BeamZ S700 Handleiding

BeamZ Rookmachines S700

Lees hieronder de 📖 handleiding in het Nederlandse voor BeamZ S700 (12 pagina's) in de categorie Rookmachines. Deze handleiding was nuttig voor 46 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/12

Ref. Nr. 160.426

S700

LED SMOKE MACHINE

Flame effect

INSTRUCTION MANUAL

GEBRUIKSAANWIJZING

BEDIENUNGSANLEITUNG

- 2 -

- 3 -

Warning:

- The smokemachine must be placed at least 100 cm away from inflammable materials such as curtains,

books, etc. Make sure that the housing cannot be touched by accident.

- Use only Beamz water-based smoke fluid recommended by your dealer.

- Poor smoke liquid caused permanent damage, bad effect, clogging, spitting of unevaporated liquid etc.

- Never add flammable fluids (oil, gas, perfume) to the fog liquid.

- Always keep enough smoke liquid in the tank.

Use of the device without liquid will cause damage to the pump and heater.

- Do not obstruct the openings on top of the case to guarantee a good ventilation.

- Don’t put any objects on the smoke machine.

- For indoor use only.

- During installation, nobody should stand beneath the mounting area.

- Prior to the first use, have the unit checked by a qualified person.

- The unit contains voltage carrying parts. DO NOT open the smokemachine

- Never plug or unplug the unit with wet hands.

- If the plug and/or mains lead are damaged, they need to be repaired by a qualified technician.

- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains outlet. It

needs to be repaired by a qualified technician.

- Only connect this unit to an earthed mains outlet of 220-240Vac/50Hz .

- Always unplug the unit during a thunderstorm or when it is not in use.

- If the unit has not been used for a longer period of time, condensation can occur inside the housing. Please

let the unit reach room temperature prior to use.

- When you unplug the unit from the mains always pull the plug, never the lead.

- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid chain, a

steel cable, etc. which has to be fastened separately from the mounting bracket.

- The supplied bracket is the main fixing and must be used to solidly mount the light effect.

- In order to avoid accidents in public premises, the local legal requirements and safety regulations/warnings

must be fulfilled.

- Keep out of the reach of children.

Location

Select a location where it is easy to fill the tank. It is also possible to hang the unit by means of the supplied

holder and fixing screws.

Intro : A compact 700W smoke machine with orange LEDs for an astonishing and unique flame effect while

producing fog. The smoke machine has a built in reservoir for the smoke fluid. The LEDs flame effect can be

switched off on the back of the smoke machine. Smoke production can be activated on the supplied remote

control.

Installation and Use

Unpack the fog machine. Do not connect yet the net cable. Connect the lead of the manual control with the 3-

pin plug at the rear of the smoke machine. Fill the fluid tank by means of a funnel. Plug the unit into a mains

outlet. Thus the heating element is automatically switched on. Depending on the room temperature, it takes

about 3 minutes until the working temperature is reached. Then the thermostat is clicking and the LED on the

manual control lights up. Push the switch once and the smoke machine will produce a nice thick fog. Once the

smoke machine has reached its working temperature (the LED is lit) the smoke machine can produce fog for a

while. After this period of time, the fog generator is cooled so much down that the thermostat switches off. Wait

a while until the working temperature is reached again. It is recommended to produce smoke with small pauses

in between so that the temperature is maintained and the thermostat doesn’t switch off.

Make sure that there is always enough liquid smoke contained in the tank. Use of the smoke machine without

liquid can permanently damage the unit. Once the smoke machine generates little smoke or pump generate

another 'rattling' sound i turn off the unit direct. Check the fluid level and fill the tank when it is empty, check the

hose and filter blockages and restore it. Plug in the unit and check if the problem is resolved. If problem persists,

switch unit direct off to prevent further damage and contact your dealer.Switching the unit off :Switch the unit off

by unplugging it from the mains. Otherwise the 700W heating element will draw unnecessarily current.

Product specificaties

Merk:	BeamZ
Categorie:	Rookmachines
Model:	S700
Kleur van het product:	Zwart
Gewicht:	2500 g
Snoerlengte:	3 m
Vermogen:	700 W
Afstandsbediening:	Bedraad
Op afstand bedienbaar:	Ja
Productafmetingen (B x H x D):	260 x 145 x 130 mm
AC-ingangsspanning:	220-240 V
AC-ingangsfrequentie:	50 Hz
Vloeistoftank capaciteit:	0.25 l
Hoeveelheid rook uitstoot:	75 m³/min
Bedrijfsvloeistof:	Water