Adastra SA120 Handleiding

Adastra Mediaspeler SA120

Lees hieronder de 📖 handleiding in het Nederlandse voor Adastra SA120 (7 pagina's) in de categorie Mediaspeler. Deze handleiding was nuttig voor 33 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/7
SA-SERIES
Secure Wall Amplifier with UHF Microphone
Item ref: - 953.1 SA240 50UK
SA120 49- 953.1 UK
SA6 - 953.1 0 47UK
User Manual
Version 1.1
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
SA-series User Manual
Introduction
Thank you for choosing the Adastra SA-series secure wall amplifier as part of your public address system. This amplifier
is designed to offer high quality, dependable service for mobile and installed systems. Please read this manual fully and
follow the instructions to achieve the best results with your new purchase and to avoid damage through misuse.
SAFETY SYMBOL AND MESSAGE CONVENTIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS
RISQUE DE CHOC ELECTRIQUE NE PAS
OUVRIR
This symbol indicates that dangerous voltage constituting a risk of electric shock is
present within this unit
This symbol indicates that there are important operating and maintenance instructions in
the literature accompanying this unit.
SAFETY NOTICE
1. Prior to use, read through this manual
2. Keep the manual in good condition
3. Pay attention to safety warnings
4. Observe all operating requirements
5. Do not use the device near water or wet areas
6. For cleaning, only use a lint-free, dry cloth
7. Install according to the specifications
8. Place away from heat sources or heating appliances
9. Use mains lead provided and avoid damage to cable or connectors
10. Unplug power from mains during stormy weather or if unused for long periods
11. In case of malfunction, water ingress or other damage, consult qualified service personnel
12. Do not place in damp areas or near liquids or moisture. Do not spill liquids on the housing
13. Please pay attention to warning symbols during transit and placement
14. Terminals marked with the symbol are HAZARDOUS LIVE and should only be connected by qualified personnel
15. Ensure that the apparatus is connected to a mains socket with a protective EARTH connection
16. Ensure correct operation of the mains switch
Warning
To prevent the risk of fire or electric shock, do not expose any components to rain or moisture.
If liquids are spilled on the casing, stop using immediately, allow unit to dry out and have checked by qualified personnel before
further use. Avoid impact, extreme pressure or heavy vibration to the case
Do not allow foreign objects into the USB/SD inputs.
No user serviceable parts inside Do not open the case refer all servicing to qualified service personnel. – –
Safety
• Check for correct mains voltage and condition of IEC lead before connecting to power outlet
• Use double insulated speaker wire with adequate current rating for 100V speaker connections
• – Ω – Only use one type of output i.e. 8 or 100V do not mix or combine these outputs on a single zone or output
• Ω Do not connect 8Ω or 4 eakers to the 100V terminal or 100V eakers to the 8 sp sp Ω terminal
• Do not allow any foreign objects to enter the case or through the ventilation grilles
Placement
• Keep out of direct sunlight and away from heat sources
• Keep away from damp or dusty environments
• Ensure adequate support and strength of fixings to the wall for the weight of the amplifier
• Ensure adequate air-flow and do not cover cooling vents around the amplifier
• Ensure adequate access to controls and connections for authorised users
Cleaning
• Use a soft cloth with a neutral detergent to clean the casing as required
• Use a vacuum cleaner to clear ventilation grilles of any dust or debris build-ups
• Do not use strong solvents for cleaning the unit
SA-series User Manual
Front panel
Bottom panel
Connections
Connect the bottom panel IEC inlet ( ) to the mains using the supplied mains 30
lead (or an equivalent approved type). Ensure that the mains voltage is correct
(230Vac) and the mains outlet is switched on.
Mains and speaker output connections are fed through the bottom of the
cabinet and the wires can be bundled together and fed through a security
plate (supplied) to deter tampering with the connections. (see the following page for speaker connection)
If an FM aerial is to be connected , this can also be fed through the security plate. (25)
Each -series amplifier has a total of 5 input channels. INPUT 1 and INPUT 2 are connected by either XLR or SA
6.3mm jack to the combo connectors on the front panel (9). It is important to determine which type of input
source is connected and make the appropriate selection on the input type selector switch (8). If the input is a
low impedance microphone, The central input chan is for the supplied UHF wireless mic. switch to “MIC”. nel
A input can accept a line level signal, connected via L+R RCA connectors (12), or can ternatively be ux 1 al
switched over to the internal media player via the AUX 1/Media button (11). “ ”
A 2 input can also accept a line leveux l signal, connected via L+R RCA connectors or a 3.5mm stereo jack
(which defeats the RCA connectors when connected)
1.
Media player display
2.
Media player controls
3.
SD card slot
4 .
USB pen drive port
5.
Input 1 + 2 Volume control
6.
Input 1 + 2 Treble control
7.
Input 1 + 2 Bass control
8.
Input 1 + 2 Mic/Line level selector
9.
Input 1 + 2 XLR/jack input
10.
Priority & Phantom Power DIP switches
11.
Aux 1 / Media source selector
12.
Aux 1 RCA L+R put in
13.
Aux 2 RCA L+R put in
14.
Aux 2 stereo 3.5mm input (defeats RCA)
15.
UHF microphone antenna BNC connector
16.
UHF microphone Volume control
17.
UHF microphone Treble control
18.
UHF microphone Bass control
19 .
Aux 1/ Media & Aux 2 Volume control
20.
Master Volume control
21.
Aux 1/ Media & Aux 2 Treble control
22.
Aux 1/ Media & Aux 2 Bass control
23.
Power and VU indicator LEDs
24.
Line output XLR
25.
FM radio antenna F-type connector
26 .
8Ω speaker terminal
27 .
COM speaker terminals
28 .
100V speaker terminal
29 .
Power on/off switch
30.
IEC mains inlet & fuse holder

Product specificaties

Merk: Adastra
Categorie: Mediaspeler
Model: SA120

Heb je hulp nodig?

Als je hulp nodig hebt met Adastra SA120 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Mediaspeler Adastra

Adastra

Adastra SA120 Handleiding

4 Juni 2023

Handleiding Mediaspeler

Nieuwste handleidingen voor Mediaspeler

Kenwood

Kenwood DMX823WXS Handleiding

16 December 2024
Philips

Philips DVP3250K Handleiding

12 December 2024
Philips

Philips PET724B Handleiding

12 December 2024
Philips

Philips DVP3747 Handleiding

12 December 2024
Philips

Philips DVP3030A Handleiding

12 December 2024
Crosley

Crosley Everett CF1103 Handleiding

7 December 2024
Thomson

Thomson THA100 Handleiding

4 December 2024
Kenwood

Kenwood DMX7018BT Handleiding

3 December 2024
Olive

Olive O4 Handleiding

25 November 2024
Olive

Olive O6HD Handleiding

25 November 2024