A-NeuVideo ANI-8MFS Handleiding

A-NeuVideo Router ANI-8MFS

Lees hieronder de đź“– handleiding in het Nederlandse voor A-NeuVideo ANI-8MFS (20 pagina's) in de categorie Router. Deze handleiding was nuttig voor 8 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/20
ANI-8MFS
8 INPUT MULTI-FORMAT SCALER SWITCH w/ VOLUME CONTROL
MIRRORED HDMI/VGA OUTPUT
A-NeuVideo.com
Frisco, Texas 75036
INSTRUCTION MANUAL
PACKAGE CONTENTS
Before attempting to use this unit, please check the packaging and make sure the following items are contained in the
shipping carton:
• ANI-8MFS Multiple Inputs to HDMI/VGA Scaler
• 15-pin D-Sub to a 3-RCA Adaptor Cable
• IR Extender Cable
• Remote Control (ANI-122)
• 5V/3A Universal Power Adaptor w/ worldwide adapters
• Rack Mounting ears
SAFETY INFORMATION
1. To ensure the best results from this product, please read this manual and all other documentation before operating your equipment.
Retain all documentation for future reference.
2. Follow all instructions printed on unit chassis for proper operation.
3. To reduce the risk of îšżre, do not spill water or other liquids into or on the unit, or operate the unit while standing in liquid.
4. Make sure power outlets conform to the power requirements listed on the back of the unit. Keep unit protected from rain, water and
excessive moisture.
5. Do not attempt to clean the unit with chemical solvents or aerosol cleaners, as this may damage the unit. Dust with a clean dry cloth.
6. Do not use the unit if the electrical power cord is frayed or broken. The power supply cords should be routed so that they are not
likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords and plugs, convenience
receptacles, and the point where they exit from the appliance.
7. Do not force switched or external connections in any way. They should all connect easily, without needing to be forced.
8. Always operate the unit with the AC ground wire connected to the electrical system ground. Precautions should be taken so that the
means of grounding of a piece of equipment is not defeated.
9. AC voltage must be correct and the same as that printed on the rear of the unit. Damage caused by connection to improper AC
voltage is not covered by any warranty.
10. Turn power o󰀨 and disconnect unit from AC current before making connections.
11. Never hold a power switch in the “ON” position.
12. This unit should be installed in a cool dry place, away from sources of excessive heat, vibration, dust, moisture and cold. Do not use
the unit near stoves, heat registers, radiators, or other heat producing devices.
13. Do not block fan intake or exhaust ports. Do not operate equipment on a surface or in an environment which may impede the normal
ow of air around the unit, such as a bed, rug, carpet, or completely enclosed rack. If the unit is used in an extremely dusty or smoky
environment, the unit should be periodically “blown free” of foreign dust and matter.
14. To reduce the risk of electric shock, do not remove the cover. There are no user serviceable parts inside. Refer all servicing to
qualiîšżed service personnel. There are no user serviceable parts inside.
15. When moving the unit, disconnect input ports îšżrst, then remove the power cable; îšżnally, disconnect the interconnecting cables to
other devices.
16. Do not drive the inputs with a signal level greater than that required to drive equipment to full output.
17. The equipment power cord should be unplugged from the outlet when left unused for a long period of time.
18. Save the carton and packing material even if the equipment has arrived in good condition. Should you ever need to ship the unit,
use only the original factory packing.
19. Service Information Equipment should be serviced by qualiîšżed service personnel when:
A. The power supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the equipment.
C. The equipment has been exposed to rain.
D. The equipment does not appear to operate normally, or exhibits a marked change in performance.
E. The equipment has been dropped, or the enclosure damaged.
THIS SAFETY INFORMATION IS OF A GENERAL NATURE AND MAY BE SUPERSEDED BY INSTRUCTIONS CONTAINED WITHIN THIS MANUAL.
TABLE OF CONTENTS
A NEUVIDEO
1
CONTENTS
INTRODUCTION........................................................................1
FEATURES & SPECIFICATIONS................................................2
FRONT PANEL ...........................................................................3
BACK PANEL .............................................................................4
REMOTE CONTROL ..................................................................5
OSD MENU ..................................................................................7
RS-232 & TELNET COMMANDS ................................................8
RS-232 PIN ASSIGNMENT ........................................................12
TELNET CONTROL ..................................................................13
WEBGUI ......................................................................................14
INPUT & OUTPUT RESOLUTIONS .........................................15
CONNECTION DIAGRAM .......................................................16
INTRODUCTION
The ANI-8MFS is a multi input scaler has Composite Video,
Component Video, PC (VGA) and HDMI inputs and can switch and
scale the signal to HDMI or VGA with audio outputs. It supports
HDMI output resolutions up to 1080p/WUXGA and Analog Digital
Conversion (ADC) and Digital Analog Conversion (DAC) allowing a
wide range of AV signals to be displayed on a HDMI or VGA display.
Further, the On-screen Display (OSD), IR remote, RS-232, IP and
on-panel controls make this product very versatile. This product
has a 3 year warranty.
SYSTEM REQUIREMENTS
Source equipment such as Blu-ray/DVD players or PC/Laptop and
output to displays, AV Receivers or active speakers.
APPLICATIONS
• Analog and digital source integration
• Upscaling standard denition video for high-denition
displays
• Conference centers
• Lecture halls
• Schools and universities
SAFETY PRECAUTIONS
Please read all instructions before attempting to unpack, install or
operate this equipment and before connecting the power supply.
Please keep the following in mind as you unpack and install this
equipment:
• Always follow basic safety precautions to reduce the risk of re,
electrical shock and injury to persons.
• To prevent re or shock hazard, do not expose the unit to rain,
moisture or install this product near water.
• Never spill liquid of any kind on or into this product.
• Never push an object of any kind into this product through any
openings or empty slots in the unit, as you may damage parts
inside the unit.
• Do not attach the power supply cabling to building surfaces.
• Use only the supplied power supply unit (PSU). Do not use the
PSU if it is damaged.
• Do not allow anything to rest on the power cabling or allow any
weight to be placed upon it or any person walk on it.
• To protect the unit from overheating, do not block any vents or
openings in the unit housing that provide ventilation and allow for
su󰀩cient space for air to circulate around the unit.
DISCLAIMERS
The information in this manual has been carefully checked and
is believed to be accurate. We assume no responsibility for any
infringements of patents or other rights of third parties which may
result from its use.
We assume no responsibility for any inaccuracies that may be
contained in this document. We make no commitment to update or
to keep current the information contained in this document.
We reserve the right to make improvements to this document and/
or product at any time and without notice.
COPYRIGHT NOTICE
No part of this document may be reproduced, transmitted,
transcribed, stored in a retrieval system, or any of its part translated
into any language or computer îšżle, in any form or by any means
— electronic, mechanical, magnetic, optical, chemical, manual, or
otherwise — without the express written permission and consent.
© Copyright 2019. All Rights Reserved.
Version 1.4 SEPT 2019
VS3 22/06/16
TRADEMARK ACKNOWLEDGMENTS
All products or service names mentioned in this document may be
trademarks of the companies with which they are associated.


Product specificaties

Merk: A-NeuVideo
Categorie: Router
Model: ANI-8MFS

Heb je hulp nodig?

Als je hulp nodig hebt met A-NeuVideo ANI-8MFS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Router A-NeuVideo

Handleiding Router

Nieuwste handleidingen voor Router