Basement Watchdog Special+ Connect Handleiding

Basement Watchdog Pomp Special+ Connect

Lees hieronder de 📖 handleiding in het Nederlandse voor Basement Watchdog Special+ Connect (20 pagina's) in de categorie Pomp. Deze handleiding was nuttig voor 12 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/20

Instruction Manual

& Safety Warnings

IMPORTANT: Even if you have the Basement Watchdog Special

Backup Sump Pump System installed by someone else, you must read

and follow the safety information contained in this manual. Failure

to do so could result in property damage, serious injury, or death.

Battery Backup

Sump Pump

System

Table of Contents

Important Safety Warnings and

Instructions

Electrical Precautions 1

Battery Preparation 1

Battery Precautions 1

Introduction

Items Included in System 2

Additional Items Needed 2

System Specifications 2

Replacement Parts List 2

Pump & Pipe

Installation Instructions

Installation Options 3

Direct Discharge to Outside 4

Connection to Existing Discharge 5

Direct Discharge for Narrow Sumps 6

Connection to Existing Discharge for

Narrow Sumps 7

Battery Instructions

Preparation of the Battery 8,9

Control Unit Connections

Positioning the Float Switch 9

Connecting the Pump 9

Installing the Battery Fluid Sensor 10

Connecting the Battery 10

Connecting the Charger 10

Understanding the Warning

Lights and Alarms

Silencing the Alarm

During an Emergency 11

Battery Alarm 11

Cleaning Battery Terminals 11,12

Replacing the Battery 12

Fuse Alarm 13

Water Alarm 13

Pump Alarm 14

Replacing the Pump 14

Power Alarm 15

Charging 15

System Operating 15

Testing the System

Test-Reset-Silence Button 15

Testing the Float Switch 15

Using the Remote Notification

Remote Terminal 15

Remote Alarm 15

USB Data Port 16

Connect Modules 16

Maintenance Check List 16

Parts & Service Information

Technical Support 16

Troubleshooting Guide 17

Warranty 18

Other Products 19

This manual is for the systems that

have the BWSP-A backup controller,

which can accommodate maintenance

or maintenance free batteries.

Important Safety

Warnings & Instructions

SAVE THESE INSTRUCTIONS. This manual

contains important SAFETY WARNINGS and

OPERATING INSTRUCTIONS for the Basement

Watchdog Special battery backup sump pump

system. You will need to refer to it before

attempting any installation or maintenance.

ALWAYS keep these instructions with the unit so

that they will be easily accessible.

Failure to read and follow these warnings and

instructions could result in property damage,

serious injury, or death. It is important to read

this manual, even if you did not install the

Basement Watchdog backup sump pump system,

since this manual contains safety information

regarding the use and maintenance of this

product. DO NOT DISCARD THIS MANUAL.

ELECTRICAL PRECAUTIONS

This installation must be in accordance with

the National Electric Code and all applicable

local codes and ordinances.

Risk of electrical and fire hazard. May result

in death, serious injury, shock or burns.

To help reduce these risks, observe the

following precautions:

• DO NOT walk on wet areas of the basement

until all power has been turned off. If the

main power supply is in a wet basement, call

an electrician.

• handle the control unit with wet handsNEVER

or while standing on a wet surface.

• ALWAYS unplug the control unit and

disconnect the cables from the battery before

attempting any maintenance or cleaning.

• ALWAYS unplug the main pump when

installing or servicing the backup pump or

float switch to avoid electric shock.

• expose the control unit to water, rainDO NOT

or snow.

• place the control unit on the floor.DO NOT

• pull the cord when disconnecting theDO NOT

control unit. Pull the plug.

• use an extension cord. The electricalDO NOT

outlet should be within the length of the

controller’s power cord and at least 4 feet

above the floor.

• use an attachment not recommendedDO NOT

or sold by the manufacturer. It may result in

a risk of fire or injury from an electrical shock.

• DO NOT operate this product if it has received

a sharp blow, been dropped, or otherwise

damaged in any way.

• DO NOT use pump in pits handling raw sewage,

salt water, or hazardous liquids. This system is

for ground water use only.

• disassemble the control unit. DO NOT

• protect the electrical cord from sharpDO

objects, hot surfaces, oil and chemicals. Avoid

kinking the cord.

• the supply circuit has a dedicatedMAKE SURE

fuse or circuit breaker rated to handle the

power requirements of this system.

When service is required, contact Glentronics

technical support at 800-991-0466, option #3,

or send an e-mail to service@glentronics.com.

Return the control unit to the manufacturer for

any repairs at the following address:

Glentronics, Inc.

645 Heathrow Drive, Lincolnshire, IL 60069-4205

BATTERY PREPARATION

Sulfuric acid can cause blindness or severe

burns. Avoid contact with skin, eyes, or

clothing. In the event of an accident, flush

with water and call a physician immediately.

KEEP OUT OF REACH OF CHILDREN.

To help reduce these risks, observe the

following precautions:

• Someone should be within range of your voice

or close enough to come to your aid when you

work near a lead-acid battery.

• Have plenty of fresh water and soap nearby in

case battery acid contacts skin, clothing or eyes.

• Wear eye and clothing protection and avoid

touching your eyes while working with battery

acid or working near the battery.

• If battery acid contacts skin or clothing, wash

immediately with soap and water. If acid

enters eye, immediately flood eye with

running cold water for at least 15 minutes and

get prompt medical attention.

WARNING:

Battery posts and terminals

contain lead, lead compounds or chemicals known

to the State of California to cause cancer, birth

defects or other reproductive harm. Wash hands

after handling. See www.p65warnings.ca.gov for

more information.

WARNING:

Battery fluid can expose you to

chemicals including strong inorganic acid mists

containing sulfuric acid, which is known to the

State of California to cause cancer. For more

information go to www.P65warnings.ca.gov.

BATTERY PRECAUTIONS

Explosive gases could cause serious injury or

death. Cigarettes, flames or sparks could

cause battery to explode in enclosed spaces.

Charge in a well-ventilated area. Always

shield eyes and face from battery. Keep vent

caps tight and level.

To help reduce these risks, observe the

following precautions:

• smoke or allow a spark or flame in theNEVER

vicinity of the battery.

• Use the Basement Watchdog control unit for

charging a LEAD-ACID battery only. DO NOT

use the control unit for charging dry-cell

batteries that are most commonly used with

home appliances.

• Be sure the area around the battery is well-

ventilated.

• When cleaning or adding water to the battery,

first fan the top of the battery with a piece of

cardboard (or another non-metallic material)

to blow away any hydrogen or oxygen gas that

may have been emitted from the battery.

• drop a metal tool onto the battery. ItDO NOT

might spark or short-circuit the battery and

cause an explosion.

• Remove personal metal items such as rings,

bracelets, watches, etc. when working with a

lead-acid battery. A short circuit through one of

these items can melt it, causing a severe burn.

• ALWAYS remove the charger from the electrical

outlet before connecting or disconnecting the

battery cables. Check the polarity of the

battery posts. The POSITIVE (+) battery post

usually has a larger diameter than the

NEGATIVE (-) post.

• When connecting the battery cables, first

connect the small ring on the end of the

BLACK wire to the NEGATIVE (-) post of the

battery, and then connect the large ring on the

end of the RED wire to the POSITIVE (+) post

of the battery.

• ALWAYS keep the cover secured on the battery

box by slipping the tabs through the fittings

on the front and back of the box.

Do not use this system to pump flammable

or explosive fluids such as gasoline, fuel oil,

kerosene, etc. This system is rated for

ground water use only.

DO NOT use this system in pits handling raw

sewage or other hazardous liquids.

Page 1

!DANGER

!WARNING / POISON

!DANGER

POSITIVE POST HAS

LARGER DIAMETER

NEGATIVE POST HAS

SMALLER DIAMETER

POSITIVE

POST

NEGATIVE

POST

!WARNING

Introduction

The Basement Watchdog Special backup sump

pump system is battery-operated. It is designed as

an emergency backup system to support your main

AC sump pump, and it will automatically begin

pumping any time the float switch is activated by

rising water. Should any malfunction or emergency

occur that involves the sump pump, the battery, or

the AC power, the Basement Watchdog system will

sound an alarm. A light on the display panel of the

control unit will indicate the cause of the alarm

and the corrective action.

For added reliability, the float switch has, not

one, but two floats. Should one float fail to

operate, the second float automatically activates

the pump.

The Basement Watchdog Special Sump Pump

System includes:

• A control unit with a dual float switch, a

battery fluid level sensor, battery cables, and a

20 amp fuse

• A pump with a 1½” PVC pipe adapter

• A plastic wire tie for mounting the float switch

• A battery box

• A battery charger

• A battery cap with a hole to accommodate the

fluid sensor

You will also need to supply:

• A Basement Watchdog Big Standby Battery

(30HDC140S or BW-30F) or Basement

Watchdog Maintenance Free (AGM) Standby

Battery (BW-27AGM).

DO NOT use an automotive battery with

this system

DO NOT use a Basement Watchdog Emergency

Standby Battery (24EP6 or BW-24F) with this

system. It will not run the pump as long as the

Big or Maintenance Free (AGM) Standby Battery

• 1½” rigid PVC pipe and fittings

• PVC primer and cement

• A union with hose clamps or a “Y” connector

and two (2) check valves, depending on the

installation method you use

• A surge protector (recommended)

• Six (6) quarts of 1.265 specific gravity battery

acid (30HDC140S and BW-30F). Battery fluid is

not needed if using the Basement Watchdog

Maintenance Free (AGM) Standby Battery.

For narrow sump pits you will need some

additional parts:

• An “L” bracket at least six (6) inches long

(preferably one that will not rust)

• Two (2) stainless steel hose clamps

• One (1) stainless steel screw (#8-32 x 3/4”), a

matching washer & nut

To connect two batteries you will need:

• Two (2) batteries of the same age, type and

capacity (so they will have equal power).

• use batteries of different types, agesDO NOT

or capacities as they will not charge properly

• Another battery box

• Two (2) acid packs to fill the dry batteries

• A set of battery cables with rings on both

ends to connect the two batteries together

(available from Glentronics, Inc.)

Use of a Basement

Watchdog Klunkless

Check Valve™ will

provide quieter

operation. (See

page 18 for more

information.)

Replacement Part Numbers

Pump . . . . . . . . . . . . . . . . . . . . . . .1011002

Float switch assembly . . . . . . . . . . . .1020009

Fluid sensor assembly . . . . . . . . . . . .1014001

Pipe adapter . . . . . . . . . . . . . . . . . .1120002

Charger . . . . . . . . . . . . . . . . . . . . . .1015001

Battery box . . . . . . . . . . . . . . . . . . .1113003

Battery cap with hole . . . . . . . . . . . .1125000

Call 800-991-0466, option #3 to order parts.

System Specifications

Power supply requirements . . . . . .115 volts AC

Pumping capacity . . . . . . . . . .2600 GPH @ 0’

Pumping capacity . . . . . . . . .1850 GPH @ 10'

Pump dimensions w/elbow . . . . . .75⁄8” H x 9”W

Pump housing & strainer . . . . . .non-corrosive,

will not rust

Pump . . . .can run dry for short periods of time

Float switch . . . . . . . . . .independent, can be

set at any level

Page 2

Battery

Wires

Control Unit

Battery Box

Charger

Cap

Wire Tie

Float

Switch

Pipe

Adapter

Pump

Fluid Sensor

Product specificaties

Merk:	Basement Watchdog
Categorie:	Pomp
Model:	Special+ Connect

Heb je hulp nodig?

Als je hulp nodig hebt met Basement Watchdog Special+ Connect stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Pomp Basement Watchdog

Basement Watchdog Special+ Connect Handleiding

3 April 2024

Basement Watchdog BWD12-120C Handleiding

9 Januari 2024

Handleiding Pomp

Nieuwste handleidingen voor Pomp

Sauermann Omega Handleiding

13 November 2024

Sauermann Delta Handleiding

12 November 2024

Testo 565i Handleiding

12 November 2024

Simpson SCP71008 Handleiding

11 November 2024

MSW -PUMP CLEAN 100 Handleiding

5 November 2024

MSW -OP-56-DC Handleiding

5 November 2024

MSW -FM-N-53 Handleiding

4 November 2024

MSW -AOP40S Handleiding

15 Oktober 2024

MSW -MN34M Handleiding

15 Oktober 2024

MSW -MN34 Handleiding

15 Oktober 2024