Buderus Logamax plus GB142-45 Handleiding

Buderus CV Ketel Logamax plus GB142-45

Lees hieronder de 📖 handleiding in het Nederlandse voor Buderus Logamax plus GB142-45 (100 pagina's) in de categorie CV Ketel. Deze handleiding was nuttig voor 189 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/100
Please read thoroughly before installing and servicing
7212 9700 – 12/2004 US/CA(EN) For registered installers
Installation and Servicing instructions
Condensing gas heater
Logamax plus GB142-24/30/45/60
CAUTION!
Before putting the appliance into operation read this manual carefully.
WARNING!
Improper installation, adjustment, alteration, service or maintenance
can cause injury, loss of life or property damage. Refer to this manual.
For assistance or additional information consult a qualified installer,
service agency or the gas supplier.
CAUTION!
The operating manual is part of the documentation that is delivered to
the installation's operator. Go through the information in this manual
with the owner/operator and make sure that he or she is familiar with
all the necessary operating instructions.
Notice:
This manual must be retained for future reference.
–Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
– What to do if you smell gas
•Do not try to light any appliance
•Do not touch any electrical switch; do not use any phone in
your building.
•Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
– Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
Warning: If the information in these instructions is
not followed exactly, a fire or explosion may result
causing property damage, personal injury or death.
2
We reserve the right to make any changes due to technical modifications!
Installation and Servicing instructions Logamax plus GB142-24/30/45/60 • Version 12/2004
Buderus Hydronic Systems • http://www.buderus.net
Preface
About these instructions
These Installation and Servicing Instructions contain
important information for the safe and professional
installation, start-up and maintenance of the appliance
with appliance capacities 24, 30, 45 and 60 kW.
These Installation and Servicing Instructions are
intended for specialist installers, who have the neces-
sary training and experience for working on heating and
gas systems.
Subject to technical changes!
Slight changes may be made to the illustrations, process
steps and technical data as a result of our policy of
continuous improvement.
Updating of documentation
Please contact us if you have any suggestions for
improvements or corrections.
Contents
3
We reserve the right to make any changes due to technical modifications!
Installation and Servicing Instructions Logamax plus GB142-24/30/45/60 • Version 12/2004
Buderus Hydronic Systems • http://www.buderus.net
1 Safety and general instructions . . . . . . . . . . 5
1.1 Designated use . . . . . . . . . . . . . . . . . . . . . . . . 5
1.2 Hazard definitions . . . . . . . . . . . . . . . . . . . . . . 5
1.3 The following instructions must be observed . . 5
1.4 Observe these instructions for heating
system water . . . . . . . . . . . . . . . . . . . . . . . . . . 6
1.5 Tools, materials and additional equipment . . . 6
1.6 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
2 Regulations and guidelines . . . . . . . . . . . . . 7
3 Product description . . . . . . . . . . . . . . . . . . . . 8
4 Dimensions and connections . . . . . . . . . . . . 9
5 Packaging and transportation . . . . . . . . . . 11
5.1 Scope of delivery . . . . . . . . . . . . . . . . . . . . . . 11
5.2 Transporting the appliance . . . . . . . . . . . . . . 11
6 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . 12
6.1 Requirements for the installation room . . . . . 12
6.2 Fitting the appliance. . . . . . . . . . . . . . . . . . . . 12
6.3 Making the gas connection . . . . . . . . . . . . . . 13
6.4 Fitting the heating circuit supply and
return pipes . . . . . . . . . . . . . . . . . . . . . . . . . . 14
6.5 Combustion Air and Ventilation Openings . . . 17
6.6 Installation of the flue gas adapter
(included in the scope of delivery) . . . . . . . . . 18
6.7 Installation of the Exhaust and
Air Intake system. . . . . . . . . . . . . . . . . . . . . . 18
7 Connecting the condensate water drain . . 23
8 Electrical connections. . . . . . . . . . . . . . . . . 24
8.1 External connection board connections . . . . .24
9 Start-up procedure. . . . . . . . . . . . . . . . . . . . 27
9.1 Testing for gas leaks . . . . . . . . . . . . . . . . . . . 28
9.2 Filling the appliance . . . . . . . . . . . . . . . . . . . . 28
9.3 Filling the condensate trap. . . . . . . . . . . . . . . 29
9.4 Venting the gas supply valve . . . . . . . . . . . . . 29
9.5 Checking the combustion air/flue gas
connection . . . . . . . . . . . . . . . . . . . . . . . . . . . 30
9.6 Checking the orrifices . . . . . . . . . . . . . . . . . . 30
9.7 Inlet gas pressure . . . . . . . . . . . . . . . . . . . . . 30
9.8 Checking and adjusting the gas/air ratio . . . . 31
9.9 Carrying out a tightness test in operating
conditions. . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
9.10 Measuring the carbon monoxide
content (CO) . . . . . . . . . . . . . . . . . . . . . . . . . 33
9.11 Function testing . . . . . . . . . . . . . . . . . . . . . . . 33
9.12 Measuring the ionization current . . . . . . . . . . 33
9.13 Installing the casing . . . . . . . . . . . . . . . . . . . . 35
9.14 Informing the owner, handing over the
technical documents . . . . . . . . . . . . . . . . . . . 35
10 BC10 basic controller . . . . . . . . . . . . . . . . . 36
10.1 Operating the BC10 basic controller . . . . . . . 36
10.1.1 Switching the heating system on and off . . . . 36
10.1.2 Displaying the operating conditions of
the burner and resetting the burner or
resetting burner faults . . . . . . . . . . . . . . . . . . 36
10.1.3 Displaying the heating system status
and/or faults. . . . . . . . . . . . . . . . . . . . . . . . . . 37
10.2 Carrying out additional tasks . . . . . . . . . . . . . 39
10.2.1 Carrying out a flue gas test . . . . . . . . . . . . . . 39
10.2.2 Selecting partial load operation
(e. g. during flue gas testing). . . . . . . . . . . . . 39
10.2.3 Switching the heating system to
manual mode. . . . . . . . . . . . . . . . . . . . . . . . . 39
10.3 Configuring the appliance . . . . . . . . . . . . . . . 40
10.3.1 Adjusting the heating capacity. . . . . . . . . . . . 40
10.3.2 Setting the DHW temperature value . . . . . . . 41
10.3.3 Entering the heater water temperature . . . . . 41
10.3.4 Setting the pump post-purge period . . . . . . . 41
11 Shutting down the system . . . . . . . . . . . . . 43
11.1 Shut down the heating system using
the control unit . . . . . . . . . . . . . . . . . . . . . . . . 43
11.2 Shutting down the heating system
in the event of an emergency . . . . . . . . . . . . 43
12 Inspection . . . . . . . . . . . . . . . . . . . . . . . . . . 44
12.1 Preparing the appliance for inspection . . . . . 44
12.2 Visual inspection for general signs of
corrosion . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
12.3 Internal tightness testing . . . . . . . . . . . . . . . . 45
12.4 Measuring the ionization current . . . . . . . . . . 45
12.5 Measuring the inlet gas pressure . . . . . . . . . 45
12.6 Checking and adjusting the gas/air ratio . . . . 45
12.7 Carrying out a gas tightness test in
operating conditions . . . . . . . . . . . . . . . . . . . 45
12.8 Measuring the carbon monoxide
content (CO) . . . . . . . . . . . . . . . . . . . . . . . . . 45
12.9 Carrying out a pressure test of the
heating system . . . . . . . . . . . . . . . . . . . . . . . 45
12.10 Checking the functioning and the safety
of the air intake and flue gas conduit. . . . . . . 45
12.11 Checking venting systems. . . . . . . . . . . . . . . 45
13 Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . 46
13.1 Cleaning the heat exchanger, burner
and condensate trap . . . . . . . . . . . . . . . . . . . 46
13.2 Checking and adjusting the gas/air-ratio . . . . 48
14 Servicing . . . . . . . . . . . . . . . . . . . . . . . . . . . 49
14.1 Checking the UBA3 fuse;
replace if necessary . . . . . . . . . . . . . . . . . . . 49
14.2 External connection board fuse . . . . . . . . . . . 49
14.3 Checking the fan unit; 120 VAC control . . . . 50
14.4 Checking the fan unit;
Supply cord (120 VAC) . . . . . . . . . . . . . . . . . 51
14.5 Checking the fan unit; Tacho cable . . . . . . . . 52
14.6 Replacing the fan unit . . . . . . . . . . . . . . . . . . 52
14.7 Checking the supply/return/safety/
hot-water temperature sensors . . . . . . . . . . . 53
14.8 Replacing the supply/return/safety sensors . 54
14.9 Checking the supply/return/
safety sensors cable . . . . . . . . . . . . . . . . . . . 55
14.10 Checking the hot surface ignitor; Control . . . 56
14.11 Checking the hot surface ignitor; resistance . 57


Product specificaties

Merk: Buderus
Categorie: CV Ketel
Model: Logamax plus GB142-45

Heb je hulp nodig?

Als je hulp nodig hebt met Buderus Logamax plus GB142-45 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding CV Ketel Buderus

Handleiding CV Ketel

Nieuwste handleidingen voor CV Ketel