Broan QTXE150C Handleiding

Broan Ventilator QTXE150C

Lees hieronder de 📖 handleiding in het Nederlandse voor Broan QTXE150C (4 pagina's) in de categorie Ventilator. Deze handleiding was nuttig voor 2 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Page 1
VENTILATION FAN MODEL QTXE150C
READ AND SAVE
THESE INSTRUCTIONS
Register your
product online at:
www.broan.ca
WARRANTY
Installer: Leave this manual with
the homeowner.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer. If you
have questions, contact the manufacturer at the address or telephone
number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service panel
and lock the service disconnecting means to prevent power from
being switched on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning device, such
as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction codes and standards.
4. Sufficient air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to
prevent backdrafting. Follow the heating equipment manufacturer’s
guideline and safety standards such as those published by the
National Fire Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
5. When cutting or drilling into wall or ceiling, do not damage electrical
wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. Acceptable for use over a tub or shower when connected to a GFCI
(Ground Fault Circuit Interrupter) - protected branch circuit (ceiling
installation only).
8. This unit must be grounded.
9. When applicable local regulations comprise more restrictive installation
and/or certification requirements, the aforementioned requirements
prevail on those of this document and the installer agrees to conform
to these at his own expenses.
10. When performing installation, servicing or cleaning this unit, it is
recommended to wear safety glasses and gloves.
CAUTION
!
1. For general ventilating use only. Do not use to exhaust hazardous or
explosive materials and vapors.
2. This product is designed for installation in ceilings up to a 12/12 pitch
(45 degree angle). Duct connector must point up. DO NOT MOUNT THIS
PRODUCT IN A WALL.
3. To avoid motor bearing damage and noisy and/or unbalanced impellers,
keep drywall spray, construction dust, etc. off power unit.
4. Please read specification label on product for further information and
requirements.
OPERATION
CLEANING & MAINTENANCE
For quiet and efficient operation, long life, and attractive appearance -
lower or remove grille and vacuum interior of unit with the dusting brush
attachment.
The motor is permanently lubricated and never needs oiling. If the motor
bearings are making excessive or unusual noises, replace the blower
assembly (includes motor and impeller).
Use an on/off switch to operate this ventilator. See “Connect Wiring” for
details.
Limited Warranty
Warranty Period and Exclusions: Broan-NuTone Canada (the “Company”) warrants to the original
consumer purchaser of its product (“you”) that the product (the “Product”) will be free from
material defects in the Product or its workmanship for a period of three (3) years from the date of
original purchase.
The limited warranty period for any replacement parts provided by the Company and for any Products
repaired or replaced under this limited warranty shall be the remainder of the original warranty period.
This warranty does not cover speed controls, fluorescent lamp starters, tubes, halogen and incandescent
bulbs, fuses, filters, ducts, roof caps, wall caps and other accessories for ducting that may be
purchased separately and installed with the Product. This warranty also does not cover (a)normal
maintenance and service, (b)normal wear and tear, (c)any Products or parts which have been subject
to misuse, abuse, abnormal usage, negligence, accident, improper or insufficient maintenance, storage
or repair (other than repair by the Company), (d)damage caused by faulty installation, or installation
or use contrary to recommendations or instructions, (e)any Product that has been moved from its
original point of installation, (f)damage caused by environmental or natural elements, (g)damage
in transit, (h)natural wear of finish, (i)Products in commercial or nonresidential use, or (j)damage
caused by fire, flood or other act of God. This warranty covers only Products sold to original consumers
in the Canada by the Company or Canadian distributors authorized by the Company.
This warranty supersedes all prior warranties and is not transferable from the original consumer
purchaser.
No Other Warranties: This Limited Warranty contains the Company’s sole obligation and your
sole remedy for defective products. The foregoing warranties are exclusive and in lieu of any other
warranties, express or implied. THE COMPANY DISCLAIMS AND EXCLUDES ALL OTHER EXPRESS
WARRANTIES, AND DISCLAIMS AND EXCLUDES ALL WARRANTIES IMPLIED BY LAW, INCLUDING
WITHOUT LIMITATION THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
To the extent that applicable law prohibits the exclusion of implied warranties, the duration of any
applicable implied warranty is limited to the period specified for the express warranty above. Some
states do not allow limitations on how long an implied warranty lasts, so the above limitation may
not apply to you. Any oral or written description of the Product is for the sole purpose of identifying
it and shall not be construed as an express warranty.
Whenever possible, each provision of this Limited Warranty shall be interpreted in such manner as to
be effective and valid under applicable law, but if any provision is held to be prohibited or invalid, such
provision shall be ineffective only to the extent of such prohibition or invalidity, without invalidating
the remainder of such provision or the other remaining provisions of the Limited Warranty.
Remedy: During the applicable limited warranty period, the Company will, at its option, provide
replacement parts for, or repair or replace, without charge, any Product or part thereof, to the extent
the Company finds it to be covered by and in breach of this limited warranty under normal use and
service. The Company will ship the repaired or replaced Product or replacement parts to you at no
charge. You are responsible for all costs for removal, reinstallation and shipping, insurance or other
freight charges incurred in the shipment of the Product or part to the Company. If you must send the
Product or part to the Company, as instructed by the Company, you must properly pack the Product
or part—the Company is not responsible for damage in transit. The Company reserves the right to
utilize reconditioned, refurbished, repaired or remanufactured Products or parts in the warranty repair
or replacement process. Such Products and parts will be comparable in function and performance
to an original Product or part and warranted for the remainder of the original warranty period.
Exclusion of Damages: THE COMPANY’S OBLIGATION TO PROVIDE REPLACEMENT PARTS, OR
REPAIR OR REPLACE, AT THE COMPANY’S OPTION, SHALL BE YOUR SOLE AND EXCLUSIVE REM-
EDY UNDER THIS LIMITED WARRANTY AND THE COMPANY’S SOLE AND EXCLUSIVE OBLIGATION.
THE COMPANY SHALL NOT BE LIABLE FOR INCIDENTAL, INDIRECT, CONSEQUENTIAL OR SPECIAL
DAMAGES ARISING OUT OF OR IN CONNECTION WITH THE PRODUCT, ITS USE OR PERFORMANCE.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you. This warranty gives you specific legal rights,
and you may also have other rights, which vary from state to state.
This warranty covers only replacement or repair of defective Products or parts thereof at the
Company’s main facility and does not include the cost of field service travel and living expenses.
Any assistance the Company provides to or procures for you outside the terms, limitations or exclusions
of this limited warranty will not constitute a waiver of such terms, limitations or exclusions, nor will
such assistance extend or revive the warranty.
The Company will not reimburse you for any expenses incurred by you in repairing or replacing any
defective Product, except for those incurred with the Company’s prior written permission.
How to Obtain Warranty Service: To qualify for warranty service, you must (a)notify the Company
at the address or telephone number stated below within seven (7)days of discovering the covered
defect, (b)give the model number and part identification and (c)describe the nature of any defect in the
Product or part. At the time of requesting warranty service, you must present evidence of the original
purchase date. If you cannot provide a copy of the original written limited warranty, then the terms
of the Company’s most current written limited warranty for your particular product will control.The
most current limited written warranties for the Company’s products can be found at
www.broan.ca.
Broan-NuTone Canada ULC 1140 Tristar Drive, Mississauga, Ontario L5T 159
www.broan.ca 888-882-7626
Page 2
VENTILATION FAN MODEL QTXE150C
TYPICAL
INSTALLATIONS
Housing
mounted to
I-joists.
Use I-joist
spacer blocks
(provided).
Housing mounted
anywhere between
trusses using
hanger bars.
Housing
mounted
anywhere
between
I-joists
using
hanger bars.
Housing
mounted to
joists.
Housing
mounted
anywhere
between
joists
using
hanger bars.
Housing
mounted to
truss.
HOUSING
MOUNTING
TABS
CEILING
MATERIAL
POWER CABLE
TRUSS
GRILLE
PLAN THE INSTALLATION
Cooking
Equipment
Floor
COOKING AREA
Do not install above or
inside this area.
45º 45º
NOT FOR USE IN
A COOKING AREA.
*Purchase
separately.
INSULATION
(Place around and
over fan housing.)
ROOF CAP
*
(with built-in
damper)
FAN
HOUSING
POWER
CABLE*
6-IN. ROUND
DUCT*
6-IN.
ROUND
ELBOWS*
Seal gaps
around
Housing.
Seal duct
joints with
tape.
OR
Keep duct
runs short.
WALL CAP*
(with built-in
damper)
The ducting from this fan to the outside of the building has a strong effect on the
air flow, noise and energy use of the fan. Use the shortest, straightest duct routing
possible for best performance, and avoid installing the fan with smaller ducts than
recommended. Insulation around the ducts can reduce energy loss and inhibit
mold growth. Fans installed with existing ducts may not achieve their rated airflow.
Page 3
VENTILATION FAN MODEL QTXE150C
1b. Mount housing anywhere between
trusses, joists, or -joists using hanger I
bars.
Sliding hanger bars are provided to allow for accurate positioning
of housing anywhere between framing. They can be used on all
types of framing ( -joist, standard joist, and truss construction) I
and span up to 24”.
Attach the MOUNTING CHANNELS to the housing using the
SCREWS supplied.
Extend HANGER
BARS to the width of
the framing.
Hold housing in place
so that bottom edge of
housing will be flush
with finished surface
of ceiling. For 1/2”
thick ceiling material,
position bottom of
each mounting flange
flush with bottom of
joist.
OR
1a. Mount
housing to
joist.
Hold housing
in place so that
bottom edge
of housing will
be flush with
finished surface
of ceiling. For
1/2” thick ceiling
material, position bottom of each mounting flange flush
with the bottom of joist. The housing mounts with four (4)
screws or nails. Screw or nail housing to joist through low-
est holes in each mounting flange, then through highest
holes. NOTE: Mounting to I-JOIST (shown) requires use
of SPACERS (included) between the highest hole of each
mounting flange and the I-joist.
2. Attach
damper/duct
connector.
3. Install
6-inch round
ductwork.
Connect 6-inch
round ductwork
to damper / duct
connector. Run
ductwork to a roof
cap or wall cap.
Tape all ductwork
connections
to make them
secure and air tight.
SPACER
(use for
mounting
to I-Joist)
TOP AND BOTTOM FLANGES
REMAIN OUTSIDE OF HOUSING
I-JOIST
BJ0025
SCREW
FROM
PARTS BAG
INSERT
TAB INTO
SLOT IN
HOUSING
To ensure a noise-free
mount: Secure hanger
bars together with
SCREWS and use a
pliers to crimp
mounting channels
tightly around
hanger bars.
INSTALL HOUSING & DUCT


Product specificaties

Merk: Broan
Categorie: Ventilator
Model: QTXE150C

Heb je hulp nodig?

Als je hulp nodig hebt met Broan QTXE150C stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Ventilator Broan

Handleiding Ventilator

Nieuwste handleidingen voor Ventilator