American International NDK778 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor American International NDK778 (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 171 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
©2006 AMERICAN INTERNATIONAL INDUSTRIES, INC. Ver. 2/06
ND-K778 Mounting Kit
Nissan
2000-03 Maxima (All Models w/o Factory Navigation)
VEHICLE APPLICATIONS
DASH DISASSEMBLY INSTRUCTIONS
1. Open the ashtray lid & pull the ashtray liner out.
2. Remove the (1) Phillips screw from this location.
3. Gently lift upward on the trim around the gearshift lever.
4. Gently lift up & towards you the gear shift/ radio trim assembly (you will need to move
the gearshift back) disconnect attached harnesses & remove.
5. Gently lift upward & towards you the vent assembly above the radio, disconnect
attached harnesses & remove.
6. Remove the (4) Phillips screws securing the radio and heater, A /C control assembly
to the sub-dash.
7. Carefully remove the entire assembly and disconnect all harnesses & antenna lead
& remove.
2
2000-03 MAXIMA (Oversized Radio Instructions)
1. Remove the (8) Phillips screws securing the factory radio to the factory brackets.
2. Remove the factory radio from the brackets.
3. Remove the (4) Phillips screws securing the Heater/ A/C controls to the factory
brackets and remove.
4. Using a hammer, flatten only the (2) upper mounting holes for the factory radio on
each bracket.
5. Re-attach the Heater, A/C controls to the factory mounting brackets.
6. Attach the left and right mounting brackets (included with the kit) to the pocket using
the (2) Phillips screws provided.
7. Mount your radio into the kit.
8. Slide the kit and radio into the factory brackets.
9. Using the factory screws, mount the kit to the (2) lower factory radio mounting holes
on each side of each bracket. NOTE: The upper mounting tabs of the kit must be in
front of the factory mounting bracket hole locations.
10. Wire your stereo (we recommend the use of our wire harness part# NWH-702. This
vehicle also requires an antenna adapter our part# NM-9).
11. Reassemble dash following "dash disassembly instructions" Steps 1-7 in reverse order.
RADIO INSTALLATION INSTRUCTIONS
3
DASH DISASSEMBLY INSTRUCTIONS
1. Open the ashtray lid & pull the ashtray liner out.
2. Remove the (1) Phillips screw from this location.
3. Gently lift upward & towards you the vent assembly/Radio trim panel, disconnect
attached harnesses and remove.
4. Gently lift up and towards you the gearshift trim panel (you will need to move the
gearshift back) disconnect attached harnesses & remove.
5. Remove the (4) Phillips screws securing the factory radio/pocket/Heater/A. C.
assembly to the sub-dash.
6. Disconnect all harnesses & antenna lead attached to the Factory radio/Heater/AC
controls & remove the assembly.
7. Remove the (4) Phillips screws securing the factory radio to the factory brackets
2000-03 MAXIMA (Single ISO Instructions)
1. Mount your aftermarket radio to the factory radio bracket hole locations using the
screws provided with your radio.
2. Wire your stereo,(we recommend the use of our wire harness part# NWH-702. This
vehicle also requires an antenna adapter our part# NM-9).
3. Place the ISO trim ring around the face of the radio before re-mounting the
Vent/Radio trim panel.
4. Reassemble dash following "dash disassembly instructions" Steps 1-7 in reverse order.
RADIO INSTALLATION INSTRUCTIONS
Part # ITR-778
ISO Trim Ring


Product specificaties

Merk: American International
Categorie: Niet gecategoriseerd
Model: NDK778

Heb je hulp nodig?

Als je hulp nodig hebt met American International NDK778 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd American International

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd