Azden WR32-PRO Handleiding

Azden Microfoon WR32-PRO

Lees hieronder de 📖 handleiding in het Nederlandse voor Azden WR32-PRO (3 pagina's) in de categorie Microfoon. Deze handleiding was nuttig voor 47 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/3

WR32-PRO

DISCRETE DUAL-CHANNEL VHF WIRELESS RECEIVER

Thank you for purchasing an Azden product.

Please read this manual thoroughly before using this

product.

TWO-YEAR LIMITED WARRANTY

AZDEN CORPORATION warrants to the first consumer purchaser that the product purchased is free

from defects in material and workmanship. AZDEN's sole obligation under this warranty shall be to

provide, without charge, repair or replacement (at AZDEN's sole discretion), within two years from the

date of purchase.

This warranty is the sole and exclusive express warranty given with respect to the product and all other

express warranties are hereby excluded. Neither AZDEN nor the dealer who sells the product is

responsible for indirect, incidental, or consequential damages.

This warranty does not extend to any defect, malfunction, or failure caused by misuse, abuse, accident,

or defective associated equipment for which it was not intended. Please read any instructions carefully.

This warranty is valid only when the product is returned directly to AZDEN at the address below, freight

prepaid, together with proof of date of purchase.

200 Valley Road, Suite 101, Mt. Arlington, NJ 07856

Phone: 973-810-3070 Fax: 973-810-3076

e-mail: sales@azdencorp.com www.azdencorp.com

PRINTED IN JAPAN 060-35783-01

PRODUCT DESCRIPTION

The WR32-PRO is a high quality discrete dual-channel VHF receiver which allows you to use two Azden

PRO Series wireless microphone/transmitters simultaneously.

FREQUENCIES

The system operates in the 169 & 172 MHz band, where interference is very low. Before using the system,

it is recommended that you check it at the locaon you are shoong; to make sure that there is no

interference.

LOADING THE BATTERY (see diagram A)

Open the baery door. Load two AA alkaline batteries into the case, making sure that the polarity is correct.

Close the door, but do not force it. If it takes pressure to close, re-check the polarity. The baery life is

approximately 8 hours. Use of rechargeable baeries is not recommended.

SHOE MOUNT (see diagram B)

The WR32-PRO comes with both a shoe mount and hook & loop fastener. You can use either method to

aach the unit to your camera. To use the shoe mount, line up the tabs on the black plasc plate holding

the shoe mount with the holes on the back of the WR32-PRO. Press down gently, and push the tabs upward,

unl you feel them slip into place (reverse the process to remove). Now aach the WR32-PRO to the

camera's shoe stand. Turn the thumbwheel clockwise to ghten, but do not over -ghten. If you're using

the hook & loop fastener instead of the shoe mount, aach the fastener with the smooth surface to the

WR32-PRO, and the piece with the rough surface to the camera.

CABLES & JACKS

The WR32-PRO comes with a stereo mini (3.5mm)-to-stereo mini (3.5mm) cable. Plug one end into the

WR32-PRO's MIC OUT jack, and the other end into the camera's MIC input jack. An oponal stereo“ ”

mini-to-dual XLR cable (part number MX-2) is available for the WR32-PRO.

The PHONE jack on the WR32-PRO is for headphone monitoring only. Plug any stereo headphone into

this jack to monitor sound. The volume level is xed and cannot be adjusted.

ANTENNAS (see diagram C)

For best recepon fully extend the antennas and point them straight up.

For storage lower the antennas and point them straight out from the receiver.

Use cauon, as the antennas are not designed to rotate side to side.

MICROPHONE / TRANSMITTERS

The WR32-PRO works with all Azden microphone/transmiers with the PRO designaon.“ ”

Including the WL/T-PRO and WM/T-PRO or the transmitters from the following systems,

WMS-PRO, WHX-PRO and WLX-PRO.

Consult the manuals for which microphone/transmier come with these systems.

POWER & FREQUENCY ON/OFF SWITCHS (see diagram D)

Turn either the F1 or F2 switch to ON . The corresponding LED will light red, indicang that the power“ ”

is on. Take your PRO Series microphone/transmier and set the frequency selector/switch to the same

frequency you have selected for the WR32-PRO F1 or F2. The corresponding LED on the WR32-PRO will

turn from red to green, indicang that the WR32-PRO is now receiving the signal. If you are using 2

microphone/transmiers with the WR32-PRO, make sure to follow the same procedure for the second unit,

using the other frequency.

CAUTIONS

When two microphone/transmiers are used simultaneously, make sure 1 transmier is set to Frequency

1 (F1) and the other transmitter is set to Frequency 2 (F2). Addionally, when using two microphone/

transmitters, make sure that the transmiers are at least 10 feet (3 meters) away from the WR32-PRO

receiver. Typical operang range is 10-100 feet. Placing one or both transmiers closer than 10 feet

may cause proximity interference problems.

The cable supplied with the WR32-PRO will not work with devices (smart phone, tablet) using a TRRS jack.

An adaptor to convert the WR32-PRO s stereo plug (2 black stripes) to TRRS plug (3 black stripes) will be’

necessary.

SPECIFICATIONS

RECEPTION FREQUENCY: F1.169.445MHz

F2.170.245MHz

Double Superheterrodyne System

RECEPTION SENSITIVITY: 2 V at S/N40dBμ

BATTERY: Two 1.5V AA (not included)

POWER CONSUMPTION: 100mA

MONITOR OUTPUT: Voltage: 0.7V

(Load: 30 , Modfreq: 1kHz, Dev: 7kHz)Ω ±

MICROPHONE OUTPUT: Voltage: 25mV

(Load: 10k , Modfreq: 1kHz, Dev: 7kHzΩ ±

Impedance: 300 )Ω

DIMENSIONS: 63(h) X 98(w) X 28.5(d)mm

WEIGHT (including baery):

171g

(B)

(A)

(C)

(D)

Product specificaties

Merk:	Azden
Categorie:	Microfoon
Model:	WR32-PRO
Kleur van het product:	Zwart
Ingebouwd display:	Nee
Gewicht:	171 g
Breedte:	98 mm
Diepte:	28.5 mm
Hoogte:	63 mm
LED-indicatoren:	Ja
Ethernet LAN:	Nee
Montagewijze:	Cameramontage
Meegeleverde kabels:	Audio (3,5 mm)
Accu/Batterij voltage:	1.5 V
Ondersteund aantal accu's/batterijen:	2
Antennas quantity:	2
Soort voeding:	Batterij/Accu
Frequentie:	169.445, 170.245 MHz
Gevoeligheid:	2 μV
Signaal/ruis-verhouding:	40 dB
Aantal kanalen:	2 kanalen
Type batterij:	AA
Type werkfrequentie:	Zeer hoge frequentie (VHF)
Aantal ontvangstfrequenties:	2