Broan Ultra Pro RB110 Handleiding

Broan Ventilator Ultra Pro RB110

Lees hieronder de 📖 handleiding in het Nederlandse voor Broan Ultra Pro RB110 (15 pagina's) in de categorie Ventilator. Deze handleiding was nuttig voor 2 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/15
RB80 n RB110
ULTRA ProTM | Ventilation Fan
with ULTRAQuickTM Installation Technology
INSTALLATION GUIDE
READ AND SAVE
THESE INSTRUCTIONS
Installer: leave this guide with homeowner.
Register your product online at www.broan.com/register.
Easy installation in both
new construction and retrofit
Table of Contents
Warnings and Cautions 2
Typical Installation 2
New Construction Installation 3
Retrofit Installation 7
Operation 12
Cleaning and Maintenance 12
Troubleshooting 12
Service Parts 13
Warranty 13
© 2014 Broan-NuTone LLC
RB80 n
RB110 Installation GuidePage 2
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer at the address
or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a
qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction codes and
standards.
4. Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent backdrafting. Follow the heating equipment
manufacturer’s guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration and
Air Conditioning Engineers (ASHRAE), and the local code
authorities.
5. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. If this unit is to be installed over a tub or shower, it must be
marked as appropriate for the application and be connected
to a GFCI (Ground Fault Circuit Interrupter) - protected branch
circuit.
8. Use an ON/OFF switch, timer, or speed control to operate this
ventilator. Use of speed control other than the Broan 78V and
78W may cause a motor humming noise.
9. This unit must be grounded.
Typical Installation
CAUTION
1. For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
2. This product is designed for installation in ceilings up to a
12/12 pitch (45 degree angle). Duct connector must point up.
DO NOT MOUNT THIS PRODUCT IN A WALL.
3. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off power
unit.
4. Please read specification label on product for further
information and requirements.
45° 45°
• Installation is the same for:
• Fits in 2" x 8" ceiling construction.
• Infinitely adjust the fan position
between joists from 14" to 24"
on center.
*Purchase
separately.
INSULATION*
(Place around and
over Fan Housing.)
ROOF CAP*
(with built-in
damper)
FAN
HOUSING
POWER
CABLE*
4-IN. ROUND
DUCT*
ROUND
ELBOWS*
Seal gaps
around
Housing.
Seal duct
joints with
tape.
OR
Keep duct
runs short.
WALL CAP*
(with built-in
damper)
NOT FOR USE IN A COOKING AREA
Do not install above or inside this area
Floor
Cooking
Equipment
Joists I-Joists Trusses
The ducting from this fan to the outside of the building has a strong effect on the air flow, noise and en-
ergy use of the fan. Use the shortest, straighest duct routing possible for best performance, and avoid
installing the fan with smaller ducts than recommended. Insulation around the ducts can reduce en-
ergy loss and inhibit mold growth. Fans installed with existing ducts may not achieve their rated airflow.
RB80 n
RB110 Installation GuidePage 3
1
2
3
4
Parts Bag holds
Knockout Plate
and six (6)
screws
Remove
Instruction
Sheet
Punch out Mask from
packaging. See Step 6.
New Construction Installation
Tools needed
• Power screwdriver with a Phillips bit
• Phillips screwdriver
• Flathead screwdriver
• Pliers
• Wire insulation stripper
• Wire cutter
Materials needed
• 4" round metal ducting recommended for best performance.
Use of other ducting is acceptable but may impact performance.
• Roof cap or wall cap (built-in damper recommended)
• Tape to seal duct connections
• Electrical wiring and supplies per local code requirements
1 Remove Packaging
2 Install
Mounting
Frame

Product specificaties

Merk: Broan
Categorie: Ventilator
Model: Ultra Pro RB110

Heb je hulp nodig?

Als je hulp nodig hebt met Broan Ultra Pro RB110 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Ventilator Broan

Broan

Broan Ultra Pro RB110L1 Handleiding

3 April 2025
Broan

Broan QTXE080FLT Handleiding

1 April 2025
Broan

Broan EC60KIT Handleiding

1 April 2025
Broan

Broan QT130E Handleiding

1 April 2025
Broan

Broan QTXE150C Handleiding

1 April 2025
Broan

Broan QT130LE Handleiding

1 April 2025
Broan

Broan InVent AER90C Handleiding

1 April 2025
Broan

Broan QT140LE Handleiding

1 April 2025
Broan

Broan L400L Handleiding

1 April 2025
Broan

Broan QTXE080 Handleiding

1 April 2025

Handleiding Ventilator

Nieuwste handleidingen voor Ventilator

Innoliving

Innoliving INN-531 Handleiding

8 April 2025
Innoliving

Innoliving INN-532 Handleiding

8 April 2025
Innoliving

Innoliving INN-533 Handleiding

8 April 2025
Ryobi

Ryobi RY40HF02 Handleiding

2 April 2025
DeepCool

DeepCool FT12-3 Handleiding

1 April 2025
PAX

PAX TSC 13 Handleiding

31 Maart 2025
Honeywell

Honeywell Quietset Slim Mini HTF210 Handleiding

31 Maart 2025
Honeywell

Honeywell QuietSet 5 HYF260 Handleiding

31 Maart 2025
Fantini Cosmi

Fantini Cosmi ASPIRKAPPA Handleiding

31 Maart 2025
Vornado

Vornado Strata 8T Handleiding

31 Maart 2025