AXESS AX-ADXSVI-GM2 Handleiding

AXESS Niet gecategoriseerd AX-ADXSVI-GM2

Lees hieronder de πŸ“– handleiding in het Nederlandse voor AXESS AX-ADXSVI-GM2 (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 10 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
METRA. The World’s best kits.β„’ metraonline.com1-800-221-0932 Β© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
Installation Instructions for AX-ADXSVI-GM2
REV. 1/16/2014 INSTAX-ADXSVI-GM2
(continued on next page)
AX-ADXSVI-GM2
WIRING THE AX-ADXSVI-GM2
β€’ξ˜ Connect the Yellowwire to the radio’s 12 volt battery or memory wire.        
β€’ξ˜ Connect the wire to the radio’s ground wire. Black     
β€’ξ˜ Connect the wire to the ignition wire of the aftermarket radio. Red        
β€’ξ˜ Connect the wire to the illumination wire of the aftermarket radio. If the Orange           
aftermarket radio has no illumination wire,        tape off the Orange wire.
β€’ξ˜ The wire will not be used in this application.Orange/White        Tape     up or cap off this
wire and disregard it.  
β€’ξ˜ Connect the wire to the antenna turn on wire of the aftermarket radio. Blue          
β€’ξ˜ Connect the wire to the left front positive speaker output of the aftermarket radio. White           
β€’ξ˜ Connect the wire to the left front negative speaker output of the White/Black          
aftermarket radio.
β€’ξ˜ Connect the wire to the right front positive speaker output of the Gray          
aftermarket radio.
β€’ξ˜ Connect the wire to the right front negative speaker output of the Gray/Black          
aftermarket radio.
β€’ξ˜ Connect the wire to the radio’s left rear positive speaker output. Green        
β€’ξ˜ Connect the wire to the radio’s left rear negative speaker output. Green/Black        
β€’ξ˜ Connect the wire to the radio’s right rear positive speaker output. Purple        
β€’ξ˜ Connect the wire to the radio’s right rear negative speaker output. Purple/Black        
CHEVROLET
Cobalt 2007-2010
HHR 2006-2011
Malibu 2008-2012
PONTIAC
G5 2007-2008
G6(5th digit of VIN must be a J, K, or L) 2009
G6 2010
Solstice 2006-2009
SATURN
Aura 2007-2009
Sky 2006-2009
APPLICATIONS
KIT FEATURES
β€’ξ˜ Provides accessory (12 volt 10 amp)    
β€’ξ˜ Retains R.A.P.   (retained accessory power)
β€’ξ˜ Used innon-amplified systems or when replacing amplified system      
β€’ξ˜ Provides outputs (parking brake, reverse, NAV     and V.S.S.)
β€’ξ˜ Prewired ASWC-1 harness included (ASWC-1 sold separately)     
β€’ξ˜ High level speaker input  
β€’ξ˜ USB updatable
Note:
1)This harness must be used in conjunction with the AX-ADXSVI        
2)All chimes will be lost when using this harness       
AX-ADXSVI-GM2
METRA. The World’s best kits.β„’metraonline.com1-800-221-0932 Β© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
The following wires are for the aftermarket radios that have navigation built in.           
β€’ξ˜ Connect the wire to the parking brake wire of the aftermarket navigation  Light Green          
radio (if applicable). 
β€’ξ˜ Connect the wire to the Blue/Pink   VSS or speed sense wire of the aftermarket       
navigation radio (if applicable).  
β€’ξ˜ Connect the wire to the reverse wire of the aftermarket navigation radio Green/Purple          
(if applicable).
β€’ξ˜ Cycle the key,          by turning the ignition on for 30 seconds. Then off and on again to test      
the radio.
AS )WC-1 (if installing
After the XSVI is initialized,              plug in the ASWC-1 into the 12-pin harness of the AX-ADXSVI-
GM2 and refer to the ASWC-1 instructions.     
K PNOWLEDGE IS OWER
Enhance your inst allation and fabrication skills by
enrolling in the most cognized and spected re re
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for mo information and take steps re
toward a better t omorrow.
Metra recommends MECP
certified technicians
IMPORTANT WARNING
Thisproductincludesinstructionsforinstallationwhichmustbecarefullyfollowed.The
instructionsarewordedinsuchamannertoassumethattheinstalleriscapableof
completingthesetypeofelectronicinstallations.Ifyouareunclearastowhatyouare
instructedtodoorbelievethatyoudonotunderstandtheinstructionssoastoproperly
andsafelycompletetheinstallationyou should consult a technician who does have this
knowledge and understanding.
Failure to follow these instructions carefully and to install the interface as described
could cause harm to the vehicle or to safety systems on the vehicle. Interference with
certain safety systems could cause harm to persons as well. If you have any questions
in this regard please call the Help line or Metra at 1-800-221-0932 for assistance.


Product specificaties

Merk: AXESS
Categorie: Niet gecategoriseerd
Model: AX-ADXSVI-GM2

Heb je hulp nodig?

Als je hulp nodig hebt met AXESS AX-ADXSVI-GM2 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd AXESS

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd