Apart PA2240BP Handleiding

Apart Receiver PA2240BP

Lees hieronder de 📖 handleiding in het Nederlandse voor Apart PA2240BP (8 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 52 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
1
6
23
45 2 3
45
1. Power switch
To turn the power on and off.
2. Overload indicator CH1 & CH2
This red LED illuminates when one of the protections have been activated. No sound will be heard
anymore. This will be in case of overheating being the result of drawing too much power from your
amplier or the impedance connected is below the minimum load impedance.
See also point 17 “bass control”.
3. Level indicators/clip-limit CH1 & CH2
The bottom LED will light green after powering on. To work under normal conditions the volume
indicator should be kept under 0dB. At +4dB a limiter will be activated. This red LED indicates that the
“auto gain circuit” reduces the level below clipping. This can be bypassed by qualied personnel only
(see jumper inside), but voids the guarantee and the LED will continue to icker.
This is NOT a clip indicator!
When the overheating protection circuit is active, the level indicators will all go dark. If this occurs
regularly, check the total load impedance and make sure the airow around the amplier is
not obstructed.
4. Prior LED CH1 & CH2
This yellow LED will illuminate when the prior input has been selected by means of the priority input
contact (see 11b). In bridge mode only the indication of CH1 are valid.
5. Program LED CH1 & CH2
This green LED tells you that the ‘program’ input is active.
6. Bridged LED
This yellow LED tells you when the amplier is in BRIDGE mode (= 480Watts)
Connect a sound source to the program or priority input 2 in bridge mode.


Product specificaties

Merk: Apart
Categorie: Receiver
Model: PA2240BP
Kleur van het product: Zwart
Breedte: 430 mm
Diepte: 412 mm
Hoogte: 88 mm
LED-indicatoren: Ja
Connectiviteitstechnologie: Bedraad
Ingang stroom: Ja
Audio-uitgangskanalen: 2.0 kanalen
Frequentiebereik: 35 - 22000 Hz
Signaal/ruis-verhouding: 95 dB
Totale harmonische vervorming (THD): 0.5 procent
AC-ingangsspanning: 230 V
AC-ingangsfrequentie: 50 Hz
Piekvermogen per kanaal: 240 W
Output impedance: 4 Ohm
Bridge-mode vermogen uitvoer per kanaal (4 Ohm): 480 W

Heb je hulp nodig?

Als je hulp nodig hebt met Apart PA2240BP stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Receiver Apart

Handleiding Receiver

Nieuwste handleidingen voor Receiver