AXESS AXPIO-COL2 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor AXESS AXPIO-COL2 (16 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 7 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16
AXPIO-COL2
I N S TA L L A T I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2024 METRA ELECTRONICS CORPORATION REV. 7/25/24 INSTAXPIO-COL2
ATTENTION: With the key out of the ignition,
disconnect the negative battery terminal
before installing this product. Ensure that all
installation connections, especially the air
bag indicator lights, are plugged in before
reconnecting the battery or cycling the ignition
to test this product.
NOTE: Refer also to the instructions included
with the aftermarket radio.
TABLE OF CONTENTS
Speaker Installation...............................................2
Dash Disassembly 2 ..................................................
Connections 3-4 ........................................................
Kit Preparation 5 .......................................................
Kit Assembly 5 ..........................................................
Radio Operations 6-7 ...............................................
Chevrolet GMCColorado/ Canyon 2019-Up
KIT FEATURES)
Designed for Pioneer DMH-W4600NEX/W4660NEX or
DMH-WC5700NEX receivers
Allows for the retention and adjustment of the factory personalization
menu through the Pioneer radio
Provides a visual view of HVAC and gauges on the Pioneer screen (cannot
be adjusted via the screen)
(cont. on page 2)
KIT COMPONENTS
• A) Radio Trim Panel • B) Brackets • C) #8 x 3/8" Phillips pan-head Screws (4)
Not Shown: Radio Interface, LD-GM30-PIO, LD-GM31-PIO, AD-EU5, 40-GPS-PIO, PR04AVIC-PIO/PRO4-PIORCA, LD-AX-SPK
Visit for more detailed information about the product and
AxxessInterfaces.com
up-to-date vehicle specific applications.
WIRING & ANTENNA CONNECTIONS
RGB Extension Cable: Pioneer part # CD-RGB150A
(not sold by Metra)
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• 9/32" socket wrench
A B C
2
KIT FEATURES (cont. from cover)
Complete Plug-n-Play installation
Includes dash kit with Axxess interface and
vehicle-specific T-harness
Includes radio antenna adaptor for GPS
Provides accessory power (12-volt 10-amp)
Provides NAV outputs (parking brake,
reverse, speed sense)
Retains audio controls on the steering wheel
Works in both single and dual-zone vehicles
Retains safety chimes through an included
off-board speaker
• USB Micro “B” USB updatable
• Dash kit is painted scratch-resistant matte
black to match the factory finish
For non-amplified vehicles only
KIT FEATURES
(CONT.)
DASH DISASSEMBLY
1. Unclip and remove the trim panel
surrounding the radio/climate control
panel. (Figure A)
2. Remove (4) 9/32" screws securing the
radio/climate control panel. (Figure B)
3. Remove (2) 9/32" screws securing the CD
player then unplug and remove the player.
4. Unclip and slide out the factory tuner
module then unplug and remove it.
5. Unclip and remove the climate controls
from the factory trim panel.
6. Unclip and remove the climate control
vents from the factory trim panel.
Continue to Connections
(Figure A)
(Figure B)
SPEAKER INSTALLATION
Install the provided speaker in the dash prior to assembling the radio components.
Note: Make sure this is mounted in a location suitable for the driver to hear. (Audio level for the
speaker can be changed via the radio, once installed.)
3
REV. 7/25/24 INSTAXPIO-COL2
EXTERNAL SPEAKER
LD SPK-AX-
Pioneer Harness
LD-GM30-PIO
CARSIDE ORS CONNECT (CONNECT TO
EXTENSION)
MICRO-HDMI
ADAPTER NEEDED
(N/A)
EXT SPKR
CAN 2
CAN3
“TBA” WIRES
AD-EU5
AUX IN
High-Level
PRO4-AVIC-PIO
USB/AUX
(USE INSTEAD)
AXXESS INTER CEFA PRO4-PIORCA
Low-Level
AUX (INCL. W/RADIO)
GPS 4-PIN MIC HDMI
ANT
18P (M)
18P (F)
16P 22P
40-GPS-PIO
10
TBA
CONNECTIONS
Important: Verify HVAC status & control, Steering
wheel audio controls, and External Speaker output
prior to completing dash assembly.
Important: Install the provided
speaker in the dash prior to assembling
the radio components.
Note: Make sure this is mounted in a
location suitable for the driver to hear.
(Audio level for the speaker can be
changed via the radio, once installed.)
Note: LD-GM30-PIO applications will
not retain the factory backup camera.


Product specificaties

Merk: AXESS
Categorie: Niet gecategoriseerd
Model: AXPIO-COL2

Heb je hulp nodig?

Als je hulp nodig hebt met AXESS AXPIO-COL2 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd AXESS

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd