Aiphone GT-HSA Handleiding

Aiphone Intercomsysteem GT-HSA

Lees hieronder de 📖 handleiding in het Nederlandse voor Aiphone GT-HSA (52 pagina's) in de categorie Intercomsysteem. Deze handleiding was nuttig voor 13 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/52

SERVICE MANUAL

GT SYSTEM

Standard & Expanded System

INSTALLATION MANUAL

Thank you for selecting Aiphone for your communication needs. Please read this manual carefully before installation, and

keep this in a safe place for future reference.

Please note that images and illustrations depicted in this manual may differ from the actual product.

The following manuals (in multi languages) of the GT system are also available from our website

http://www.aiphone.net/.

* The site can be accessed directly by reading the QR code on the right.

• Operation manual

• Installation manual

• Setting manual

• Quick start installation guide

• Aiphone GT Setup Tool for Windows

[QR code]

- 2 -

PRECAUTIONS

WARNING

(Negligence could result in death or serious injury.)

1. Do not dismantle or alter the unit. Fire or electric shock could result.

2. Do not connect any power source other than speciﬁ ed to terminals +,

- nor install two power supplies in parallel to single input. Fire or

damage to the unit could result.

3. Do not connect any terminal on the unit to AC power line. Fire or

electric shock could result.

4. For power supply, use Aiphone power supply model or model speciﬁ ed

for use with system. If non-speciﬁ ed product is used, ﬁ re or malfunction

could result.

5. Voltage is applied to parts within the equipment. Do not touch any parts

that are not associated with the installation, wiring, or connection.

Electric shock could result.

6. If any abnormality (i.e., smoke, unusual smell or unusual noise) is

sensed from the unit, or the unit falls or gets broken, unplug the unit or

turn off the breaker immediately. Fire or electric shock could result.

CAUTION

(Negligence could result in injury to people or damage to

property.)

1. Do not install or make any wire terminations while power supply is

plugged in. It can cause electrical shock or damage to the unit.

2. Before turning on power, make sure wires are not crossed or shorted.

Fire or electric shock could result.

3. When mounting the unit on wall, install the unit in a convenient location,

but not where it could be jarred or bumped. Injury could result.

4. Do not install the unit in locations subject to frequent vibration or

impact. It may fall or tip over, resulting in damage to the unit or personal

injury.

5. Be sure to perform a call test or check the chime volume with the

handset on the hook. If you operate the hook switch with the handset on

your ear, a sudden call etc. may cause damage to your ear.

6. Do not place your ear close to the speaker during use as it could cause

hearing damage.

Precautions for mounting

1. Observe the following restrictions for mounting entrance stations.

• Do not mount the entrance station so that it faces obliquely upward. The

rain water may go inside and it may damage the unit.

• Do not block the bottom of entrance station by caulking.

2. Do not install the unit in any of the following locations. Fire, electric shock,

or unit trouble could result.

• Places under direct sunlight.

• Places near heating equipment or a boiler that varies in temperature.

• Places where dust, oil, chemicals or hydrogen sulﬁ de are present.

• Places where moisture and humidity extremes are present, such as

bathrooms, cellars, greenhouses, etc.

• Places where the temperature is quite low, such as inside a refrigerated

area or in front of an air conditioner.

• Places with steam or smoke (near heating or cooking surfaces).

• Places subject to sulfur, such as hot springs.

• Places near the shore or exposed to the direct sea breeze.

3. Do not install this unit in any of the following locations where lighting or

the ambient environment could impact the display on the video monitor due

to the characteristics of the door station's camera.

• Locations where is bright as the sky is shown widely behind the caller

• There is a white wall behind the caller

• Locations subject to direct sunlight or strong lighting

4. When using a ﬂ uorescent light that shines around the camera in the 50Hz

area, the screen colors may variously change as color rolling or ﬂ ickering.

Please block off the light or use the inverter ﬂ uorescent lamp.

5. For running cables, separate them for audio/video and door release and

keep them more than 10cm (3-15/16") away from each other.

6. When using an existing wiring, depending on the type of wiring, it may not

operate the system. Please check and change it in advance.

7. Do not use the impact driver for mounting. Damage to the unit could result.

General Precautions

1. Keep the intercom wires more than 30cm (12") away from AC 100-240V

wiring. AC induced noise and malfunction could result.

2. When installing and using the system, please consider the privacy and

portrait rights of users and visitors. Aiphone shall not be held responsible

for violation or privacy or other statutory rights. (The protection of privacy

and statutory rights is the responsibility of the customer.)

3. Install the units, which will not be operated, in an area that will be

accessible for future inspections, repairs, and maintenance.

4. Be sure to install an entrance station vertically. If it is installed horizontally,

rainwater may get into the unit causing a malfunction.

5. For maintenance or after-sales service, make sure to provide the setting

data to the customer.

6. Do not put an obstacle such as a foliage plant where monitoring is done by

a human body detection sensor.

Notices

• Do not install the unit close to an electrical appliance or water heater using

a dimmer or inverter, a remote controller of ﬂ oor heating, etc. Failure to do

so may generate a noise causing a malfunction of the unit.

• In areas where broadcasting station antennas are close by, intercom system

may be affected by radio frequency interference.

• When warm indoor air ﬂ ows into the unit, dew condensation may be caused

by a temperature difference between indoors and outdoors. It is

recommended to cover openings on the unit such as cable incoming holes

to avoid condensation.

• Using a mobile phone or professional-use radio equipment such as walkie-

talkie close to the system may cause a malfunction.

Prohibited Do not dismantle unit Keep unit away from water Be sure to follow the instruction

- 3 -

Table of Contents

PRECAUTIONS ......................................................................................................................................... 2

1 SYSTEM CONFIGURATIONS

1-1 Standard system conﬁ guration & capacity ....................................................................................... 4

1-2 Expanded system conﬁ guration & capacity ...................................................................................... 5

1-3 Residential/tenant station conﬁ guration ............................................................................................ 6

1-4 Lift control system conﬁ guration (for expanded system only) ......................................................... 8

1-5 Wiring distance ................................................................................................................................. 9

2 COMPONENTS

2-1 Entrance station (modular type) ...................................................................................................... 12

2-2 Entrance station (all-in-one type) .................................................................................................... 14

2-3 Bus control unit etc. ........................................................................................................................ 14

2-4 Residential/tenant station, sub residential/tenant station ................................................................ 15

2-5 Door station ..................................................................................................................................... 16

2-6 Guard station ................................................................................................................................... 16

2-7 Lift control adaptor ......................................................................................................................... 16

3 MOUNTING

3-1 Mounting locations ......................................................................................................................... 17

3-2 Cable ............................................................................................................................................... 17

3-3 Mounting positions and image view area ....................................................................................... 18

3-4 Entrance station (modular type) ...................................................................................................... 19

3-5 Entrance station (all-in-one type) .................................................................................................... 21

3-6 Bus control unit, 4-way video junction unit, lift control adaptor and power supply ...................... 22

3-7 Residential/tenant station ................................................................................................................ 23

3-8 Door station (for residential/tenant station) .................................................................................... 26

3-9 Guard station ................................................................................................................................... 27

4 WIRING

4-1 Standard system .............................................................................................................................. 28

4-2 Guard station ................................................................................................................................... 30

4-3 Entrance station ............................................................................................................................... 31

4-4 Residential/tenant trunk .................................................................................................................. 34

4-5 Expanded system ............................................................................................................................ 40

4-6 Lift control system (for expanded system only) ............................................................................. 42

4-7 Option connector ............................................................................................................................. 43

5 SETTINGS

5-1 Switch settings ................................................................................................................................ 45

5-2 Switch settings (for residential/tenant stations only) ...................................................................... 48

6 CHECK FOR INSTALLATION ......................................................................................................... 49

6-1 Finding a proper "grounding point" for power supply .................................................................... 49

6-2 Checking "ground fault" with tester ................................................................................................ 50

REGULATIONS ....................................................................................................................................... 51

WARRANTY ............................................................................................................................................ 52