Bauknecht GSIP 6517/1 SW Handleiding

Bauknecht Vaatwasser GSIP 6517/1 SW

Lees hieronder de 📖 handleiding in het Nederlandse voor Bauknecht GSIP 6517/1 SW (8 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 51 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

5019 496 01066

GB GSIP 6517

Before using the dishwasher, read the

installation and maintenance instructions carefully!

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to

different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness

and power supply voltage.

2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on

the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with.

Standard NF EN 13697 - November 2001.

1. OVERVIEW

Programme selector

START button

The indicator lights up during operation, ﬂashes when a fault

occurs, and goes off at the end of the programme.

START button RESET function:

Press this button for at least 2 seconds; the selected programme and

options are cancelled. Main failure displays (repeated flashing of the

START indicator lamp) can be cancelled by RESETTING. Detailed

instructions are given in chapter 5 “What to do, in case of...”.

Fault indication and wash time display

In normal operation it indicates the remaining time (h:mm),

whereas with “Delayed start” selected it indicates the time

remaining until programme start (hh).

If “F..” appears on the display, see chapter 5 “What to do, in case of...”.

“Delayed start” button

Press the button (repeatedly) to delay the start of the programme.

Adjustable from 1 to 24 hours. With each press of the button, the

delayed start indicator increases by one hour and after 24 restarts

from 00. Then press the START button. The dishwasher will start

after the set time.

Half Load/Multizone button

The half load cycle can be used for the upper or lower rack. Select the

required programme then press the “Half load” button. The light

comes on and goes off at the end of the programme.

This function can be used with the programmes indicated in table 1.1.

Antibacterial rinse 3)

This function activates an antibacterial rinse at the end of the wash

cycle, guaranteeing a further reduction of bacteria. Press the button to

activate or deactivate the function. This function can be used with those

programmes marked with the relative symbol in table 1.1.

The dishwasher door must be kept shut for the entire duration of

the programme in order to guarantee reduction of bacteria. If the

door is opened the indicator lamp starts flashing.

On / Off button

Table 1.1.

Table of programmes Detergent

dispenser Consumption 1)

PProgrammes Available

options Loading instructions large small Litres kWh Minutes

1Pre-rinse cold — Crockery to be washed later. — — 4.0 0.03 14 ± 1)

2Rapid 40°C —Lightly soiled crockery, without dry

residuals. X — 10.0 0.65 30 ± 1)

3Bio 2) 50°C Normally soiled crockery. Energy-saving

programme. X X 12.0 1.05 165 ± 1)

4Daily 60°C Normally to heavily soiled crockery. X X 13.0 1.25 120 ± 1)

5Intensive 70°C Recommended programme for heavily

soiled crockery, especially suitable for

pans and saucepans. X X 14.0 1.55 155 ± 1)

2. QUICK REFERENCE GUIDE

Detailed instructions are given on the following pages; also see section “5. What to do, in case of...”

1. Switch on the

appliance Press the ON/OFF button.

2. Select a programme Press the button “Select programme” or the programme selector to display the

selected programme. If required, select possible options.

3. Select the type of

detergent The detergent selection procedure varies depending on the dishwasher model.

Chapter “1. Overview” provides instructions for selecting detergent type.

4. Fill in the detergent 4a. Powder/gel/tabs

Fill the detergent dispenser compartments in

accordance with the wash programme selected.

Large compartment A for every wash cycle, additional

small compartment B for programmes with pre-wash

(see table 1.1.).

4b. Combined action detergents (2 in 1/3 in 1/... etc.)

Place the detergent in compartment A or in the cutlery

basket, as per the manufacturer's recommendations.

5. Check the rinse aid

level

6. Check the salt level Depending on the model:

7. Load the racks

Make sure that the spray arms can turn freely and are not impeded by crockery

or cutlery in the racks.

Detailed instructions on loading the racks are given in chapter “3. How to use

the appliance”, under “How to load the racks”.

8. Open the water tap

and close the door

9. Start the appliance Press the START button.

Wash cycle

If the appliance is switched off during a

wash cycle, when switched on again it will

resume the cycle from where it was

interrupted. Care must be taken when

opening the door, as steam will escape!

10.End of programme The START indicator lamp switches off at the end of the programme.

11.Switch off the

appliance Press the OFF button. All the indicator lamps switch off.

12.Turn oﬀ the water

tap, unload the racks

Unload the appliance, starting from the lower rack in order to avoid any

residual drips of water falling onto crockery below.

Visual indicator in dispenser C

dark ➯sufficient rinse aid present,

clear ➯add rinse aid (approx. 100 ml).

The indicator lamp on the control panel lights up when rinse aid

needs to be added. Not all models are equipped with such an

indicator.

window in salt reservoir cap on bottom of appliance inside

orange ➯when sufficient salt is present,

clear ➯when salt needs to be added.

The indicator lamp on the control panel lights up when salt needs

to be added. Even once salt has been added, the indicator lamp

only switches off after several wash cycles!

Changing the programme

in progress:

- Keep the START button pressed

for about 2 seconds until the

START indicator goes off.

- (Water drains for up to 60

seconds).

- Select the programme again.

- Press the Start button.

3. HOW TO USE THE APPLIANCE

PROGRAMME SELECTION

Press the button “Select programme” or the programme selector to display the selected programme. The

appliance must be switched on. If required, select possible options. The corresponding indicator lights up. The

correct programme and the selectable functions are given in table 1.1 on page 1.

Programme times stated in the table were obtained under normal conditions and may vary

depending on conditions. Differences of up to 20 minutes are possible with sensor programmes

as a result of the appliance's automatic calibration system.

HOW TO FILL THE DETERGENT DISPENSER

Only fill the detergent dispenser prior to starting a wash programme. Only use detergents

specially recommended for dishwashers, observing the manufacturer's recommended dosage.

Observe the manufacturer's safety warnings!

Open the detergent dispenser compartments by pushing the left lever (lever 1) of the dispenser.

a. Powder/gel/tabs

Fill the detergent dispenser compartments in accordance with the wash programme selected (table 1.1).

Programmes without pre-wash:

pour the entire recommended dosage into compartment

Programmes with pre-wash:

pour 2/3 of the recommended dosage into the large compartment

A and 1/3 into the small compartment B.

Dishwasher tabs should be placed, according to the

manufacturer's recommendations, in compartment A or in the

cutlery basket.

If the “Half load” option is selected, detergent dosage should be

reduced by approximately 1/3.

b. Combined action detergents (2 in 1/3 in 1/... etc.)

Combined action detergents should be placed, according to the

manufacturer's recommendations, in compartment A or in the

cutlery basket.

Firmly press the detergent compartment lid shut after filling.

Detergents with rinse aid incorporated may be effective only with longer programmes. In the

case of shorter programmes, detergent residue may be a problem (if necessary, use powder

detergent). Detergents with rinse aid incorporated tend to form excess suds.

The guarantee is not applicable if faults are caused by the use of these products.

HOW TO CHECK/FILL/ADJUST RINSE AID

Not necessary when using a combined action detergent.

a. How to check the rinse aid level

Check the visual indicator C on the rinse aid dispenser: dark = su ear = add rinse aid.fficient rinse aid, cl

In the case of appliances with an electric indicator on the

control panel, the rinse aid indicator lamp lights up red

when rinse aid needs to be added.

b. How to fill the rinse aid dispenser

Open the rinse aid dispenser by pressing the right lever

(lever 2) of the dispenser.

Fill the dispenser with rinse aid up to the “max” line

(approx. 100 ml).

Shut the lid again.

Only use rinse aids recommended for use in domestic dishwashers. Immediately wipe away

any rinse aid spilt accidentally. This prevents the formation of excess suds which can cause a fault

function of the appliance.

Lever 1

Large

compartment A

Small

compartment B

Lever 2Indicator C

max

Product specificaties

Merk:	Bauknecht
Categorie:	Vaatwasser
Model:	GSIP 6517/1 SW

Heb je hulp nodig?

Als je hulp nodig hebt met Bauknecht GSIP 6517/1 SW stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Vaatwasser Bauknecht

Bauknecht OBIC Ecospace 8650 Handleiding

18 December 2024

Bauknecht B2I HKD524 AS Handleiding

18 December 2024

Bauknecht GSIP 6527 IN Handleiding

3 December 2024

Bauknecht GSXP 50/1 Power Handleiding

3 December 2024

Bauknecht OBBC Ecosilent 8650 Handleiding

11 November 2024

Bauknecht B0I D551A S Handleiding

24 September 2024

Bauknecht B0U D651A X Handleiding

22 Augustus 2024

Bauknecht B0U D641A X Handleiding

22 Augustus 2024

Bauknecht B0F D641A X Handleiding

22 Augustus 2024

Bauknecht B0I D541A S Handleiding

21 Augustus 2024

Handleiding Vaatwasser

Nieuwste handleidingen voor Vaatwasser

Bosch SBV4HBX23E Handleiding

20 December 2024

Equator GD 075 Handleiding

19 December 2024

Teka DFI 46730 Handleiding

17 December 2024

Teka DFI 46720 Handleiding

17 December 2024

Junker JB55X02ITE Handleiding

16 December 2024

Junker JB55X01ITE Handleiding

16 December 2024

Junker JB55X01HTE Handleiding

16 December 2024

Junker JB65X00HTE Handleiding

16 December 2024

Junker JB65X00HVE Handleiding

16 December 2024

Junker JB55X00HTE Handleiding

16 December 2024