AXESS AXDI-VET1 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor AXESS AXDI-VET1 (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 9 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
AXDI-VET1
I N S T A L L A T I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2023 METRA ELECTRONICS CORPORATION REV. 8/8/23 INSTAXDI-VET1
ATTENTION: With the key out of the
ignition, disconnect the negative battery
terminal before installing this product.
Ensure that all installation connections,
especially the air bag indicator lights, are
plugged in before reconnecting the battery
or cycling the ignition to test this product.
NOTE: Refer also to the instructions
included with the aftermarket accessory
before installing this device.
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS & INSTALLATION ACCESSORIES REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink • Tape • Wire cutter
• Zip-ties
TABLE OF CONTENTS
Connections
LD-AX-XSVI-GM5 Diagram 2 ................................
Installation 3 .............................................................
Programming 3 .........................................................
Corvette Amplifier Interface 1997-2004
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (Retained Accessory Power)
• High level speaker input
• Retains amplified door woofers
• Micro-B USB updatable
• CHEVROLET
APPLICATIONS
Chevrolet
Corvette 1997-2004 ...........................................................................................
Visit
AxxessInterfaces.com
for more detailed information about the product
and up-to-date vehicle specific applications
2
CONNECTIONS: LD-AX-XSVI-GM5 DIAGRAM
Differential Converter
(top view)
Radio Connections
Red - Accessory power
Red - Accessory power
Orange - Illumination
Black - Ground wire
White/Black - Front left speaker -
White - Front left speaker +
Purple - Rear right speaker output +
Purple/Black - Rear right output -
Gray - Front right speaker +
Gray/Black - Front right speaker -
Green/Black - Rear left speaker output -
Green - Rear left speaker output +
Blue/White - Amp turn on
Yellow - Battery wire
Differential Converter
(front view)
Vehicle Connectors
Interface
OUTPUT
INPUT
Fuse Holder
CH3CH4 CH1CH2
TRIGGER
LD-AX-XSVI-GM5
Output Level Adjustments
3
REV. 8/8/23 INSTAXDI-VET1
INSTALLATION
PROGRAMMING
With the key in the off position:
• Connect the harness into the interface, and then to the wiring harness in the vehicle.LD-AX-XSVI-GM5
Attention! If the interface loses power for any reason, the following steps will need to be performed again. Also, if installing an
AXSWC connect it after you initialize and test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
If the radio does not come on within 60 seconds, turn the key to the off position, disconnect the interface, check all Note:
connections, reconnect the interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all functions of the installation for proper operation,
before reassembling the dash.
If using the AXSWC, connect it after you initialize the AXDI-VET1, with the key in the off position.Note:


Product specificaties

Merk: AXESS
Categorie: Niet gecategoriseerd
Model: AXDI-VET1

Heb je hulp nodig?

Als je hulp nodig hebt met AXESS AXDI-VET1 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd AXESS

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd