BSS Audio Soundweb 9008 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor BSS Audio Soundweb 9008 (15 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 4 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/15
Installation Guide
Soundweb
TM
2
9008 Installation Guide
Regulatory Information
An example of this equipment has been tested and found to comply with the following
European and international Standards for Electromagnetic Compatibility and Electrical
Safety:
Emissions (EU): EN55013 (1990)
Generic Immunity (EU): EN50082-1 (1997)
Electrical Safety (EU): EN60065+A11 (1993)
Electrical Safety (USA): UL6500/ETL (1996)
Electrical Safety (CAN): CAN/CSA-E65/ETLc (1994)
Radiated Emissions (USA): FCC parts 15 Class B
For continued compliance with international EMC regulations, it is important that all
cables be screened, and connected as follows:
 Audio cable screens to their 9008 connector ground.
 Control cable screens to the ground screws adjacent to the connector.
Network cables should be of type CAT. 5
IMPORTANT SAFETY INFORMATION
Do not remove covers.
No user serviceable parts inside - refer servicing to qualified service personnel.
This equipment must be earthed.
It should not be necessary to remove any protective earth or signal cable shield
connections to prevent ground loops. Any such disconnections are outside the
recommended practice of BSS Audio and will render the EMC or safety certification
void.
Mechanical Installation
If the unit is likely to undergo extreme vibration through extensive road trucking and
touring, it must be supported at the rear and/or sides to lessen the stress on the front
mounting flange. Use either a ready-built rack tray or mount the 9008 unit between other
units. Damage caused by insufficient support is not covered by the warranty.
To prevent cosmetic damage to the front panel finish, use protective plastic cups under
the rack mounting bolts.
Soundweb
TM
9008 Installation Guide
3
Front Panel LED Functions
DSP Clip
Illuminated = indicates that the processed signal is clipping internally.
Network
Sync
Steady = indicates the presence of one or more valid network connections.
Flashing = there is a problem with the incoming network signal - check connections and/
or possibly the maximum cable length has been exceeded.
Activity
Flashing Yellow = indicates data transfer. The flashing is not regular, but dependent on
the rate of transfer.
Flashing Red = indicates bad data and is usually caused by network faults. Check
network connections, see Rear Panel details.
Power
Illuminated = indicates that the power supply is functioning.
Flashing = the network is initialising. If the led continues to flash for
more than a few seconds, there is a cabling fault - either a double ring
error or a problem with one of the cable connectors.
Steady = this unit has become the clockmaster for the network.
Off = this unit is clienting to an external master clock.


Product specificaties

Merk: BSS Audio
Categorie: Niet gecategoriseerd
Model: Soundweb 9008

Heb je hulp nodig?

Als je hulp nodig hebt met BSS Audio Soundweb 9008 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd BSS Audio

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd