel Plieger
- Deurbel Profile
- Deurbel Renkforce
- Deurbel Ring
- Deurbel SecuFirst
- Deurbel Sencor
- Deurbel Silvercrest
- Deurbel Sinji
- Deurbel SkyBell
- Deurbel Smart
- Deurbel Smartwares
- Deurbel Somfy
- Deurbel Swissvoice
- Deurbel Toa
- Deurbel Tronic
- Deurbel Trust
- Deurbel Ubiquiti
- Deurbel Unitec
- Deurbel Urmet
- Deurbel V-Tac
- Deurbel Velleman
- Deurbel Zmodo
- Deurbel Jacob Jensen
- Deurbel Olympia
- Deurbel Orbegozo
- Deurbel Caliber
- Deurbel Exibel
- Deurbel Steren
- Deurbel DoorBird
- Deurbel Aspes
- Deurbel EMOS
- Deurbel Infiniton
- Deurbel Arlo
- Deurbel Avidsen
- Deurbel Imou
- Deurbel Techly
- Deurbel Extel
- Deurbel M-e
- Deurbel NuTone
- Deurbel REV
- Deurbel Oricom
- Deurbel Cata
- Deurbel Chacon
- Deurbel ACE
- Deurbel Nexa
- Deurbel Swann
- Deurbel Milectric
- Deurbel Apelson
- Deurbel Hombli
- Deurbel Reolink
- Deurbel Fanvil
- Deurbel EQ3
- Deurbel X-Sense
- Deurbel ORNO
- Deurbel Brilliant
- Deurbel Bell4U
- Deurbel Vimar
- Deurbel Legrand
- Deurbel Intertechno
- Deurbel EKO
- Deurbel Pentatech
- Deurbel ZAMEL
- Deurbel AVANTEK
- Deurbel Vibell
- Deurbel ALC
- Deurbel Middle Atlantic
- Deurbel Bearware
Nieuwste handleidingen voor Deurbel
20 November 2024
18 November 2024
16 November 2024
16 November 2024
16 November 2024
16 November 2024
16 November 2024
16 November 2024
15 November 2024
12 November 2024