Bestway 61078 Boot Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Bestway 61078 Boot (56 pagina's) in de categorie Boot. Deze handleiding was nuttig voor 59 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/56
61062,61078,61102
61099,61100,61108
www.bestwaycorp.com
Item
Inflated Size
Maximum Weight
Passenger Capacity
Inflation Pressure
1.55m x 93cm (61’’ x 37’’)
80 kg (178 lbs.)
1 adult
0.03 bar (0.5 psi)
61078 / 61099
1.88m x 98cm (6’2’’ x 39’’)
120 kg (264 lbs.)
1 adult +1 child
0.03 bar (0.5 psi)
61062 / 61100/ 61108
2.32m x 1.15m (91’’ x 45’’)
190 kg (418 lbs.)
2 adults +1 child
0.03 bar (0.5 psi)
61102
Technical Specifications
Warning
IMPORTANT SAFETY INSTRUCTIONS
Follow all the Safety and Operating Instructions. If you don’t follow these
instructions, it may cause the boat to overturn or explode and result in drowning.
1. Do not exceed the maximum recommended number of persons. Regardless of
the number of persons on board, the total weight of persons and equipment
must never exceed the maximum recommended load. Always use the seats/
seating spaces provided.
2. When loading the craft, never exceed the maximum recommended load:
Always load the craft carefully and distribute loads appropriately to maintain
design trim (approximately level). Avoid placing heavy weights high up.
NOTE: The maximum recommended load includes the weight of all persons
onboard, all provisions and personal effects, any equipment not included in
the light craft mass, cargo (if any) and all consumable liquids
(water, fuel, etc.).
3. When using the boat, life saving devices such as life jackets and buoys should
be pre-inspected and used at all times.
4. Before every use, carefully inspect all boat components including
air-chambers, grab ropes, oars, and air valves, to ensure everything is in good
condition and tightly secured. If you find any damage, please stop to repair it.
5. Buckets, water scoops and air pumps should always be available in case of air
leakage or if the boat takes on water.
6. When the boat is in motion, all passengers must remain seated at all times to
avoid falling overboard. Keep the boat balanced. Uneven distribution of
persons or load in the boat may cause the boat to overturn and result in
drowning.
7. Use the boat near the shore and beware of natural factors such as wind, tide
waters and tidal waves.
BE AWARE OF OFFSHORE WINDS AND CURRENTS.
8. If one chamber is punctured when the boat is in the water, it may be necessary
to fully inflate the other air chamber to prevent the boat from sinking.
9. Be careful when landing on the shore. Sharp and rough objects such as rocks,
cement, shells, glass, etc. may puncture the boat. To avoid damage, do not
drag the boat on rough surfaces.
10. When choosing an outboard motor, refer to the technical specifications section
of this manual to determine acceptable horsepower ratings.
11. For electrical motors equipped with batteries, note that battery acid can be
caustic, which can cause damage to both skin and boat materials.
12. For motors which use fuels such as gas, oil or petrol, since fuel is a flammable
substance, it should be kept away from open flames. Further, clean the boat
material immediately if fuel spatters onto the boat surface. Be aware of the
potential harmful effects of liquids such as battery acid, oil or petrol. The
liquids may damage your boat.
13. Inflate according to the numbered air chamber and rated pressure of the boat,
or it will cause over-inflation and potential and boat explosion. Exceeding the
data given on the capacity plate may cause the craft to be damaged, overturn
and lead to drowning.
14. Know how to operate a boat. Check in your local area for information and/or
training as needed. Inform yourself about local regulations and dangers
related to boating and/or other water activities.
NOTE: 1.55m x 93cm (61’’ x 37’’) boats do not include oar clasps.
NOTE: Drawings for illustration purpose only. Not to scale.
PLEASE CAREFULLY READ THIS MANUAL BEFORE USING YOUR
INFLATABLE BOAT. KEEP IT FOR FUTURE REFERENCE.
Boat Safety rope • Inflation Scale
61099; 61100
Components:
• Repair Patch
• Deflation Pipe
OarBoat
Components:
• Repair Patch
• Deflation Pipe
Safety rope
Foot Pump
• Inflation Scale
61062; 61108
OarBoat
61102
Components:
• Repair Patch
• Deflation Pipe
Safety rope
Hand Pump
• Inflation Scale
OarBoat
61078
Components:
• Repair Patch
• Deflation Pipe
Safety rope
• Inflation Scale
Heavy Duty Handle
Inflatable Floor
Oar Clasp
Oarlock
Rope Grommet
Valve
Grab Rope
2
Construction of the boat
• Inflate the air chambers with a HAND air pump.
An inflation scale is provided with the product. Inflate the product until the printed
scale is charged up to the same level as that of the supplied scale. (refer to the
table and illustrations below)
Caution: Under and over-inflation of the boat will result in safety hazards. It is
better to check the pressure of the boat each time before use. If you use another
pressure gauge, the boat pressure should not be more than the data given on the
builder’s plate.
• Never stand on or rest objects on the boat during inflation.
• Inflate the bottom chamber and other accessories such as the seat until it is stiff
to the touch, but NOT hard.
• Extended exposure to sun can shorten the lifespan of your boat. We suggest not
leaving boats in direct sunlight for more than 1 hour after use.
SAVE THESE INSTRUCTIONS
Assembling of the boat
NEVER USE HIGH PRESSURE AIR TO INFLATE INFLATABLES. THIS CAN
DAMAGE YOUR PRODUCT AND VOID YOUR WARRANTY
Oars Installation
For 61062, 61078, 61108, 61102
Note: When the oars are not in use, lock the oars into the Oar Clasps to avoid
damage.
Note: All drawings for illustration purpose only. May not reflect actual product.
Storage
1. Remove the Oars from the oarlocks.
Note: Keep all accessories for future use.
2. Carefully clean the boat using a mild soap with clean water.
Note: Do not use acetone, acid, and/or alkaline solutions.
3. Use a cloth to gently dry all surfaces.
Note: Do not dry the product in direct sunlight. Also, never dry with equipment
such as electric blowers. Doing so will cause damage and shorten the boat’s life
span.
4. Deflate the hull chambers. Deflate all the hull chambers at the same time so the
air-pressure drops simultaneously.
This will prevent damage from occurring to the boat's inner structures. Next,
deflate the floor.
5. Fold the boat from front to back to remove additional air. You can also use a
pump to drain any remaining air.
Repair
1. If there is a small puncture, repair it according to the instructions on the repair
patch.
2. If the hole is too big to be repaired with the provided patch, purchase a Bestway
repair kit or send the boat to a speciality shop to make the repair.
Registration (For US/Canada customers only)
If you need to register your boat, please have the boat Hull Identification Number
and model name ready and then visit www.bestwaycorp.com/support to obtain
your Certificate of Origin, or you can send e-mail to
service@bestwaycorp.us for the Certificate of Origin.
PLEASE KEEP THIS MANUAL IN A SECURE PLACE, AND HAND IT OVER TO
THE NEW OWNER WHEN YOU SELL THE CRAFT.
mc
mc1112
1112
131415
3
Item
61078 / 61099
61062 / 61100 / 61108
61102
Product Inflated Size
1.55m x 93cm (61’’ x 37’’)
1.88m x 98cm (6’2’’ x 39’’)
2.32m x 1.15m (91’’ x 45’’)
Deflated Size
10cm
10cm
10cm
Inflated Size
Chamber 3
11.3cm
11cm
11.1cm
Inflated Size
Chamber 2
5.4cm
5.4cm
5.4cm
Product specificaties
| Merk: | Bestway |
| Categorie: | Boot |
| Model: | 61078 Boot |
Heb je hulp nodig?
Als je hulp nodig hebt met Bestway 61078 Boot stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Boot Bestway
4 Mei 2024
1 Augustus 2023
4 Juni 2023
4 Juni 2023
4 Juni 2023
4 Juni 2023
4 Juni 2023
4 Juni 2023
3 Juni 2023
Handleiding Boot
- Boot Yamaha
- Boot Hansa
- Boot Intex
- Boot Rhino
- Boot Sevylor
- Boot Talamex
- Boot Vetus
- Boot Zodiac
- Boot Jilong
- Boot Crivit
- Boot Honwave
- Boot Rodi
- Boot Seamax
- Boot Pega
- Boot Winga
Nieuwste handleidingen voor Boot
16 Juli 2024
16 Juli 2024
16 Juli 2024
16 Juli 2024
16 Juli 2024
16 Juli 2024
16 Juli 2024
16 Juli 2024
16 Juli 2024
4 April 2024