Burley Bee 2004-2006 Handleiding

Burley Diversen Bee 2004-2006

Lees hieronder de 📖 handleiding in het Nederlandse voor Burley Bee 2004-2006 (24 pagina's) in de categorie Diversen. Deze handleiding was nuttig voor 27 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/24
Contents
Section Page
Introduction 2
I. Hardware Bag Contents & Tool List 3
II. Mounting the Re ectors 3
III. Attaching the Wheels 4
IV. Unfolding & Folding Your Burley Bee 5
V. Using the Seat Harness 8
VI. Hitching the Burley Bee to Your Bicycle 11
VII. Trailer Maintenance and Care 12
VIII. Safety Guidelines 13
IX. Safety Checklists 19
X. Parts List & Drawing 22
Warranty 24
Bee
Owner’s Instruction and Safety Manual
2
Burley Bee Owner’s Instruction and Safety Manual
Congratulations!
You’ve just pur chased a Burley® trailer, the lead ing choice of dis crim i nat ing bi cy cle
trailer own ers world wide. Every ef fort has been made to ensure your pur chase is of
top quality and proven design, ready to provide you with many years and thou sands
of miles of happy, safe trailering.
IMPORTANT: Because some of the features and guidelines for
using the Burley Bee merit close attention, it is very im por tant
that you fa mil iar ize yourself with the trailer by reading this
manual all the way through before use. If you have any ques-
tions, we encourage you to contact your Burley dealer.
Introduction
This manual is written sequentially to assist initial assembly. Your Burley Bee is
shipped 95% factory-as sem bled. You need only to mount the refl ectors, install the
tongue, attach the wheels, side panels, roll bar and safety fl ag, and snap the cover
into place. Once you’ve read the safety guidelines, you’re ready to go. Initial as sem bly
should take 10-15 minutes. Sub se quent setting up and folding can eas i ly be done in
a couple of minutes, no tools re quired.
Before trailering, be sure you have a thor ough understanding of the safety harness
and of trailer hitch operation. Practice folding and un fold ing your trailer; it can easily
be done in less than a minute, no tools required. Check to see that the trailer wheels
and hitch are securely at tached. We again request that you read this manual from
start to fi nish before use, referring to it as necessary in the future.
NOTE: Any reference to left or right is made in the direction of
travel, as if you were sitting in the child seat looking forward.
When Loaning or Selling Your Trailer
If you loan or sell your Burley Bee, supply the new user with this manual. They must
familiarize them selves with all sec tions—especially sections VIII. Safety Guidelines”
and “IX. Safety Check lists” prior to use. It is es sen tial that they understand the differ-
ences between riding a bicycle with a trailer and without one. It is also essential that
they understand correct wheel at tach ment, setup, folding, and use of the har ness,
safety fl ag, cover, and hitch. Always ensure that both adult and child are wear ing
helmets. Never loan your trailer if it is need of maintenance or repair.
3
Burley Bee Owner’s Instruction and Safety Manual
I. Hardware Bag Contents and Tool List
IMPORTANT: Please verify that you have received all of the
con tents listed. Do not pro ceed with as sem bly if any parts are
missing; contact Bur ley im me di ate ly for replacement parts.
Hardware Bag Contents
(2) large red refl ectors
(2) hex head refl ector screws
(2) 1” plastic refl ector brackets
(1) 5 x 10 plastic bag
Envelope
Burley Checklist
Warranty Card
Burley Bee Owner’s Instruction & Safety Manual
II. Mounting the Re ectors
The red refl ectors install onto the rear of the main frame tube of the trailer on the
right and left sides. The main frame tubes run along either side of the trailer bottom
frame.
1. The bracket (A) mounts as shown on the
section of the main frame tube that extends
behind the trailer (B). Tighten the clamp onto
the tube so that the two holes used to mount
the refl ector are horizontal.
2. Screw the refl ector (C) onto the bracket as
shown.
3. The lower screw on the refl ector bracket
is used to adjust the angle of the refl ector.
Adjust the angle of the refl ector to ensure
that the back face is oriented vertically to the
ground, so that the refl ector points directly
back when the trailer is attached to the bike.
4. Repeat for the other side of the trailer.
A
B
C
Tools Required
Phillips screwdriver
9/16" socket and torque wrench
Flat blade screwdriver


Product specificaties

Merk: Burley
Categorie: Diversen
Model: Bee 2004-2006

Heb je hulp nodig?

Als je hulp nodig hebt met Burley Bee 2004-2006 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Diversen Burley

Handleiding Diversen

Nieuwste handleidingen voor Diversen