Aspes ATE80S Handleiding

Aspes Niet gecategoriseerd ATE80S

Lees hieronder de 📖 handleiding in het Nederlandse voor Aspes ATE80S (16 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 244 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/16

EN ELECTRIC WATER HEATER 03-07

Instructions for use and maintenance

TERMO DE AGUA ELÉCTRICO

08-12

Instrucciones de uso y mantenimiento

Read this manual carefully and keep it for future reference.

Lea atentamente este manual y guárdelo para futuras consultas.

ATE30S

ATE50S

ATE80S

Instructions for use and maintenancе 3

English

Dear Clients,

Our team would like to congratulate you on your

new purchase. We hope that your new appliance

shall bring more comfort to your home.

This technical description and instructions manual

was prepared in order to acquaint you with the

product and the conditions of proper installation and

use. These instructions were also intended for use

by qualied technicians, who shall perform the initial

installation, or disassembly and repairs in the event of

a breakdown.

Please consider that following the current

instructions will primarily be of interest to the

consumer, but along with this, it is also one of the

warranty conditions, pointed out in the warranty

card, so that the consumer can benet from the free

warranty services. The producer is not responsible

for damages in the appliance that have appeared

as a result of operation and/or installation not

corresponding to the instructions here.

The electric water heater complies with the

requirements of EN 60335-1, EN 60335-2-21.

I. INTENDED USE

The appliance is intended to supply hot water to

household sites equipped with a piping system

working at pressure below 6 bar (0,6Mpa).

It is designed to operate only in closed and heated

premises where the temperature is not lower than 4

°C and it is not designed to operate in a continuous

protracted regime.

The appliance is designed to operate in regions where

the water hardness is not more than 10 °dH. In case

that it is installed in a region where the water is harder

it is possible that limestone precipitation accumulate

very fast. This can cause a specic noise during

heating, as well as fast damaging of the electrical

part. For regions with harderwater yearly cleaning

of the limestone precipitation in the appliance is

recommended, as well as usage of not more than 2

kW of heating power.

II. TECHNICAL PARAMETERS

1. Nominal volume V, liters - see the appliance’s

rating plate.

2. Nominal voltage - see the appliance’s rating

plate.

3. Nominal power consumption - see the

appliance’s rating plate.

4. Nominal pressure - see the appliance’s rating plate.

This is not the water mains pressure. This is

the pressure that is announced for the

appliance and refers to the requirements of the

safety standards.

5. Water heater type - closed type accumulating

water heater, with thermal insulation.

6. Daily energy consumption – see Annex I

7. Rated load prole - see Annex I

8. Quantity of mixed water at 40 °C V40 litres - see

Annex I

9. Maximum temperature of the thermostat - see

Annex I

10. Default temperature settings - see Annex I

11. Energy e󰀩ciency during water heating - see

Annex I

III. IMPORTANT RULES

•This appliance is intended for domestic use only.

•The water heater must only be mounted in premises with normal

re resistance.

•Do not switch on the water heater unless you established it was

lled with water.

Attention! Improper installation and connection of the

appliance may make it hazardous for the health and life of

consumers. It may cause grievous and permanent consequences,

including but not limited to physical injuries and/or death.

Improper installation and connection of the appliance may also

lead to damage to the consumers’ property /damage and/ or

destruction/, or to that of third persons, as a result of, but not

limited to ooding, explosion and/or re. Installation, connection to

the main water and power supply, and putting into operation must be

carried out by certied electricians and technical personnel certied in

installation of this category of appliances, who have obtained their

license in the state where the installation and commissioning of the

appliance are carried out, and in compliance with its local legislation.

•Upon connecting the water heater to the electric mains care must

be taken to connect the safety lead.

Product specificaties

Merk:	Aspes
Categorie:	Niet gecategoriseerd
Model:	ATE80S
Kleur van het product:	Wit
Gewicht:	25200 g
Breedte:	386 mm
Diepte:	386 mm
Hoogte:	1270 mm
Geluidsniveau:	15 dB
Energie-efficiëntieklasse:	C
Jaarlijks energieverbruik:	1410 kWu
Soort:	Tank (wateropslag)
Capaciteit watertank:	80 l
Ondersteuning voor plaatsing:	Verticaal
Temperatuur (max):	60 °C
Maximaal vermogen:	1500 W
Maximum werkdruk:	8 bar
AC-ingangsspanning:	220 - 240 V
AC-ingangsfrequentie:	50 Hz
Stroomverbruik (typisch):	1500 W
Energie-efficiëntieschaal:	A+ tot F
Brandstof:	Electrisch
Boiler systeem:	Solo-boilersysteem
Warmwatercapaciteit:	- l/min