Audio-Technica ES925/XLR Handleiding

Audio-Technica Microfoon ES925/XLR

Lees hieronder de 📖 handleiding in het Nederlandse voor Audio-Technica ES925/XLR (3 pagina's) in de categorie Microfoon. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/3

ES925ML6/XLR

ES925ML12/XLR

ES925ML15/XLR

ES925ML18/XLR

ES925ML21/XLR

ES925ML24/XLR

User Manual

MICROLINE CONDENSER

MODULAR GOOSENECK MICROPHONE

WITH XLR POWER MODULE

■Introduction

Thank you for purchasing this product. Before using the product, read through

the user manual to ensure that you will use the product correctly. Please keep

this manual for future reference.

■Features

• Modular microphone system comprised of an ES Series capsule, gooseneck

assembly, and power module.

• RGB LED built into the gooseneck assembly can be linked seamlessly with

ATUC Series products and the desk stand (AT8699R).

• Insert the power module into a standard XLRF-type connector, or use the

included quick mount stand adapter (AT8473) to attach it to a microphone

stand.

• Cover a wide sound acquisition range from 90° to 360° by replacing the

capsule.

■Safety precautions

Although this product was designed to be used safely, failing to use it correctly

may result in an accident. To ensure safety, observe all warnings and cautions

while using the product.

■Cautions for the product

• Do not subject the product to strong impact to avoid malfunction.

• Do not disassemble, modify or attempt to repair the product.

• Do not handle the product with wet hands to avoid electric shock or injury.

• Do not store the product under direct sunlight, near heating devices or in a

hot, humid or dusty place.

■Notes on use

• Do not swing or pull the product. Doing so may cause disconnection or

damage.

• The circuitry in the microphone takes about 30 seconds to stabilize after power

is supplied. You may hear some audio disturbance during startup.

• Check that the carry case ground is grounded with the mic cable latch firmly

engaged before use.

• Do not excessively bend the gooseneck assembly, rotate the ends of the

capsule, or pull on them. Doing so may cause disconnection or malfunction.

• The product is a modular system comprised of a microphone element,

gooseneck assembly and power module. Make sure the parts are firmly

attached before use.

• Do not remove the rubber O-ring on the power module connecting part at the

lower section of the gooseneck assembly and the lower part of the XLR power

module.

• When attaching parts, remove the black cap on the capsule connecting part

of the gooseneck assembly. Do not remove the silicone part at the end of

the capsule connecting part.

Silicone part

Do not remove

■Assembly

1. • Insert the gooseneck assembly (c) while rotating it into the XLR power

module (d).

• Tighten until it does not rotate, and use the hex wrench (f) to tighten the

set screw (e) and set the gooseneck assembly in place.

• Connect the capsule (b) to the gooseneck assembly, and attach the

windscreen (a).

* If the parts are not sufficiently tightened together, problems may occur

such as the LED not lighting up to the set color or sound is not output.

2. • If you are using the AT8474, make mounting reference holes (with a

diameter of 1.5 mm (0.06") (X) on the circumference of a circle with a

diameter of 40 mm (1.6")) in the mounting surface.

• Make a hole with a diameter of 25.4 mm (1") in the center (Y) of the

mounting surface for the XLR power module.

• The outer diameter of the mounting surface is 52.4 mm (2.1") (Z).

120°

52.4

3 - 1.5φ

φ40.0

25.4

AT8474

■LED color

1 2 3

OFF RED GREEN

YELLOW

4 5 6 7

BLUE

MAGENTA

CYAN WHITE

■Wiring

1 2

PIN2

(Hot)

PIN1

(LED control)

CASE

(Ground)

PIN3

(Cold)

LED control only available with ATUC series products and AT8699R desk stand

■Specifications

ES925MLx/XLR

Element Fixed-charge back plate, permanently polarized condenser

Polar pattern Line + Gradient

Frequency response 30 - 20,000 Hz

Open circuit sensitivity -35dB (17.7mV) (0dB=1V/Pa, 1kHz)

Impedance 130 ohms

Maximum input sound

level 137 dB SPL (1kHz at 1% THD)

Dynamic range 114 dB (1kHz at Max SPL)

Signal-to-noise ratio 71 dB (1kHz at 1Pa, A-weighted)

Phantom power

requirements 11 - 52 V DC, 6.7 mA

Weight

ES925ML6/XLR: 106.2 g (3.7 oz)

ES925ML12/XLR: 130.2 g (4.6 oz)

ES925ML15/XLR: 135.2 g (4.8 oz)

ES925ML18/XLR: 140.2 g (4.9 oz)

ES925ML21/XLR: 145.2 g (5.1 oz)

ES925ML24/XLR: 150.2 g (5.3 oz)

Dimensions

ES925ML6/XLR: 316.3 mm (12.4“) x 20.2 mm (0.8“) x 20.2 mm (0.8“)

ES925ML12/XLR: 423.8 mm (16.7“) x 20.2 mm (0.8“) x 20.2 mm (0.8“)

ES925ML15/XLR: 500 mm (19.7“) x 20.2 mm (0.8“) x 20.2 mm (0.8“)

ES925ML18/XLR: 576.2 mm (22.7“) x 20.2 mm (0.8“) x 20.2 mm (0.8“)

ES925ML21/XLR: 652.4 mm (25.7“) x 20.2 mm (0.8“) x 20.2 mm (0.8“)

ES925ML24/XLR: 728.6 mm (28.7“) x 20.2 mm (0.8“) x 20.2 mm (0.8“)

(H×W×D)

Output connector 3-Pin XLRM-type

Optional interchangeable

elements

ESE-Ca (120°), ESE-Ha (100°), ESE-Oa (360°)

Included accessories

Windscreen AT8138a,

Universal isolation mount AT8474,

Quick mount stand adapter AT8473,

Coversion screw adapter (5/8”-27 to 3/8”-16),

Set screw (M2×2 mm (0.08“)) 2 pcs., Hex wrench (0.89 mm (0.04“))

x = 6/12/15/18/21/24

■Polar pattern

240˚

180˚

210˚

270˚

300˚

330˚

0˚

150˚

120˚

90˚

30˚

60˚

SCALE IS 5 DECIBELS PER DIVISION

LEGEND

200 Hz

1 kHz

5 kHz

8 kHz

■Frequency response

5020 20k10k5k2k1k500200100

Response in dB

Frequency in Hertz

LEGEND

0°, 50cm

10dB

■Dimensions

XLR power module (ES8544)

φ20.2

142419772-02-01 ver.1 2019.06.01

Audio-Technica Corporation

2-46-1 Nishi-naruse, Machida, Tokyo 194-8666, Japan

Global Support Contact: www.at-globalsupport.com

Made in Japan

(unit: mm)

ES / ES / ES / ES /925ML6 XLR 925ML12 XLR 925ML15 XLR 925ML18 XLR ES /925ML21 XLR ES /925ML24 XLR

316.3

423.8

500.0

576.2

652.4

728.6

φ8.0

Product specificaties

Merk:	Audio-Technica
Categorie:	Microfoon
Model:	ES925/XLR

Heb je hulp nodig?

Als je hulp nodig hebt met Audio-Technica ES925/XLR stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Microfoon Audio-Technica

Audio-Technica ATR4800-USB Handleiding

27 Februari 2024

Audio-Technica ES964 Handleiding

27 December 2023

Audio-Technica ATR4697-USB Handleiding

22 November 2023

Audio-Technica BP3600 Handleiding

2 Juli 2023

Audio-Technica ATM350PL Handleiding

15 Juni 2023

Audio-Technica BP4029 Handleiding

14 Juni 2023

Audio-Technica ES947WC/TB3 Handleiding

11 Juni 2023

Audio-Technica U841R Handleiding

10 Juni 2023

Audio-Technica AT2020USBi Handleiding

7 Juni 2023

Audio-Technica U843R Handleiding

7 Juni 2023

Handleiding Microfoon

Nieuwste handleidingen voor Microfoon

Neumann KM 56 Handleiding

2 December 2024

Vimar 19586.B Handleiding

1 December 2024

Vimar 19586 Handleiding

1 December 2024

Vimar 20586.N Handleiding

30 November 2024

Vimar 20586.B Handleiding

30 November 2024

Vimar 19586.M Handleiding

30 November 2024

Vimar 20586 Handleiding

30 November 2024

HyperX SoloCast Handleiding

30 November 2024

Hollyland LARK M1 Handleiding

30 November 2024

Polsen XP-2 Handleiding

25 November 2024