Zempire Hubble Handleiding

Zempire Tent Hubble

Lees hieronder de 📖 handleiding in het Nederlandse voor Zempire Hubble (3 pagina's) in de categorie Tent. Deze handleiding was nuttig voor 114 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
PITCHING INSTRUCTIONS - HUBBLEairflowseries
6. Peg out the four corners firmly
ensuring that the floor sits at flat
as possible
8. Pull the fly over the tent and
connect the SR buckles sewn
onto the fin at the rear of the tent.
Attach the hooks onto the loops
sewn around the pole sleeves.
9. Peg out all the guy ropes. Try to
have guy ropes at a 45o angle to the
ground. Also peg out the lower draft
vents on each side of the tent.
1. Clear your site making sure there are no
sharp objects where you are going to
pitch your tent. Try to get a site that is
as flat as possible.
3. Thread the RED poles through the
pole sleeves that run diagonally
across the centre of the tent. Insert the
ends of the poles into the pins located
below each pole sleeve. Follow the
seam line down from the pole sleeve
to find the correct pin. Clip the C Clips
between the pole sleeve and the pin
onto the poles.
2. Assemble the 5 pole sections.
Ensure that the poles do not snap
together. It is important that the poles
are fully inserted into the ferrules.
4. Thread the BLUE poles through the
pole sleeves on either side of the
centre dome you have just created.
Insert the pole ends into the pins at
the base and clip the C Clips to the
frame.
5. Thread the YELLOW pole through
the pole sleeve that run across the
rear of the tent. Insert the ends of the
poles into the pins located at the rear
corners of the tent. Clip the C Clips
between the pole sleeve and the pin
onto the pole.
7. Peg out all the peg points
around the tent. Firmly peg out
the rear anchor ORANGE
webbings attached to the
large fin atthe rear of the tent.
These webbing anchors should
sit at a 45o angle.
Copyright 2014
pitching instructions
HUBBLE
Freedom Zempire is proud to be a 100%
New Zealand owned and operated
business.
For more information about this and
other great products we offer please
visit our website.
WWW.FREEDOMCAMPING.COM
PITCHING INSTRUCTIONS - HUBBLEairflowseries
10. For extra warmth and
privacy you may decide to
attach the inner tent inside the
tent. Lay out the inner inside the
tent with the door facing the
front and the floor facing
downwards. Attach the corner
male buckles to the female
buckles sewn into the inside rear
corners of the tent. Connect the
toggles through the
corresponding rings sewn on the
tent working your way front the
rear to the front of the inner. Peg
down the front of the inner and
airflowseries
1. Ensure guy ropes are pegged out at all times during use
2. Never pack your tent away wet. If you must take your tent down when
wet, ensure that you dry you tent completely as soon as possible to
prevent mildew forming.
3. If mildew does form on your tent wash off pours with warm water and a
soft brush to prevent further growth. Do not use detergents.
4. Do not use an open flame inside your tent. The fabric has been treated
with a fire retardant but is in no way fire proof
5. Clean all pegs and poles before storing
.


Product specificaties

Merk: Zempire
Categorie: Tent
Model: Hubble

Heb je hulp nodig?

Als je hulp nodig hebt met Zempire Hubble stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Tent Zempire

Handleiding Tent

Nieuwste handleidingen voor Tent