Blaupunkt AMP7502 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Blaupunkt AMP7502 (12 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 94 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
Bridgeable Range Ampli er
AMP1504
AMP1501
AMP7502
©2017 BLAUPUNKT. All Rights Reserved. This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation. WARNING: This product contains a chemical known to the
State of California to cause cancer and reproductive toxicity.
2231 Colby Ave, Los Angeles California 90064
System Planning
Speaker Requirements
Symptom Possible Cause Action to take
10
installation carefully, you can avoid situations where the performance and reliability of your system is
compromised. Our authorized dealer has been trained to maximize your system’s sound quality when
Ω speaker loads when used in Stereo Mode. When
a channel-pair is bridged, the recommended
minimum load impedance is 3 for subwoofer use, Ω
and 4 for full range operation. Although Ω
operation with lower impedances is not likely to
cause immediate damage to the internal circuitry,
the unit will most likely overheat, causing the
thermal protection circuitry to shut down the
operation will resume.
conditions is not recommended and will reduce its
life expectancy. Most speakers designed for car
audio operation are 4 impedance. Connecting Ω
two such speakers in parallel will result in a 2 Ω
nominal impedance, which is not recommended
Poor bass response Speakers wired wrong
polarity causing cancellation
at low frequencies
Check speaker polarity and repair as
needed
Crossover set incorrectly Reset crossover referring to the
section of this manual for detailed
instructions
Battery fuse blowing
too low
Check speaker impedance load. If below
2 stereo or 4 mono, rewire speakers Ω Ω
to achieve a higher impedance
Short in power wire or
incorrect power connections
Check power and ground connections
and repair as needed
Fuse used is smaller and
recommended
Replace with proper fuse size
Too much current being drawn Check speaker impedance load. If below
2 stereo or 4 mono, rewire speakers Ω Ω
to achieve a higher impedance and
replace with recommended fuse size
Short in power wire or incorrect
wire
Check power and ground connection and
repair as needed
Too much current being drawn Check speaker impedance load. If below 2
Ω Ω stereo or 4 mono, rewire speakers to
achieve a higher impedance and replace
with recommended fuse size
Check power and ground connections.
Repair as needed
Fuse used is smaller than
recommended
Replace with proper fuse size


Product specificaties

Merk: Blaupunkt
Categorie: Receiver
Model: AMP7502

Heb je hulp nodig?

Als je hulp nodig hebt met Blaupunkt AMP7502 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Receiver Blaupunkt

Handleiding Receiver

Nieuwste handleidingen voor Receiver