Bushman DC85-X Handleiding

Bushman Vriezer DC85-X

Lees hieronder de 📖 handleiding in het Nederlandse voor Bushman DC85-X (12 pagina's) in de categorie Vriezer. Deze handleiding was nuttig voor 2 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
User Manual &
Operating Instructions
DC-X Fridges
CARAVAN RV – – MARINE - OFFGRID
Congratulations on Bushman DCyour purchase of a -X Please read fridge. these instructions carefully
before installation use. and
Please be safe and use common sense and caution when installing, operating and cleaning this appliance. If you are
unsure about any of these instructions, contact your local before proceeding.stockist
IMPORTANT INFORMATION
Do not lay your fridge on its back, top If your fridge has been incorrectly or sides or at any angle exceeding 30º.
handled, ensure that the fridge is placed in a level upright position for 12 hours to allow the internal fluids to
redistribute evenly.
Never operate your fridge directly from a 240 V or AC power . supply
Do not use a modified sine wave inverter to operate your fridge.
PRIOR TO INSTALLATION
DELIVERY
At delivery, please check that the fridge is complete and is not damaged in any way. Remove all packaging and
securing tapes from the fridge. To avoid injury and causing damage to the appliance, be extremely cautious when
using sharp or pointed tools to complete this task.
Do not connect an appliance that has been damaged, contact your local dealer immediately.
INSTALLATION
Installation of the DC fridges must be completed by a suitably trained professional only.-X range of
POWER SUPPLY
Your fridge V V must be connected to a stable and regulated 12 or 24 DC power supply only. The compressor will
automatically detect which voltage is present adjust accordingly.
If you are using a generator or other power supply, the output must be a pure sine wave. Any fluctuations in
generator current may damage the compressor.
WIRING
For optimum results, you will need the correct sized wire depending on the distance from your power supply to the
fridge. Wiring must be to your directly from your fridge battery and should be continuous without joins. Please also
e a nsure the earth is wired directly to your battery, not to chasse. If your sufficientwiring is in , your fridge may not
perform correctly or may be even be damaged.
CROSS SECTION
IN MM2
MAXIMUM LENGTH OF WIRE IN METRES
12 V
24 V
2.5
2.5
6
4
4
8
6
6
12
10
10
20
Any switches must have a breaking load not less than 20 A on 12 V or 10 A on 24 V.
The power supply wiring must also be protected with a 15 A fuse.
Ensure sure the wiring polarity is correct. Connect the red wire to the positive terminal (+) and the black wire to the
negative terminal (- ).
Never connect bare electric wires. Use only connections of a size suitable for the cross section of the wire being
used.
INSTALLATION IN TO A CAVITY
DC-X fridges are designed to be installed in a . A gap of cavity minimum mm is recommended for the rear. 40 Refer to
the following table for the recommended If you are using the mounting kit, allow an extra 5mm - cut out dimensions.
width for the mounting kit frame and screws.
MODEL
CUT- OUT CAVITY DIMENSIONS (MM)
WIDTH
DEPTH
HEIGHT
DC50-X
3 85
495
530
DC65-X
4 55
515
530
DC85-X
480
550
630
DC130-X
530
550
7 55
EFFICIENT OPERATION
VENTILATION
Ventilation will have a significant impact on the efficient operation of your fridge. A minimum of 2 vents need to be
provided from the rear of the fridge cavity to the outside environment, or to the general area where the fridge is
located. The vents should be located at the bottom and top of the fridge cavity and have a free cross section of
minimum 200cm2 each. By providing free air flow to the compressor area your cooling system will remove heat
faster and the fridge will operate more efficiently.
MOUNTING KIT
The mounting kit is first affixed to the side and top of the fridge cabinet using the screws provided.
Once the fridge has been connected to the power supply and moved into its final position, the mounting kit can be
affixed to the front of the cavity.
OPERATING THE FRIDGE
THERMOSTAT
• Turn the thermostat knob around from 0 to power up the fridge.
• The cooling level can be set between 1 and 7.
• 7 is the coldest setting and 1 is the warmest.
EQUALISING THE FRIDGE
During the first 24 hours of operation, your compressor will operate for longer than usual. This process allows the
internal air temperature, food, drinks, condenser and insulation to equalise.
ENERGY SAVING TIPS
• Have a much venti the more the better.lation as possible –
• Keep the fridge out of direct sunlight whenever possible
• Only open the fridge or freezer door when necessary
• Allow hot food to cool down before placing inside the fridge
• Defrost the fridge as soon as a layer of ice forms
• Set the fridge to be only as cold as necessary
USING THE FRIDGE IN EXTREME HEAT
If you are using your fridge in a very hot area or situation, removing the drip tray will improve cold air circulation
throughout the fridge cabinet. the Note - DC130 X models do not have a drip tray.


Product specificaties

Merk: Bushman
Categorie: Vriezer
Model: DC85-X

Heb je hulp nodig?

Als je hulp nodig hebt met Bushman DC85-X stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Vriezer Bushman

Handleiding Vriezer

Nieuwste handleidingen voor Vriezer