Byron DIC-23112 Handleiding

Byron Deurbel DIC-23112

Lees hieronder de 📖 handleiding in het Nederlandse voor Byron DIC-23112 (23 pagina's) in de categorie Deurbel. Deze handleiding was nuttig voor 32 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/23
DIC-23112
MANUAL
Installation
We recommend for the Wi Fi doorbell to be set up indoors and tested before final fitting.- -
Please follow the steps included in this guide to get the product up and running.
Doorbell setup
To use the recording feature, it is recommended to install the SD card before installation. This can be
done later but will involve removing and -re fitting some cables.
1. Remove the 3x securing screws located on the back of the doorbell and also remove the
rubber seal.
2. Slide the doorbell up and out of the aluminium case.
3. On the side of the doorbell is the SD card slot. Remove the rubber seal and insert the SD
card, then push the rubber seal back into place.
4. Slide the doorbell back into its aluminium case and replace the 3x securing screws.
5. Push the power cable through the hole of the rubber seal.
6. Connect the power cable to the V+ and connections at the back of the doorbell. V-
7. terminal. Connect the red wire to the V+ terminal. Connect the black wire to the V-
Don’t replace rubber seal yet. Plug in the power supply and connect it to the power cable, then
switch the socket on.
8. After around 30 seconds, the red and green LED’s will begin to light up on the back
9. of the doorbell. If this does not happen, please ensure the power cable and the power supply
are all connected correctly and the plug socket is turned on. Push the rubber seal back into
place


Product specificaties

Merk: Byron
Categorie: Deurbel
Model: DIC-23112

Heb je hulp nodig?

Als je hulp nodig hebt met Byron DIC-23112 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Deurbel Byron

Handleiding Deurbel

Nieuwste handleidingen voor Deurbel