Adastra SA180 Handleiding

Adastra Omroepinstallatie SA180

Lees hieronder de 📖 handleiding in het Nederlandse voor Adastra SA180 (8 pagina's) in de categorie Omroepinstallatie. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

SA180

Secure Wall Amplifier with UHF Microphone

Item ref: 148UK 953.

User Manual

Version 1 .0

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

SA180 User Manual

Introduction

Thank you for choosing the Adastra SA180 secure wall amplifier as part of your public address system. This amplifier is

designed to offer high quality, dependable service for mobile and installed systems. Please read this manual fully and

follow the instructions to achieve the best results with your new purchase and to avoid damage through misuse.

SAFETY SYMBOL AND MESSAGE CONVENTIONS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

AVIS

RISQUE DE CHOC ELECTRIQUE NE PAS

OUVRIR

This symbol indicates that dangerous voltage constituting a risk of electric shock is

present within this unit

This symbol indicates that there are important operating and maintenance instructions in

the literature accompanying this unit.

SAFETY NOTICE

1. Prior to use, read through this manual

2. Keep the manual in good condition

3. Pay attention to safety warnings

4. Observe all operating requirements

5. Do not use the device near water or wet areas

6. For cleaning, only use a lint-free, dry cloth

7. Install according to the specifications

8. Place away from heat sources or heating appliances

9. Use mains lead provided and avoid damage to cable or connectors

10. Unplug power from mains during stormy weather or if unused for long periods

11. In case of malfunction, water ingress or other damage, consult qualified service personnel

12. Do not place in damp areas or near liquids or moisture. Do not spill liquids on the housing

13. Please pay attention to warning symbols during transit and placement

14. Terminals marked with the symbol are HAZARDOUS LIVE and should only be connected by qualified personnel

15. Ensure that the apparatus is connected to a mains socket with a protective EARTH connection

16. Ensure correct operation of the mains switch

Warning

To prevent the risk of fire or electric shock, do not expose any components to rain or moisture.

If liquids are spilled on the casing, stop using immediately, allow unit to dry out and have checked by qualified personnel before

further use. Avoid impact, extreme pressure or heavy vibration to the case

No user serviceable parts inside not open the case refer all servicing to qualified service personnel. –Do –

Safety

• Check for correct mains voltage and condition of IEC lead before connecting to power outlet

• Use double insulated speaker wire with adequate current rating for 100V speaker connections

• Only use one type of output i.e. - , 70V or 100V do not mix or combine these outputs on a single zone or output –4 16Ω –

• Do not connect - or 70V terminal or 100V/70V speakers to the - 4 16Ω speakers to the 100V 4 16Ω terminal

• Do not allow any foreign objects to enter the case or through the ventilation grilles

Placement

• Keep out of direct sunlight and away from heat sources

• Keep away from damp or dusty environments

• For rack-mounting, use the rack ears provided and ensure adequate support for the weight of the amplifier

• Ensure adequate air-flow and do not cover cooling vents at the front and rear of the amplifier

• Ensure adequate access to controls and connections

Cleaning

• Use a soft cloth with a neutral detergent to clean the casing as required

• Use a vacuum cleaner to clear ventilation grilles of any dust or debris build-ups

• Do not use strong solvents for cleaning the unit

SA180 User Manual

Front panel

Bottom panel

Connections

Connect the bottom panel IEC inlet (24) to the mains using the supplied mains lead

(or an equivalent approved type). Ensure that the mains voltage is correct (230Vac)

and the mains outlet is switched on. Mains and speaker output connections are fed

through the bottom of the cabinet and the wires can be bundled together and fed

through a securing plate (supplied) to deter tampering with the connections.

The SA180 has a total of 4 input channels. INPUT 1 and INPUT 2 are connected by either XLR or 6.3mm jack

to the combo connectors on the front panel (6). It is important to determine which type of input source is

connected and make the appropriate selection on the input type selector switch (5).

If the input is a standard microphone, slide the switch to “MIC”.

If the input is a condenser microphone which requires phantom power, slide the switch to “PHANTOM”.

If the input is a line level input (CD player, MP3 player, electronic keyboard etc.), slide the switch to “LINE”.

AUX 1 input is connected via a mini jack (3.5mm stereo) to accept a line input from smart phone, tablet or

laptop etc. If the input is stereo, the left and right sides will be mixed (summed) to mono. This input shares a

channel with the internal media player (see below) and is controlled by the AUX1/MEDIA volume control (14)

AUX 2 input is connected via a twin RCA connector to accept a line input. If the input is stereo, the left and

right sides will be mixed (summed) to mono. This input is independent of the media player and is controlled

by the AUX 2 volume control (15)

Further mixer-amplifiers or slave amplifiers can be connected from the LINE OUT RCA sockets 6). (1

This output carries the full mix of all channels, including the media player, as fed to the speakers.

SD card slot

Output level meter

BASS EQ control

Input 1 + 2 VOLUME controls

Input 1 + 2 input type selector switches

Input 1 + 2 combo XLR/jack input sockets

AUX 1 mini jack input (3.5mm stereo)

Media player display

USB port

10.

UHF wireless microphone receiver antenna

11.

UHF wireless microphone volume control

12.

TREBLE EQ control

13.

MASTER volume control

14.

AUX 1 / MEDIA volume control

15.

AUX 2 volume control

16.

LINE OUT RCA connectors

17.

POWER on/off switch

18.

AUX 2 RCA input connectors

19.

Mains voltage switch

20.

IEC mains inlet & fuse holder

21.

DC power terminals

22.

COM speaker terminal

23.

4 - speaker terminal 16Ω

24.

100V speaker terminals

Product specificaties

Merk:	Adastra
Categorie:	Omroepinstallatie
Model:	SA180
Soort bediening:	Buttons, Rotary
Kleur van het product:	Wit
Gewicht:	10000 g
Breedte:	335 mm
Diepte:	160 mm
Hoogte:	375 mm
Gewicht verpakking:	11500 g
Breedte verpakking:	405 mm
Diepte verpakking:	230 mm
Hoogte verpakking:	445 mm
Soort:	Vrijstaand PA-geluidssysteem
Bluetooth:	Ja
Connectiviteitstechnologie:	Bedraad en draadloos
Montagewijze:	Muur
Type stroombron:	AC
Geïntegreerde geheugenkaartlezer:	Ja
Compatibele geheugenkaarten:	SD
Microfoon, line-in ingang:	Ja
Audio-ingang (L, R):	1
Gemiddeld vermogen:	180 W
Vermogensverbruik (max):	190 W
Volumeregeling:	Draaiknop
Aantal USB-aansluitingen:	1
Audio (L,R) out:	1
Frequentiebereik:	40 - 15000 Hz
Inclusief monitor:	Nee
Handvat(en):	Nee
MP3 afspelen:	Nee
AUX ingang:	Ja
Maximale afstand:	50 m
Optical disc player:	Nee
Inclusief microfoon:	Ja
Totale harmonische vervorming (THD):	0.1 procent
USB direct afspelen:	Ja
Versterker:	Ingebouwd
XLR in:	Ja
Productontwerp:	Vrijstaand
Regeling van bass-niveau:	Ja
AC-ingangsspanning:	230 V
AC-ingangsfrequentie:	50 Hz
Treble adjustment:	Ja
Ingebouwde tuner:	Ja
Mixersectie:	Ja
Geheugenkaartslot:	Ja
Aantal microfoons inclusief:	1