Byron DB305USB Handleiding

Byron Deurbel DB305USB

Lees hieronder de πŸ“– handleiding in het Nederlandse voor Byron DB305USB (2 pagina's) in de categorie Deurbel. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
ON
ON
QuickStart
β„’
Wirefree plug-in door chime kit
75
DB305USB Instructions
Insert the Plug-in Chime into a standard
230-240V ~50Hz wall socket and switch the
socket ON, chime will ring.
Insert the 23A battery (Supplied) into the
battery holder, making sure the
Positive/Negative terminals match the internal
markings. ATTENTION:
Avoid positioning the Bell Push/Chime on or
directly near metallic surfaces as this may reduce
the operation range.
UPVC Door Frames:
When positioning the bell push onto a UPVC door,
always check the operating performance before
final installation, internal metal frame of the door
may affect performance.
Tip: Try adjusting the location of the Bell Push
slightly to the Left/Right or place on an external
wall.
Note: the appliance is not to be used by children
or persons with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge unless they have been given
supervision or instruction. Children should be
supervised to ensure that they do not play with
the appliance.
TROUBLE SHOOTING.
In case of the door chime does not sound, please
check the followings:
a) Flat batteries in either push button or door
chime.
b) Wrong battery polarity in either push button or
door chime.
c) For plug-in door chimes make sure the socket is
switched on.
d) Bell push and door chime are not paired
together, see setup guide.
e) Materials in between the bell push & chime will
reduce the operating range, move the door
chime closer to the bell push
f) Wire free devices can be affected by external
sources e.g. wirefree home alarms or power
transformers/adapter.
Type R2 Device - device where the sound output is
created by the initial operation of the control and
where the period of sound output continues for
the designed duration irrespective of condition of
the control.
IMPORTANT:
There are no serviceable parts, do not repair. The
appliance is not to be used by children or persons
with reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge,unless they have been given
supervision or instruction. Children should be
supervised to ensure that they do not play with
the appliance.
433.92MHz
R&TTE
APPROVED
CH Byron Electrical United Kingdom. www.chbyron.com
A
B
DK
FIN
F
D
GR
LT
IRL
I
L
NL
P
E
S
UK
BG
CZ
EST
H
IS
LV
M
N
SK
SLO
CH
PL
RO
A
B
DK
FIN
F
D
GR
IRL
I
L
NL
P
E
S
SK
PL
β„’
CH Byron (Electrical) Ltd
Byron House,
34, Sherwood Rd,
Aston Fields,
Bromsgrove
B60 3DR
UK
www.chbyron.eu/byronsupport
Tel: 0845 2301231 (UK)
10-4 Mon-Fri, Local call charges apply
support:
SPECIFICATION:
Bell Push: DBT
Power: 1 x 23A Battery
(Included)
IP44 Weather Resistant
Plug in Door Chime:
DB305USB
Power: 230 - 240V 50Hz
Stanby power: <0.5W.
Rated charging current:
500Ma, 1A MAX, Voltage
5VΒ±0.3V
Range: 75 Metres
Indoor Use Only
GETTING STARTED...
Using a small flat screwdriver, insert into the
locking clip and gently twist. The back plate will
unclip from the Bell Push.
Press the Bell Push within 30 seconds, the
chime will ring to confirm that the Bell Push has
been paired to the Chime.
MELODY SELECTION:
To select a new melody for the door chime.
Press the melody select button on the
(side) of the chime unit (M).
The chime will play the newly selected melody.
Press again to select the next melody
NOT WORKING....TRY A FACTORY RESET
Press and hold the learn button (L) until the
chime plays a melody – approximately 10
seconds.
Now Press the learn button (L) on the back of
the Portable Chime quickly (DO NOT HOLD
DOWN) to enter the Learn mode. The chime
will ring to confirm.
POSITIONING YOUR CHIME:
Test the Chime in the intended location, as
internal walls and surfaces may reduce
operating range. DO NOT mount onto metallic
surfaces.
1
2
3
4
Press the Bell Push within 30 seconds, the
chime will ring to confirm that the Bell Push
has been paired to the chime.
WALL MOUNTING YOUR BELL PUSH.
Using back plate as template.
Make sure UP arrow points UP.
Mark and drill holes.
Insert wall plugs and attach to wall using screws
provided.
Clip the Bell Push on to the back plate making
sure the Bell Push β€˜Clicks’ in to place.
Place the Door Chime, within the operating range
(50M). Transmission of the wire free signal
through walls, doors and ceilings etc, may reduce
the operating range.
10
8
USB CHARGER:
The USB connection is convenient for recharging
devices that can be connected by USB eg:
smartphones, MP3 players and tablets etc...
9
7
6
5
CHANGING PUSH BATTERY.
Remove back plate from the Bell Push
Remove old battery from the holder
Replace with new β€˜23A’ battery
Insert the 23A battery into the battery
holder, making sure the Positive/Negative
terminals match the internal markings.
Test Chime Kit
10
9
10
1 2
3
4
1 metre
8
8
5
10 seconds 1 second
1
6
1 metre
7
ON
2
ON
ON
USB
Device
melody
learn


Product specificaties

Merk: Byron
Categorie: Deurbel
Model: DB305USB

Heb je hulp nodig?

Als je hulp nodig hebt met Byron DB305USB stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Deurbel Byron

Handleiding Deurbel

Nieuwste handleidingen voor Deurbel