AMX MXA-HST Handleiding

AMX Hoofdtelefoon MXA-HST

Lees hieronder de 📖 handleiding in het Nederlandse voor AMX MXA-HST (2 pagina's) in de categorie Hoofdtelefoon. Deze handleiding was nuttig voor 25 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

Installation Guide

MXA-HST Modero X Series® Bluetooth Handset

Overview

The MXA-HST Modero X Series® Bluetooth Handset (FG5968-17) is an optional

accessory for use with the Modero X Series Touch Panels. The handset allows

wireless Bluetooth audio communication through the touch panel, while the handset’s

Charging Cradle allows recharging either with a USB connection to the touch panel or

via the included electrical adapter.

Product Specifications

Safety and Battery Charging Information

Safety Information

• Do not dismantle, open, or shred the battery.

• Do not short-circuit the battery. Do not store batteries haphazardly in a box or

drawer where they may short-circuit each other or be short-circuited by conduc-

tive materials.

• Do not remove a battery from its original packaging until required for use.

• Do not expose batteries to heat or fire. Avoid storage in direct sunlight.

• Do not subject the batteries to mechanical shock.

• In the event of a cell leaking, do not allow the liquid to come in contact with the

skin or eyes. If contact has been made, wash the affected area with copious

amounts of water and seek medical advice.

• Equipment should be designed to prohibit the incorrect insertion of the battery

and its connector.

• Store the batteries in a dry place with the temperature between 32° F (0° C) and

104° F (40° C).

• Secondary batteries give their best performance when they are operated at

normal room temperature: 68° F +/- 5° (20° +/- 5° C).

CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of

used batteries according to the instructions.

Charging

• Use only with approved charger.

• Charge with a constant-voltage, constant-current battery charger circuit with the

following parameters:

Maximum charge voltage: 5.2 +/- 0.5 VDC

Maximum charge current: 120 mA

Charging temperature range: 2.5 deg C to 37.5 deg C (+/- 2.5 deg C)

Disposal

• When disposing of batteries, keep cells or batteries of different electrochemical

systems separate from each other.

• .Recycle or dispose of this battery in accordance with local regulations

1. When this crossed-out wheeled bin symbol is attached to a product, it means

the product is covered by the European Directive 2002/96/EC.

2. All electrical and electronic products/battery should be disposed of separately

from the municipal waste stream via designated collection facilities appointed by

the government or the local authorities.

3. The correct disposal of your old appliance/battery will help prevent potential

negative consequences for the environment and human health.

For more detailed information about disposal of your old appliance/battery, please

contact your city office, waste disposal service or the shop where you purchased the

product.

FCC Notice

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Indicator Light Status

The indicator light on the back of the MXA-HST (FIG. 1) flashes and changes color

based on the handset’s current status.

FIG. 1 MXA-HST Handset

MXA-HST Specifications

Power Requirements: DC 5V, 500mA

Bluetooth Specification: v2.1+EDR Class 2

Bluetooth Profiles

Supported:

Headset v1.2, HandsFree v1.5

Range of Frequency: 2.4GHz Spectrum

Nominal Charging Time: Within 8 hours

Talk Time: Up to 35 hours

Standby Time: Up to 200 hours

Dimensions (HWD): • Handset: 6.88” x 1.62” x 0.77” (17.46 cm x 4.12 cm x

1.95 cm)

• Charging Cradle: 1.93” x 3.64” 3.01” (5.06 cm x 9.25

cm x 7.65 cm)

Weight: • Handset: 0.2 lbs (90.72 g)

• Charging Cradle: 0.2 lbs (90.72 g)

Certifications: • CE

• Bluetooth

• FCC part 15 Class A

Other AMX Equipment: • MXA-IPA International Power Adapter Accessory Kit

( )FG5968-31

•MXA-BT Bluetooth USB Adaptor (FG5968-19)

Front Back

Indicator Light

Multi-Function

Button

Mute Button

Volume Up/

Volume Down

Buttons

Indicator Light Status

Handset Status Indicator Light

Standby Flash white

Charging (OFF STATE) Solid blue

Fully Charged (OFF STATE) Solid white

Charging (ON STATE) Solid blue, flash white every 10 seconds

Fully Charged (ON STATE) Solid white, flash white every 10 seconds

Mute Solid red

Low Battery Flash red with beep every minute

Out of Charge Indicator light turns off

Out of Range Solid blue for 5 seconds

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).

12/12

AMX reserves the right to alter specifications without notice at any time.

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com

93-5968-17 REV: A

Getting Started

To use your MXA-HST Bluetooth handset:

1. Ensure that your handset is fully charged.

2. Ensure that you have installed an MXA-BT Bluetooth USB Adaptor (FG5968-19)

to the USB port of your touch panel.

NOTE: An MXA-BT Bluetooth USB Adaptor is necessary to use the MXA-HST with a

Modero X Series touch panel.

3. Ensure that you have the latest Modero X Series Panoramic Touch Panel

firmware installed on your panel.

4. Ensure that you have the latest versions of the AMX Communications

Application and the Panel-to-Panel Video Chat Module uploaded to your

network Master. These modules are required for full button functionality with

intercom and video conferencing.

NOTE: The Modero X Series Panoramic Touch Panel firmware, the AMX

Communications Application, and the Panel-to-Panel Video Chat Module may be

downloaded at www.amx.com.

5. Pair your charged handset with a Modero X Series touch panel. For more

information, please refer to the Pairing the MXA-HST with a Modero X Series

Touch Panel section on page 2 below.

Charging the MXA-HST

The MXA-HST comes with a built-in rechargeable battery. Prior to using the handset

for the first time, fully charging the battery is highly recommended.

To charge your handset:

1. If you wish to charge your MXA-HST via USB, insert the USB plug of the

Charging Cradle (FIG. 2) into an available USB port on the Modero X Series

touch panel.

2. Insert the base of the handset into the Charging Cradle. The indicator light on

the back of the handset will turn blue while the handset is charging and solid

white when it is fully charged. The charging indicator will be delayed for a few

seconds if the handset has not been used for a long time or the battery is

drained.

NOTE: Use only the supplied Charging Cradle and USB charging cable to charge the

handset.

WARNING: Do not use the handset while it is seated in the Charging Cradle.

NOTE: Fully charging the handset may require up to eight hours.

Pairing the MXA-HST with a Modero X Series Touch Panel

To pair your handset with a Modero X Series touch panel:

1. Ensure that your handset is off before starting.

2. To activate the pairing mode, press and hold the handset’s Multi-Function

Button (MFB) (FIG. 1) for 8 seconds.

3. From the touch panel’s Settings Pages, pair the device with the touch panel. For

more information on pairing a Modero X Series touch panel with a Bluetooth

device, please refer to the Modero X Series Programming Guide, available from

www.amx.com.

4. If the pairing cannot be completed within two minutes after the pairing mode has

been activated, the indicator light on the back of the MXA-HST will flash blue

rapidly five times and then shut off. Repeat steps 1 through 3 to pair both

devices again.

Resetting the MXA-HST/Removing Its Pairing History

To reset your MXA-HST handset or remove its Bluetooth pairing history:

1. While the handset is in OFF mode, hold the Volume button and seat the hand-

set into the Charging Cradle. The indicator light will flash blue twice.

2. Release the Volume button.

3. The indicator light will stay blue again and the handset is reset.

Using the MXA-HST with a Modero X Series Touch Panel

FIG. 2 MXA-HST Charging Cradle (front)

Using the MXA-HST with a Modero X Series Touch Panel

Function Button Audio Indicator LED Indicator

Power ON Press and hold

MFB for 2

seconds

Short beep through

the earphone Flash white light

3 times

Power OFF Press and hold

MFB for 2

seconds

Long beep through

the earphone Flash blue light 2

times and then

turns off

Standby/Wake Up N/A N/A Flash white light

every 10 seconds

Charging N/A N/A Solid blue light

Fully Charged N/A N/A Solid white light

Low battery N/A Long beep through

the earphone Flash red light

Out of battery N/A N/A All lights turn off

Out of range N/A Long beep through

the earphone Solid blue light

for 5 seconds

Pairing Press and hold

MFB for 8

seconds

N/A Flash white and

blue lights

alternately

Incoming Call N/A Ringtone through the

earphone Blinking blue light

Answer/End a call Press MFB once Two step-up tones

for Answer

Two step-down tones

for Hang-up

Flash white light

every 10 seconds

Adjust Volume Press VOL UP

and VOL DOWN Short beep through

the earphone N/A

Last Number Redial Press MFB twice N/A N/A

Reject Incoming Call Hold VOL UP or

VOL DOWN for 2

seconds

Short beep N/A

Mute Press Mute

button once Two-step down tone

for Mute On, with 2

beeps every 10

seconds

Two-step up tone for

Mute Off

Solid red light

Product specificaties

Merk:	AMX
Categorie:	Hoofdtelefoon
Model:	MXA-HST
Kleur van het product:	Zwart
Oplader:	Ja
Bluetooth:	Ja
Bluetooth-versie:	2.1+EDR
Bluetooth-profielen:	HSF, HSP
Connectiviteitstechnologie:	Draadloos
Draagwijze:	In-ear
Headset type:	Monauraal
Positie speakers koptelefoon:	Intraauraal
Gesprekstijd:	35 uur
Type product:	Headset