Amina AIW350I-S200 Handleiding

Amina Speaker AIW350I-S200

Lees hieronder de 📖 handleiding in het Nederlandse voor Amina AIW350I-S200 (32 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 81 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/32
Installation Guide
V2.12 Oct 2014
Invisible Loudspeakers
AIW150i/350i/450i/550i/150i-S200/350i-S200
AIW150E/350E/550E/150E-S200/350E-S200
Products may vary from items pictured
Ensure that all installation mounting surfaces
are able to support the weight of the product.
After installation, avoid pushing on the wall
or ceiling surface immediately in front of the
speaker. Excessive excursion, whilst unlikely to
damage the speaker, will undoubtedly crack
the plaster around its perimeter.
Do not attempt to modify or repair the product.
Contact your distributor or manufacturer if a
fault should occur.
The rear of the product should not be subject
to chemical cleaning and should not be painted
in any way.
When plastering over, ensure only 2mm of
material covers the product. More than this will
degrade the performance of the product and
could lead to product failure.
To ensure optimal performance, please read
this guide carefully and keep in a safe place
for future reference.
Install this product in a cool, dry, clean place
- away from direct sunlight and heat sources,
strong vibrational forces, chemical fumes,
dust and moisture (steam).
Do not expose this product to sudden
temperature changes or locate it in an
environment with high humidity. This is to
prevent condensation forming inside which
may cause damage to the product.
Do not clean this product with chemical
solvents as this may damage the finish. Use a
clean, dry or damp cloth.
Caution: Read before installing this product
>
>
>
>
>
>
>
>
>
ENVIRONMENTAL:
Before installing, ensure that the building is environmentally sealed, de-humidified and at a stable
temperature of at least 16 degrees centigrade (61 degrees Fahrenheit)
This product should not be used with single thick coat plaster solutions or with other finishing
methods that take days (rather than hours) to dry out.
Please be aware that when this product is directly fitted into a solid wall structure (e.g. when
using the solid wall backbox) vibrational energy is inevitably transferred into the solid wall
structure. This energy can travel for some considerable distance up, down and along the structure.
It is therefore recommended the product be fitted within acoustically insulated stud walls or
ceiling sections where possible. The use of the product directly embedded in solid walls is not
recommended in multi occupancy buildings.
Equally, using the product in simple (stud or rafter with plasterboard or floor board directly
attached on both sides) stud walls & wooden rafter ceiling/floor structures will also transfer
substantial sound energy to the other side of the wall or floor above. It is therefore recommended
that the product be fitted in acoustically isolated stud walls or ceiling sections where possible.
WARNING:
No attempt should be made to install this product within existing building structures unless you
are certain that no electric cables, water pipes, gas pipes or supporting joists will be cut through.
FIRE PROTECTION:
When making an intrusion into an internal wall or ceiling to install an Amina loudspeaker be sure
to check the appropriate regulations pertaining to the required fire rating. Depending on the
location of the intrusion and the applicable regulations it may be necessary to build in or install
additional fire rated components or products to surround the speaker and back box. Amina
Technologies take no responsibility for the correct specification and installation of any such fire
protection system that is required behind their speakers.
01 Message from the Managing Director
02 Included in the carton / Packaging
03 How to use this manual
04 Installation overview diagram
Section
Preparing the wall / ceiling and
fixing the product
05 Cavity Installation steps 1 + 2
06 Cavity Installation steps 3+4
07 Cavity Installation steps 5 + 6
08 Cavity Installation with backbox steps 1 + 2
09 Cavity Installation with backbox steps 3
10 Solid Wall Installation with backbox steps 1 + 2
11 Solid Wall Installation with backbox steps 3+4
12 Solid Wall Installation with backbox step 5
Section
Alignment and plastering preparation
13 Retrofit (patch plastered)
14 Retrofit (feathered skim)
15 Retrofit (full wet skim)
16 Drywall (patch plastered)
17 Drywall (feathered skim)
Section
Testing
18 Testing the speakers
Section
Finishing
19 Plastering and decorating steps 1 + 2
20 Plastering and decorating steps 3 + 4
21 Setup tips
22 Setup tips
23 Further details
24 Troubleshooting
25 Specifications / Evolution Series & APU
26 Spacesaver information
27 Warranty & copyright information
28 Accessories
29 Contact information
Contents
A
B
C
D


Product specificaties

Merk: Amina
Categorie: Speaker
Model: AIW350I-S200
Kleur van het product: Zwart
Gewicht: 1100 g
Breedte: 200 mm
Diepte: 40 mm
Hoogte: 450 mm
Gebruikershandleiding: Ja
Connectiviteitstechnologie: Bedraad
Gemiddeld vermogen: 30 W
Aanbevolen gebruik: Universeel
Impedantie: 8 Ohm
Audio-uitgangskanalen: - kanalen
Speaker plaatsing: Muur-montage
Peak Music Power Output (PMPO): 60 W
Frequentiebereik: 130 - 20000 Hz
Gevoeligheid: 84 dB
Versterkeraansluiting (binding post): Ja
Luidspreker soort: 1-weg

Heb je hulp nodig?

Als je hulp nodig hebt met Amina AIW350I-S200 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker Amina

Handleiding Speaker

Nieuwste handleidingen voor Speaker