Zanussi ta 850 Handleiding

Zanussi Wasmachine ta 850

Lees hieronder de 📖 handleiding in het Nederlandse voor Zanussi ta 850 (8 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 40 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

1. TECHNICAL CHARACTERISTICS

2. WARNINGS

Keep this user’s manual with your washing machine. If you sell your washing machine or give it away, make sure that it is accom-

panied by its user’s manual. The new user can then be informed of how the washing machine operates and read relevant warnings.

These warnings have been written for your safety and for the safety of others. Please read these comments carefully before ins-

talling and using your washing machine. Thank you for your attention.

• When you receive your washing machine, unpack it or have it

unpacked immediately. Check its general appearance. Make

any reserves in writing on the delivery form and keep a copy.

• Your washing machine was designed for use by adults. Make

sure that children do not touch it or use it as a toy.

• Do not modify or attempt to modify the characteristics of this

washing machine. This could be dangerous for you.

• Your washing machine is intended for normal domestic use. Do

not use it for commercial or industrial purposes or for any

purpose other than that for which it was designed : to wash, to

rinse and to spin.

• Unplug the power suplly plug and close the water supply tap

every time after using your washing machine.

• Only wash articles that can resist machine washing. Refer to

the instructions on the label for each article.

• Do not wash underwear with bones, or any material without

hems, or torn materials in your washing machine.

• Remember to remove all coins, safety pins, boraches, screws,

etc., before each wash. They can cause serious damage if they

are left in your washing.

• Do not put articles in your washing machine if you have used a

solvent, alcohol, trichloroethylene, etc., to remove stains from

them. If you must use these stain removers, wait until the pro-

duct has evaporated before putting the articles in the drum.

• Collect all small articles such as socks, belts, etc., in a small

cloth bag or pillow case.

• Use the quantity of detergent indicated in the «proportioning of

detergents» section.

• Always unplug the washing machine before cleaning it and

doing any maintenance.

• This washing machine is heavy. Take care when moving it.

• You must remove the packing on the washing machine before

use. Failure to remove all transport protection devices can

cause damage to the washing machine or nearby furniture.

The washing machine must be unplugged while packing is

being removed.

• Do not allow any one other than a qualified plumber to make

the hydraulic connections necessary to install your washing

machine.

• The washing machine must be plugged in to a power outlet with

a conform earth.

• Call a qualified electrician if the electrical installation in your

residence is such that you have to modify it before you can con-

nect your washing machine.

• Please read the instructions in the "electrical connections"

chapter carefully before connecting your washing machine.

• After installing your washing machine, make sure that it is not

standing on its electrical power supply cable.

• When your machine is installed on a carpeted floor, make sure

that the carpet does not close off the ventilation openings near

the bottom of the machine.

• The power supply cable may be only replaced by the After

Sales Service.

• Your manufacturer cannot be held responsible for any damage

resulting from a nonconform installation.

• The symbol on the product or on its packaging indicates

that this product may not be treated as household waste. Ins-

tead it shall be handed over to the applicable collection point for

the recycling of electrical and electronic equipment. By ensu-

ring this product is disposed of correctly, you will help prevent

potential negative consequences for the environment and

human health, which could otherwise be caused by inappro-

priate waste handling of this product. For more detailed infor-

mation about recycling of this product, please contact your local

city office, your household waste disposal service or the shop

where you purchased the product.

INSTRUCTIONS BOOK

WASHING

MACHINES

TA 1050

TA 850

DIMENSIONS Height

Width

Depth

850 mm

400 mm

600 mm

VOLTAGE / FREQUENCY

TOTAL POWER

230 V / 50 Hz

2300 W

WATER PRESSURE

Connection to the water network

Minimum

Maximum

0,05 MPa (0,5 bar)

0,8 MPa (8 bars)

Type 20x27

Spin speed TA 1050

TA 850

1000 rpm

850 rpm

This washing machine complies with CEE directive 89-336 about the limitation of radioelectric disturbances and

directive CEE 73-23 for electrical safety.

146 8714 01 - 09/05

3. INSTALLATION

3.1. Unpacking

Packing used to protect internal parts of the washing

machine during transport must be removed before the

washing machine is put into service for the first time.

Remove all packing from the

washing machine. Tilt the washing

machine sideways and then remove

the packing under the motor, and

straighten the washing machine.

Tilt the washing machine back-

wards, rotate it by a quarter of a turn

on one of its corner to remove the

transport base.

Open the washing machine lid and

remove the immobilization packing

and plastic films.

Close the lid.

Use a 10 mm spanner to remove the

two screws and spacers at the back.

You can now see the openings that

must be closed with the caches in the

pack attached to the washing machi-

ne; do not forget to fold down the

central capsule.

Make sure that you have removed all

these parts from your washing ma-

chine and keep them so that you can

use them again if you need them for

future transport.

If you want to keep your washing ma-

chine aligned with the adjacent furni-

ture, you can cut the pipe support

strip at the back of your washing ma-

chine. Leave the two side closers in

place.

3.2. Position

Put the washing machine on a flat hard floor in a well venti-

lated room. Make sure that your washing machine does not

touch the wall or any other furniture in the room.

3.3. Moving your washing machine

If you want to move your washing

machine, lift it onto its rollers by pul-

ling the lever at the bottom of the

washing machine all the way to the

left. When you have put your

washing machine into the required

location, put the lever back into its

initial position.

3.4. Leveling

Precise leveling will prevent vibrations, noise and move-

ments of the washing machine during operation.

Make the washing machine level by

adjusting the leveling screw that is

too short.

Unscrew the stand and locking col-

lar assembly (lift the washing machi-

ne if necessary).

When the washing machine is sta-

ble, maintain the stand on the

ground and turn the locking collar as

far as posible.

3.5. Water inlet

Screw the supply ppe connector

onto the water inlet tap (20x27 mm),

remembering to use the washer pro-

vided with the washing machine.

Open the water inlet tap.

You cannot prolong the water inlet

pipe. If it is too short, buy a longer

pipe provided for this purpose.

3.6. Drain

The drain siphon must be placed in-

side a drain pipe (or in a washbasin)

at a height of between 70 and 100

cm. Make sure that it cannot fall.

•Important: the drain pipe must

never be prolonged. If it is too short,

call a professional.

3.7. Electrical connection

You can only connect this washing machine to 230 V single

phase power supply.

Check rating of the fuse line: 10 A at 230V.

The washing machine must not be connected through an

extension cable or a power bar.

Check that the earthing connection is conform with the regu-

lations in force.

4. USING

4.1. The control panel

1 - «On/Off» pushbutton 4 - Spinning speed variator

2 - «Half load» pushbutton 5 - Programme selector

3 - «Rinse hold» pushbutton 6 - Temperature selector

Presented model : TA 1050

4.2. How to do a wash ?

Before the first wash in your washing machine, we recom-

mend that you should do a preliminary wash at 90°C with de-

tergent but without any washing to clean the tub.

4.2.1. Loading the washing

• Lift the machine cover.

• Open the drum by pressing on the locking button A; the

two flaps automatically separate.

• Insert the washing, close the drum and the cover of your

washing machine.

Warning : before you close the

cover of your washing machine,

make sure that the drum door is

properly closed:

•the two flaps latched together,

•the locking button A extended.

4.2.2. Proportioning of detergents

Your washing machine was designed to reduce water and

detergent consumption, therefore reduce the doses recom-

mended by detergent manufacturers.

Pour the powder detergent dose into the wash compartment

and into the prewash compartment if you chose the

«prewash» option. Pour in the softener into the compart-

ment and Javel water into the compartment if you wish.

If you are using a different type of detergent, refer to the «de-

tergents and additives» section in the washing guide.

4.2.3. Choice of the spinning speed

Choose the spinning speed which corresponds to the nature

of your laundry and to the degree of humidity wished at the

end of the wash.

The knob indicates the possible spinnings on the coton pro-

grammes. These spinnings are reduced for the synthetics,

wool and delicate cycles.

4.2.4. Choice of the temperature

Choose the wash temperature applicable for the selected

programme (using the information given in the programmes

table) and comply with the temperature shown on the care

label for each article to be washed (see the washing guide).

4.2.5. Choice of the pushbuttons

Press the chosen pushbuttons.

4.2.5.1. «Half load» pushbutton

This pushbutton allows to wash small quantity of linen not

much soiled (max. 2,5 kg) on cotton programmes only by re-

ducing the water quantity during rinsings.

4.2.5.2. «Rinse hold» pushbutton

If you use this pushbutton, the tub remains full of water at the

end of the last rinse to prevent the washing from becoming

creased if it is not taken out of the drum as soon as the

washing machine is stopped.

4.2.6. Choice of the programme

Select the programme depending on the nature and the de-

gree of soil of the laundry. Turn the programme selector

clockwise to select the chosen programme.

4.2.7. Starting the programme

After you choose the washing programme, press the On/Off

« » pushbutton to start the cycle.

123456

Product specificaties

Merk:	Zanussi
Categorie:	Wasmachine
Model:	ta 850

Heb je hulp nodig?

Als je hulp nodig hebt met Zanussi ta 850 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Wasmachine Zanussi

Zanussi ZWF 386 Handleiding

15 November 2024

Zanussi FA 821 Handleiding

15 November 2024

Zanussi FA 868 Handleiding

15 November 2024

Zanussi ZWF 71243 W Handleiding

15 November 2024

Zanussi ZNI814PDWV Handleiding

1 Augustus 2023

Zanussi ZW84PCBI Handleiding

2 Juli 2023

Zanussi ZW74PDBI Handleiding

1 Juli 2023

Zanussi FCS 725 Handleiding

17 Juni 2023

Zanussi ZWFN146ATW Handleiding

11 Juni 2023

Zanussi WDJ 1507 E Handleiding

8 Juni 2023

Handleiding Wasmachine

Nieuwste handleidingen voor Wasmachine

Asko w 6362lt Handleiding

5 December 2024

Svan SL8201DD Handleiding

21 December 2024

Svan SLI8200D Handleiding

21 December 2024

Svan SL9401AIDB Handleiding

21 December 2024

Svan SL7201DD Handleiding

21 December 2024

Electrolux EWD8462OBI Handleiding

20 December 2024

Svan SL6001DD Handleiding

20 December 2024

Whirlpool FFWDB 964489 WV EE Handleiding

20 December 2024

Asko w 6461 rf Handleiding

5 December 2024

Asko W2084C.W-2 Handleiding

5 December 2024